Ritelite K10 360 User manual
EN | DE | ES | FR
www.riteliteportablelighting.co.uk
Rechargeable LED Worklight
Quick Start Guide
2
Quick Start Guide 4 EN
Schnellstartanleitung 10 DE
Guía de Inicio Rápido 16 ES
3
Guide de mise en marche rapide 22 FR
4
EN K10 LED
Rechargeable LED Worklight
QUICK START GUIDE
SAFETY INFORMATION
• Only recharge in a well ventilated area.
• Do not stare directly into the light head or LEDs when switched on.
• Do not submerse the unit in water/liquids.
• Do not switch the light head on in close proximity to flammable materials. Ensure that
the front of the light head is at least 0.5m away from the nearest object or surface when
switched on. Failure to do so could result in heat build up and fire.
IMPORTANT
• Recharge battery immediately aer use. Do not leave in a discharged state. Failure to do
this will significantly reduce the lifespan and performance of the battery.
• Only use approved batteries and chargers. Use of other batteries and chargers may
cause damage and/or reduce the performance of equipment.
OPERATING MODES
Torch Worklight
5
EN
OPERATION
1x = Switch on (3 light heads on)
2x = Light head 1 only
3x = Light head 2 only
4x = Light head 3 only
5x = 3 Light heads on
Switch off (Hold for 2 seconds)
0x = White
1x = White flashing
2x = SOS flashing
3x = White
Increase Brightness
0x = 100%
1x = 110%
2x = 120%
Increases in 10% increments per press, up to 150% max
Decrease Brightness
0x = 100%
1x = 90%
2x = 80%
Decreases in 10% increments per press, down to 10% min
FOCUSSING
Spot light Flood light
6
EN BATTERY STATUS
CHARGING STATUS
SEALED LEAD ACID (SLA) K10
SEALED LEAD ACID (SLA) K10
WITH VEPAC
LITHIUM K10 WITH VEPAC
CHARGING
~100 % – 75 %: LED = Green
~75 % – 50 %: LED = Amber
~50 % – 25 %: LED = Red
~25 % – 0 %: LED = Flashing Red
~0 % - 80 %: LED = Red
~80 % - 100 %: LED = Amber
~100 %: LED = Green
~0 % - 80 %: LED = Red
~80 % - 100 %: LED = Flashing Red
~100 %: LED = Green
~0 % - 80 %: LED = Red
~80 % - 100 %: LED = Amber
~100 %: LED = Green
Charge Standby: LED = Flashing Green
Vehicle Charger (Optional)
For VEPAC equipped units
Input 12 – 30V DC
A
B
C
Mains Charger* (Optional)
For units without VEPAC
Input 100 – 240V AC
For SLA K10 units without an in-built VEPAC charger.
If the unit does not have an LED at the position
shown above it will need to be charged with a mains
charger (C). Charging status colours are shown on the
external charger.
* Only for SLA battery equipped units
For SLA K10 units with an in-built VEPAC charger. If
the unit has an LED at the position shown above the
in-built charger can be powered by either a mains
adaptor (B) or a vehicle charger (A). Charging status
colours are shown on the K10 at the position shown
above.
For Lithium K10 units which all have an in-built VEPAC
charger as standard. The in-built charger can be
powered by either a mains adaptor (B) or a vehicle
charger (A). Charging status colours are shown on the
K10 at the position shown above.
Mains Adaptor (Optional)
For VEPAC equipped units
Input 100 – 240V AC
LED
VEPAC LED
7
EN
INTEGRATED TRIPOD
45º 45º 45º
1.8m
The contents of this manual are subject to change without prior notice.
We take no responsibility for errors or omissions.
