Rukket Spor Net Installation guide
6. Fully extend the berglass top
half of the left pole. The arms
should be slanted in the same
direction, as shown above.
123
456
1. Unfold the frame’s middle
cross beam. The frame will lay at
on a rubber base.
2. Unfold the legs, making sure
that the locking button is fully
extended.
3. Bring up the left arm. Lock it
into place using the base pin.
Make sure the pin is fully inserted
into the base.
4. On the left arm, fully extended
the berglass top half of the arm.
Lock into place with the cotter
pin.
5. Bring up the right arm, but do
not extend it all the way up. Rest
the base pin on the groove that is
half way up the bottom base
plate.
Check out our video instructions at:
/RukketSports
789
10
7. Lay the net in front of the
frame, logos facing downward. 8. Slide the red sleeves
completely over the berglass poles.
Use ties to attach the bases of the
red sleeves through the holes on the
bases of the berglass arms.
9. Pull the left arm fully upright
and make sure that the base pin
is fully inserted into the slot.
10. Attach the velcro straps to
the ends of the folding legs.
12. Ready to play!
Check out our video instructions at:
/RukketSports
11
11. Attach the wings using the
provided bungies. The top and side
edges of the wings are red, and the
bottom edge is black. The edge of
the wings should be attached a few
squares inside the main net’s edge.
12. The bag at the end of the
wing can be used as a
weigh-down, or it can be staked
by small loops at the corner.
12
OR
Ready to play!
Other Rukket Accessories manuals
