Salter Brecknell MS-20 User manual

A copy of the original signed declaration for this instrument is available

from the below UK address:

Electromagnetic Compatibility Statement for North America

This equipment has been tested and found to comply with the limits for a Class B

digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to

provide reasonable protection against harmful interference when the equipment is

operated in a residential installation. This equipment generates, uses and can

radiate radio frequency energy and if not installed and used in accordance with the

instruction manual, may cause harmful interference to radio communications.

However, there is no guarantee that interference will not occur in a particular

installation. If this equipment does cause harmful interference to radio or television

reception which can be determined by turning the equipment off and on, the user is

encouraged to try to correct the interference by one of the following measures:

Re-orient or relocate the receiving antenna.

Increase the separation between the equipment and the receiver.

Connect the equipment to an outlet different from that to which the receiver is

connected.

Consult the dealer or an experienced radio / TVtechnician for help.

USER'S

MANUAL

Model MS-20

IN-0787 3014H

Declaration of Conformity

Manufacturer Salter Brecknell

Type MS-20

Corresponds to the requirements of the following EC directives

Electro Magnetic Compatibility Directive EMC 89/336/EEC

Low Voltage Directive LVD 73/23/EEC

The application harmonised standards are: EN60950,

EN50081-1

EN50082-1

Salter Brecknell Weighing

UK & Europe

PO box 9533, Smethwick,

West Midlands, B66 2TE

United Kingdom

Tel: +44 (0) 870 444 6132

Fax: +44 (0) 870 010 2241

Email: sales @salterbrecknell.co.uk

Salter Brecknell Weighing

Products USA

1000 Armstrong Drive,

Fairmont, MN56031

TollFree:800-637-0529

Phone: 507-238-8702

Fax:507-238-8271

Email:sales@salterbrecknell.com

www.salterbrecknell.com

SETTING UP YOUR MS-20 SCALE

To insure that your scale operates correctly, position the scale on a level sturdy

worktop.

The display head can be either attached to the wall or positioned in front of the

scale.

Pull down feet on back of display head enable the operator to change the

viewing angle of the display head.

Any excess cable can be stored in the cavity on the underside of the display

head.

POWER SUPPLY

The MS-20 uses 9V alkaline battery or

9V 100mA AC adapter.

CAUTION: alwaysconnect the AC

adapter to the MS-20 before

connecting to the mains power supply.

Disconnect from the mains power

supply before disconnecting the

adapter from the MS-20

KEY FUNCTION

ON/TARE (1) Press once to switch scale on.

OFF - (2) Press while scale is switched on to

re-zero the scale.

(3) Press and hold this key for 2 seconds

to switch scale off. Scale will auto shut-off

if not used after 120 seconds

UNIT - Selects between kg mode and lb mode.

HOLD - When pressed the displayed weight will be

held on the display once the weight becomes

stable.

By repressing the Hold key again will release

the held display and allow the scale to return

back to normal weighing mode.



ERROR MESSAGES

1. Low Battery

2. High zero counts

3. Low zero count

4. Overload

SPECIFICATIONS

Model # MS-20

MaximumCapacity44 lb / 20 kg

Readability½ oz/ 10 g

Weight unitslb / kg

Power supply 9V alkaline battery or 9V 100mA AC adapter

Dimensions 20” x 12” x 2 ½” / 505mm x 300mm x 65 mm

Display 1.0” LCD display with 4 active digits

Tray Plastic top cover

Operating Temperature 5°C ~ 35°C

Function keys ON/TARE/OFF, UNIT, HOLD

CALIBRATION PROCEDURE

1) With the scale switched off, press and hold the “ON/OFF/TARE key, without

releasing press the kg/lb key three times and then release.

2) Display will show zero (4000~12000).

3) Press the “UNITS” key, switch to LB mode or KG mode

4) Press “ON/OFF/TARE” key once.

5) Display will show “CAL” and then “0”.

6) Load 20kg weight onto the scale, or load 40 lb in case of switched to LB mode

at step 3.

7) Display will show span count (8000~16000)for KGmode or(7260~14520) for

LB mode.

8) Press “ON/OFF/TARE” key again.

9) Display will show “CAL” and then “20.00 kg” for KG mode or “40:00 lb” for LB mode.

10)Remove the weight from the scale and the calibration isfinished.

Table of contents

Other Salter Brecknell Scale manuals

Salter Brecknell

Salter Brecknell BS150 Troubleshooting guide

Salter Brecknell

Salter Brecknell B 130 User manual

Salter Brecknell

Salter Brecknell B220 User manual

Salter Brecknell

Salter Brecknell 405 User manual

Salter Brecknell

Salter Brecknell C3235 User manual

Salter Brecknell

Salter Brecknell TME0221 Installation instructions

Salter Brecknell

Salter Brecknell Pegasus Floor Scale User manual

Salter Brecknell

Salter Brecknell SP series User manual

Salter Brecknell

Salter Brecknell SBI-100 User manual

Salter Brecknell

Salter Brecknell 402 User manual

Salter Brecknell

Salter Brecknell PS250 User manual

Salter Brecknell

Salter Brecknell B220 User manual

Salter Brecknell

Salter Brecknell B220 User manual

Salter Brecknell

Salter Brecknell EG1500 Installation manual

Salter Brecknell

Salter Brecknell 405 User manual

Salter Brecknell

Salter Brecknell C3255 User manual

Salter Brecknell

Salter Brecknell S-100 User manual

Salter Brecknell

Salter Brecknell GP100 User manual

Salter Brecknell

Salter Brecknell MB-2610 Troubleshooting guide

Salter Brecknell

Salter Brecknell S122 User manual

Salter Brecknell

Salter Brecknell PR-3000 Series User manual

Salter Brecknell

Salter Brecknell B 120 User manual

Salter Brecknell

Salter Brecknell LPS-400 User manual

Salter Brecknell

Salter Brecknell CS User manual

Popular Scale manuals by other brands

AWS

AWS ZEO-50 user manual

Gima

Gima Glass Body Fat Analyzer Use and maintenance book

Seca

Seca 374 user manual

TEC

TEC TEC SL59 SERIES owner's manual

Axis

Axis B/E Series user manual

Alecto

Alecto ACW-40 user manual

Rice Lake

Rice Lake MSI-4260 IS Technical manual

IKA

IKA RCT basic safety control operating instructions

ADE

ADE M20011 operating manual

Duronic

Duronic KS3000 manual

Digi

Digi SM-720 Service manual

Cardinal

Cardinal CS Series Operation manual

Korona

Korona Kastella Instructions for use

A&D

A&D FC-50Ki instruction manual

BDA

BDA CAMARGUE installation guide

Tanita

Tanita HD-357 Instructions for use

Leifheit

Leifheit 03173 quick start guide

Lumme

Lumme LU-1340 user manual