3
• The Quad Pod is not designed to be towed on a public highway.
• Never move the Quad Pod with the mast partly or fully raised.
• Do not switch on light heads until mast is raised.
• Do not stare directly into the lights to prevent damage to eyes.
• Arrange the angle of the light heads as far as possible to ensure that the light heads are not
likely to dazzle people in the near vicinity.
• Set the Quad Pod up so light spill cannot form a nuisance or danger to others, especially those
using machinery.
• Where possible the Quad pod should be set up away from personnel or moving vehicles.
• Set the Quad pod up in such a way that it can’t obstruct walkways or areas that form emergency
exit routes.
• Check area where the product has been set up on a regular basis to ensure stability has not
been compromised through changing conditions, e.g. through wind or water logged ground.
• Never lean a ladder or other equipment against the Quad pod.
• Do not use the Quad Pod for any purpose other than that for which it is designed.
• The Quad pod is NOT a lifting device for anything other than its designed purpose.
AFTER USE
• Leave mast erected for at least 10 minutes when light heads are turned off to enable the light
heads to cool down.
PACKING AWAY
• In slippery or uneven terrain it is recommended that two people manoeuvre the product at all
times.
• Take extra care handling light heads for transport in case housings are still hot.
MAINTENANCE
• It is recommended that all Quad Pod products are PAT tested at least on an annual basis. Owner
/ manager to assess and decide frequency of PAT testing required depending on regularity or
type of use.
• It is recommended that a regular inspection of the complete product is carried out to look for
signs of wear and tear and identify possible maintenance required. This should be done by a
competent person on at least an annual basis depending on severity and types of use.
• It is recommended that gloves are worn during cleaning and maintenance to protect the user.
• When removing the light heads (load) during deep maintenance or the removal of parts ensure
the product is laid flat to prevent uncontrolled movement of the mast sections in disassembly.
• Any damaged parts that could pose a risk to the user/personnel must be replaced.
• All sliding and rotating mechanisms must be kept clean and lubricated where applicable.
• Never lubricate the winch brake.
• The Quad Pod must be taken out of service if, during use, or repair and maintenance serious
damage is discovered.
• The Quad Pod can only be put back into use after it has been properly repaired and examined
and signed off by authorised personnel.
• Maintenance and repairs can be executed only by authorised personnel.
• If any person maintaining or repairing the device is in any doubt they should contact the dealer
or Ritelite (Systems) Ltd.
