Prem-I-Air EH1710 User manual

2580 Ver. 3 –0918

EH1710 / EH1710BLK

2kW Convector Heater

This product is only suitable for well-insulated

spaces or occasional use.

2580 Ver. 3 –0918

IMPORTANT

Installer and Users please note:

These instructions should be read carefully and left with the user of the product for

future reference. BEFORE USE

You must inspect the appliance including its cable and plug for any signs of

damage. If the product is damaged, DO NOT use it, and contact your supplier

immediately. PRODUCT SAFETY

This appliance can be used by children aged from 8 years and above and

persons with reduced physical, sensory or mental capabilities or lack of

experience and knowledge if they have been given supervision or instruction

concerning use of the appliance in a safe way and understand the hazards

involved.

Do not leave this product unattended when in use.

Do not use the heater unless the feet are correctly attached.

Children shall not play with the appliance.

We advise not to use this heater on carpets which have a thick pile.

Please ensure the heater is placed on a firm and level surface.

Cleaning and user maintenance shall not be made by children without

supervision.

Do not cover. This symbol shown on the casing of the heater means

that the heater should not be covered.

For indoor use only.

Do not use in bathrooms,

Do not use in wet or damp locations.

Do not place the mains lead beneath a carpet or rug.

Do not position heater immediately below a socket outlet.

Before using please ensure the intended socket / electrical outlet matches the

recommended rating issued to the heater.

Do not use the heater in locations where paint, petrol or other flammable liquids

are used or stored.

Please ensure heater is switched off and unplug when not in use, also keep

unplug before assembly or disassembling parts.

Please avoid the use of an extension lead with this heater as this could cause

the product to overheat.

Do not use the heater for other than its intended use.

Do no insert any object into the heater through the grilles. This may damage

the heater or result in overheating or electric shock.

2580 Ver. 3 –0918

ASSEMBLY / INSTALLATION

For free-standing use: attach the feet to the underneath of the heater

using the four 10 mm screws. The feet are placed at the end of the case.

OPERATION

1. Power 750W

2. Power 1250W

1&2. Power 2000W

3. Thermostat

Note: When heaters are turned on for the first time or when they are turned on after

not being used for long period in time it is normal for that the heater may emit some

smell and fumes. This will disappear when the heater has been on for a short while,

if the smell or fumes do notdisappear we advise toswitch off the heater and contact

a specialist.

Following the above guidelines choose a suitable location for the heater.

Turn the thermostat dial fully in a clockwise direction to the maximum

setting.

2580 Ver. 3 –0918

Turn on the heater by the power switches on the side of the heater, once

on these will illuminate. For the maximum heat setting both switches

should be on.

To reach the desired room temperature turn the thermostat anti-clockwise

until the thermostat “clicks off” and the lights on the switches are seen to

go out. The heater will keep the air temperature in the room at the set

temperature by switching on & off automatically.

NOTE: The heater does remain hot / warm for some time after the unit has

been switch off, please handle with care.

PAT TESTING

When used in a workplace, this product should be safety-tested yearly by a

qualified electrician (PAT Tested). We recommend that it is PAT tested regularly

when used in a domestic environment.

GENERAL SAFETY REQUIREMENTS

Domestic wiring must be tested periodically by a qualified electrician at least once

every 10 years or at every change of occupancy.

For office and retail premises, and buildings such as village halls, the wiring must

be inspected at least once every 5 years.

It is recommended that all buildings be fitted with smoke alarms (it is mandatory for

new buildings).

OPERATING COSTS

At time of going to press, the average cost of electricity is £0.145 per unit (kilowatt-

hour). The amount you are being charged will be shown on your electricity bill.

At this cost, the EH1710 / EH1710BLK will cost £0.29 per hour to run with the

thermostat set to its maximum.

If the thermostat is used to regulate the temperature, the operating costs will be

lower, depending on the room temperature.

2580 Ver. 3 –0918

MAINTENANCE

Before cleaning, turn the heater off, and disconnect from the mains supply. The

heater may then be cleaned using a damp cloth with a drop of washing-up liquid to

remove any dust or dirt from the case. Do no use stronger detergents or solvents

as these may damage the plastic.

Using a dry 1" (25 mm) paint-brush, remove any dust from the grilles.

If the mains lead is damaged, it must be replaced by the manufacturer or and

authorised service centre. If the mains plug needs to be replaced, proceed

as follows:

Connect the brown wire to the terminal

labelled "L".

Connect the blue wire to the terminal

labelled "N".

Make sure that the cord-grip is

positioned correctly (over the outer sheath of the

cable) and it fully tightened.

DISPOSAL AND RECYCLING

You must not dispose of this appliance with domestic household waste.

Most local authorities have specific collection system for appliances and disposal

is free of charge to the end-user.

When replacing an existing appliance with a similar newappliance your retailer may

take the old appliance for disposal.

