Rosen DA-7169 Quick start guide

Table of Contents

1 Before You Begin ............................................ 2

2 Installing the DA-7169 Monitor ....................... 4

Parts Overview................................................. 8

4 Operating the DA-7169 Monitor ................... 11

5 Specifications ................................................ 16

6 Appendix ........................................................ 17

Page 2

Welcome to the In-Dash DA-7169 Operating Guide. Before

ou begin, read the following warnings and notes carefull .

Warning!

To avoid serious harm or injur to ou, others, the vehicle,

or the remote control unit, follow the instructions below.

To avoid short-circuiting the electrical s stem:

•When replacing a blown fuse, disconnect all power

supplies and power off the unit. Be sure to use the correct

replacement fuse.

•If the unit shows signs of overheating or malfunction,

power off the unit and consult our dealer immediatel .

Do not open the unit; there are no serviceable parts

inside.

To avoid damaging the LCD panel:

•Do not drop the LCD displa panel or subject it to direct

impact.

•If the LCD panel breaks, avoid contact with an broken

glass or leaking fluids. If ou come into contact with these

materials, flush and clean the affected areas with water.

Seek medical attention immediatel .

This unit uses high-qualit electronic components and is

manufactured under a stringent qualit -control s stem.

Properl maintain the remote control unit to ensure optimal

performance:

•Replace the batteries regularl . To avoid damage to new

batteries, do not use new and used batteries at the same

time. Batter life is six months.

•Use a soft, damp cloth (a lens cloth) to wipe dirt and

fingerprints off the screen. Chemical solvents, cleaning

agents, or corrosive detergents can cause irreparable

damage.

1 Before You Begin

Page 3

•Do not drop metal or foreign objects between the displa

screen and enclosure. Doing so ma impede the motor-

ized tra and cause an electrical short.

Important Notes

•When using the unit with a radio/TV tuner (model DA-2301),

reception qualit will var with geographical location and

climatic conditions.

•For safet , this unit can onl be activated when the

vehicles hand break is engaged. See our dealer for

details.

•Do not install the screen where it ma distract the driver.

•Avoid installing the displa screen in direct sunlight or

near hot air vents. Operating temperature for the displa

screen is 0oC to 60oC. If the internal temperature of the

vehicle is extremel high, cool down the inside of the

vehicle before operating the unit.

•Install the unit in a dr location, awa from condensation.

•To avoid a fire hazard, use the correct fasteners and

connecting cables during installation.

•The unit contains high voltages. To avoid electrical shock,

do not open the unit; there are no user serviceable parts

inside.

•See our authorized dealer if unsure how to proceed.

Before installing this display system,

ensure you are in compliance with

local traffic rules and regulations.

1 Before You Begin

Page 4

Precautions

1 This unit should be installed b a qualified service techni-

cian.

2 This product is designed to operate with a 12-Volt,

negative ground batter .

3 Disconnect the ground wire from the batter terminal

before connecting this unit to the electrical s stem.

4 Other products or accessories ma have wires that are

color-coded similarl to those for this unit. Refer to the

electrical diagrams of an other products before installa-

tion of the unit to avoid making wrong connections.

5 To avoid short-circuiting the electrical s stem, use proper

insulation and fastening materials.

6 Do not connect the units ellow wire directl to the

batter terminal. Connect the units red wire to the ACC of

the ignition switch. Failure to connect the red and ellow

wires properl ma drain the vehicles batter .

7 To avoid damaging the unit, use onl the accessories

supplied with the unit.

8 Do not install this product at an angle exceeding ±30°.

9 Do not install this product in a position that ma cause

injur to passenger(s) during an accident.

2 Installing the DA-7169 Monitor

Page 5

Electrical Connections

Color Code Function

Black Ground

Red ACC

Yellow +12 V

Blue +12 V Out (Max 1 Amp)

2 Installing the DA-7169 Monitor

Page 6

Signal Connections

Color Code Function

Gre /Yellow Video 1 In

Black /Yellow Video 2 In

Black/Black Video Out

Orange/Brown Rear View Camera/Night Switch

Signal

Signal & Control Signal & Control

2 Installing the DA-7169 Monitor

Page 7

Typical Wiring Diagram

The following is a t pical wiring diagram for an In-Dash DA-

7169 connected to model DVA-310x and a radio receiver with

a 40-Watt, 4-channel power amplifier.

2 Installing the DA-7169 Monitor

Page 8

Parts Overview

Front Panel

1 Mute (MUTE)

2 Remote sensor

3 Signal Source select (SRCE and CH / AV1 / AV2)

4 Pla er select and Pla /Pause (DISC & PLAY /

PAUSE)

5 AM/FM Radio select (BAND & AM/FM; when

interfaced with DA-2301)

6 OPEN / CLOSE

7 Disc select +/- (DISC)

8 Audio select (AUDIO)

9 Repeat function (REP)

7/8/9 Memor location (1 / 2 / 3 / 4 / 5 / 6)

10 Forward (>)

11 Up volume control

12 Backward (<)

13 Function mode (SEL)

14 Down volume control

15 Degree of tilt (ANGLE)

16 Displa mode (WIDE)

Page 9

Remote Control Unit

Frequently Used Buttons

CHANNEL SELECT: Selects TV channels, disc title, or

desired settings on the MENU screen.

MODE: Selects the input video source. i.e. TV / AV1 / AV2.

MENU: Displa s menu screen of functions available.

POWER: Open (ON) or close (OFF) the monitor enclosure.

VIEWING ANGLE & DISPLAY MODE:

Press once to activate angle adjustment function. While in

this mode, press por q to set the tilt angle of the screen.

Press and hold to activate displa mode functions: ZOOM /

CINEMA / NORMAL / FULL.

Parts Overview

Other manuals for DA-7169

This manual suits for next models

Table of contents

Rosen DA-7169 Quick start guide

Popular Car Video System manuals by other brands