User’s Manual Altimeter Sensor
Alti-DX2
January 2020
6. The binding process was successful when both the receiver
(DSMX 22ms) and "Telemetry" were recognized (Fig. 5).
Figure 5: Binding was successful: Receiver and Telemetry
detected
7. Press the scroll wheel to access the "Function List" and
select "Telemetry" (Fig. 6).
Figure 6: “Telemetry in der Function List
8. To integrate Alti-DX2 the “Auto Configuration” function
must be used:
a. Power on the transmitter, then power on the receiver
b. Delete all Altitude and Vario sensors in the telemetry
menu
c. Select Telemetry >> Settings >> Auto-Config in the
Function List (Fig. 7)
Figure 7: “Auto-Configuration Function in the Telemetry menu
9. Click on "Altitude" at position “4” and if required adjust the
alarms.
2.
Installation in the model aircraft
Since the altitude is determined by measuring the surrounding
air pressure, the installation location should be as free from
drafts as possible. Rapidly moving air over surfaces can create
pressure differences that lead to deviating measurement results.
For this reason, altimeters should never be installed outside the
model aircraft. The optimal installation location is usually
protected from wind within the fuselage of your model aircraft.
Use double-sided adhesive tape or servo tape on the back of the
Alti-DX2 for fastening.
The Alti-DX2 measures air pressure. Therefore, do not wrap the
Alti-DX2 in air-impermeable plastic film.
3.
Technical specification
Determines the altitude above ground level (AGL)
Resolution: 0 cm
Measures altitudes from -3000 m to 3000 m
Dimensions: 23 x 5 x 6 mm
max. Current Consumption: 0 mA
Supply Voltage: 3.4 - 8.5 V
Weight: less than 2.2 g (with cable ~3.0 g)
Power supply via the X-BUS cable
Can be used for drones, helicopters, sailplanes, planes, Jets,
rockets, HGL/DGL
Kay Claußen
Südliche Auffahrtsallee 8
80639 München
WEEE-Reg.-Nr.
DE 87908722
This product must not be disposed of with other
waste.
Instead, it has to be taken to a waste
collection center for treatment, recycling, or
disposal. For more information about where you
can drop off your waste equipment for recycling,
please contact your local city office, your
household waste disposal service or where you
purchased the product.