TECHNICAL SPECIFICATION

Dimensions (with feet): 383×530×198 mm

Weight: 2 kg

Power supply: 230 V ~

Power consumption: 2 kW

2580 Ver. 3 –0918

ERP SPECIFICATIONS

Model Number

EH1710 / EH1710BLK

Item

Symbol

Value

Unit

Heat Output

Nominal Heat Output

Pnom

2,0

Minimum Heat Output

(Indicitive)

Pmin

0,8

Maximum Continuous

Heat Output

Pmax,c

2,0

Auxiliary electricity Consumption

At nominal heat output

elmax

N/A

At minimum heat

output

elmin

N/A

At standby mode

elSB

N/A

Type of heat input, for electric storage local space heaters only (single select)

manual heat charge control, with integrated thermostat

manual heat charge control with room and/or outdoor

temperature feedback

electronic heat charge control with room and/or outdoor

temperature feedback

fan assisted heat output

Type of heat output/room temperature control (single select)

single stage heat output and no room temperature control

Two or more manual stages, no room temperature control

with mechanic thermostat room temperature control

Yes

with electronic room temperature control

electronic room temperature control plus day timer

electronic room temperature control plus week timer

2580 Ver. 3 –0918

Other control options (multiple selections possible)

room temperature control, with presence detection

room temperature control, with open window detection

with distance control option

with adaptive start control

with working time limitation

with black bulb sensor

Contact Details

Prem-i-Air Appliances Ltd, Lancots Lane, St Helens,

WA9 3EX

SERVICE WARRANTY

Prem-i-Air guarantees the product free from defects in materials and workmanship

for a period of one years.

Should this unit be operated under conditions other than those recommended, at

voltages other than the voltage indicated on the unit, or any attempts made to

service or modify the unit, then the warranty will be rendered void.

The product you buy may sometimes differ slightly from illustrations. This warranty

is in addition to, and does not affect, your statutory rights.

If you have any problems with this product, please call our Help Desk on (0845)

459 4816.

Prem-i-Air Appliances Ltd.,

Lancots Lane,

Sutton,

St. Helens,

Merseyside.

WA9 3EX

Website: www.prem-i-air.co.uk

This manual suits for next models

Table of contents

Other Prem-I-Air Heater manuals

Prem-I-Air

Prem-I-Air EH1794 User manual

Prem-I-Air

Prem-I-Air EH1896 User manual

Prem-I-Air

Prem-I-Air EH1524 Manual

Prem-I-Air

Prem-I-Air HQH2000H User manual

Prem-I-Air

Prem-I-Air EH1644 User manual

Prem-I-Air

Prem-I-Air EH1842 User manual

Prem-I-Air

Prem-I-Air EHO154 User manual

Prem-I-Air

Prem-I-Air PCH0501 User manual

Prem-I-Air

Prem-I-Air EH1710 User manual

Prem-I-Air

Prem-I-Air EH1582 User manual

Prem-I-Air

Prem-I-Air N10Turbo User manual

Prem-I-Air

Prem-I-Air EH1840 User manual

Prem-I-Air

Prem-I-Air EH0291 User manual

Prem-I-Air

Prem-I-Air EH1550 User manual

Prem-I-Air

Prem-I-Air N10T24 User manual

Prem-I-Air

Prem-I-Air EH1668 User manual

Prem-I-Air

Prem-I-Air EH1526 User manual

Prem-I-Air

Prem-I-Air EH1712 User manual

Prem-I-Air

Prem-I-Air EH1426 User manual

Prem-I-Air

Prem-I-Air Elite EH1365 User manual

Prem-I-Air

Prem-I-Air EH1369 User guide

Prem-I-Air

Prem-I-Air EH1436 User manual

Prem-I-Air

Prem-I-Air EH1372 User manual

Prem-I-Air

Prem-I-Air EH1846 User manual

Popular Heater manuals by other brands

oventrop

oventrop Regucor Series quick start guide

Blaze King

Blaze King CLARITY CL2118.IPI.1 Operation & installation manual

ELMEKO

ELMEKO ML 150 Installation and operating manual

BN Thermic

BN Thermic 830T instructions

KING

KING K Series Installation, operation & maintenance instructions

Empire Comfort Systems

Empire Comfort Systems RH-50-5 Installation instructions and owner's manual

Well Straler

Well Straler RC-16B user guide

EUROM

EUROM 333299 instruction manual

Heylo

Heylo K 170 operating instructions

Eterna

Eterna TR70W installation instructions

Clarke

Clarke GRH15 Operation & maintenance instructions

IRSAP

IRSAP The Radiator Company Ovali Fitting instructions

Empire Heating Systems

Empire Heating Systems WCC65 Installation and owner's instructions

Wetekom

Wetekom 92 86 43 Original instructions

Desa

Desa SPC170-F owner's manual

Watlow

Watlow Watrod Electric Tubular Heaters Specifications

Haverland

Haverland ECO-DRY GPS Series Instruction & installation manual

Stelpro

Stelpro ASILVC2060 Series user guide