Wet Location Rated LED Exit Sign
User Manual
XS-RWL and XSC-RWL
Model XS-RWL XSC-RWL
IP Rating IP65
Operating Temperature -4°–104° F (-20°–40° C)
Specications
Mounting Plate Dimensions
XSC-RWL
4400 Earth City Expy, St. Louis, MO 63045 866-590-3533 superbrightleds.com
¹
¹Limited 2-year warranty on battery.
Rev Date: V1 12/01/2022
Important: Read all instructions prior to installation. SAVE THESE INSTRUCTIONS.
Important Safeguards
Read and follow all safety instructions. When using electrical
equipment, basic safety precautions should always be followed
including the following:
• This product should be installed and serviced by a certied
electrician in accordance with applicable national, state, and
local building and electrical codes.
• Light must be maintained, tested, and serviced in
accordance with all applicable National Fire Protection
Association (NFPA) and local codes.
• To reduce the risk of electric shock, ensure that the main
power source and circuit breakers are switched o before
performing any installation or wiring procedures.
• Ensure xture is securely mounted and mount will support
weight of the xture. Failure to properly support xture may
result in damage or injury, for which the manufacturer does
not assume responsibility.
• Equipment should be mounted in locations and at heights
where it will not be subjected to tampering by unauthorized
personnel.
• May be used outdoors if within operating temperature range.
• Do not mount near gas or electric heaters or any other
radiant heat sources.
• Use caution when handling or servicing the battery pack.
• For conduit wiring installation, use exible conduit only
• The use of accessory equipment not recommended by the
manufacturer may cause an unsafe condition.
• Do not use this equipment for anything other than its
intended use and do not use with accessories not included
with this equipment.
• Do not repair or modify arbitrarily. Do not replace any part of
the light including LED board and transformer/driver without
consulting the manufacturer or authorized distributors.
• Battery in this unit may not be fully charged when
purchased. After electricity is connected to the unit, let the
battery charge for at least 24 hours before testing.
Wiring Diagram
White
Red
Black
Neutral
Line (277 VAC)
Line (120 VAC)
3.03in
76.96mm
.18in
4.57mm
.71in
18.03mm
.13in
3.30mm
0.60in
15.24mm
2.43in
61.72mm
1.25in
31.75mm
2.49in
63.25mm
2.73in
69.34mm
3.22in
81.79mm
2.76in
70.10mm
