RADE/GARAGE F4 User manual
KTM 690 & Husqvarna 701 F4 fairing Installation Manual
Thank you for purchasing the KTM 790/Husqvarna 701 F4 fairing kit from RADE/GARAGE. The
installation is full bolt on, not difficult but may take full afternoon including all preparations.
The installation is the same for KTM 690 2019+ and for Husqvarna 701 2020+ so we use one set of
pictures. Only the side fairings are different for nice fit with the bike itself.
1/ Remove the OEM mask
a/ First take out the hose from the plastic guide on the left side (in the direction of the motorbike)
b/ The mask holds on torx bolts. Remove them and take out the mask
c/ disconnect the headlights connector
2/ Unbundle and disconnect the cables
a/ To be able to remove the black mask holder, first you must cut carefully all zip-ties
b/ Take out the controls from the dash panel. First mark the control cables (what is what) before you
disconnect them. Then you will have easier assembly ☺
Pull the cables down and then push the controls up through the dash panel. Keep them aside, you will
need them soon.
c/ Take small screw driver and release from bottom the ABS control. You will need it soon again.
d/ Remove the speedometer
e/ Go from left side and turn the handlebars to the right. Loose the M5 bolt and bent the black plastic
cover. You will see three connectors from the throttle. Disconnect them.
f/ Now you the cables are free… you can divide them on the group coming from main harness and the
group coming from handlebars. No worries you cannot mix up the connectors because each pair is
different ☺
g/ To finally take out the black mask holder, you have to do short cut of the plastics with sharp knife.
This will enable to remove the mask holder from the brake/ABS hose.
3/ Mount the adapter for Scotts (optional)
It is optional, but we recommend it even you wont use the Scotts, because it is at the same time
convenient handlebar riser
a/ Remove the handle bars
You have to use contra key no 17, because there is nut from the bottom
b/ Take our adapter and M10 bolt –don’t forget to loc-tite! and bolt on. It is a bit tricky to tight it
parallel for precise fit of the handlebars.
4/ Prepare the tower
a/ At first we must prepare the tower. Remove the original speedo grommets and place them into the
tower dash.
b/ Mount the speedo with the original screws.
c/ b/ Also insert the three large supplied grommets into three large holes and insert the controls (not
on the picture). And place in the 12V USB outlet.
d/ Mount the hose guide with M6 flat head bolts. And you are ready to install the tower.
5/ Install the tower
a/ Fisrt step is the top clamp installation. Use M6x25 bolts. The top clamps is mounted to the frame
tubes with two black holders. We recommend to use loc-tite!
b/ bolt on the peg holder with short M6 bolts. Also loc-tite
c/ Use M6x20 bolts and washer to bolt on the tower to the top clamps. Don’t tight at this stage!
d/ Now lift the tower a bit to be able to get inside (start from the bottom) the harness and cables
as on the picture.
Other RADE/GARAGE Motorcycle Accessories manuals