8
EN TECHNICAL DATA
Lamp type 12 x High Power / Flux LED's
Colour temperature 6500 Kelvin
Lumen output at 100% setting 8,500 Lumens
Lumen output at 150% setting 12,000 Lumens
Nominal life expectancy of LED's 50,000 Hours
Power consumption 70 watts in 100% mode, 105 watts in boost mode
Operating modes Choice of 2 main modes
1. Worklight 15 brightness levels
2. Signal mode White flashing, SOS flashing
Focusing system Variable intensity from spot to full flood
Circuit protection MCB circuit breaker - 15A thermal circuit breaker
Protection class IP54
Dimensions (L x W x H) 430mm x 215mm x 255mm
* Battery duration is subject to ambient temperatures.
Battery type SLA LITHIUM DUAL LITHIUM
Battery voltage / amp hour 12V / 22AH 14.8V / 20.8AH 14.8V / 41.6AH
* Brightness level / approx duration
10% 30 hours 45 hours 90 hours
50% 5 hours 45 mins 8 hours 15 mins 18 hours
100% 2 hours 45 mins 4 hours 15 mins 9 hours 15 mins
150% 1 hour 45 mins 3 hours 6 hours 30 mins
* Recharge times
VEPAC integrated charger 5 hours 9 hours 13 hours 30 mins
SLA 12V 3A external mains charger 7 hours N/A N/A
Nominal operating voltage 12V DC 14.8V DC 14.8V DC
Weight (including extension poles) 11.75 Kg 7.75Kg 8.9Kg
9
CAUTION
• Always read the manual fully before use.
• Use the Ritelite approved chargers only, other chargers may cause a
detrimental effect on the performance of this unit.
• Ensure adequate ventilation for this unit whilst charging.
• Do not stare directly into the light head when powered up.
• Do not completely submerse the unit in water.
• No user serviceable parts inside. Leave servicing to a qualified person.
The contents of this manual are subject to change without prior notice.
We take no responsibility for errors or admissions.
ADVICE ON DISPOSAL OF RITELITE PRODUCTS AT END OF LIFE
For our latest advice on the disposal of Ritelite products at end of life please visit the link below.
https://www.ritelite.co.uk/disposal-advice
DISCLAIMER OF WARRANTY
For details about the warranty offered on Ritelite products please visit the link below.
https://www.ritelite.co.uk/warranty-information
EN
Setup Video & Resources
10
DE
K10 LED
AKKU LED-Beleuchtungssystem
SCHNELLSTARTANLEITUNG
SICHERHEITSHINWEISE
• Bitte stellen Sie beim Aufladen sicher, dass das Gerät ausreichend belüet ist.
• Schauen Sie nie direkt in den Lichtkopf oder die LEDs wenn das Gerät
eingeschaltet ist.
• Das Gerät nicht in Wasser oder andere Flüssigkeiten eintauchen.
• Schalten Sie den Lichtkopf nicht in der Nähe brennbarer Materialien ein. Stellen Sie sich-
er, dass die Vorderseite des Lichtkopfes mindestens 0,5 m von anderen Gegenständen
oder Oberflächen entfernt ist, wenn er eingeschaltet ist. Andernfalls kann es zu Hitzeauf-
bau und Feuer kommen.
WICHTIG!
• Ein Wiederaufladen der Batterie ist nach jedem Einsatz unbedingt erforderlich. Lassen
Sie das Gerät nie in einem entladenem Zustand. Bei Missachtung wird die Lebensdauer
und Leistung der Batterie deutlich verringert.
• Bitte verwenden Sie nur zugelassene Batterien und Ladegeräte. Der Gebrauch anderer
Batterien und Ladegeräte kann Schäden hervorrufen und/oder die Leistung des Gerätes
beeinträchtigen.
BETRIEBSARTEN
Handlampe Arbeitslampe
Table of contents
Languages:
Other Ritelite Work Light manuals
Popular Work Light manuals by other brands
PowerSmith
PowerSmith PWLD080T Operator's manual
MaxLite
MaxLite 73683 installation instructions
Heitronic
Heitronic Trend 27867 Installation and operating instructions
Monzana
Monzana Gore MZCL10 manual
EINHELL
EINHELL TE-CL 18/2000 LiAC Original operating instructions
Bayco
Bayco NIGHTSTICK Dual-Light Xtreme Lumens... instruction manual