Philips LASERFAX 920 User manual

920

100

OFF

English page 4

Français page 16

Dansk side 28

Norsk side 40

Svenska sid 52

Suomi sivu 64

1Do not allow the shaver to become wet.

2Do not leave the appliance in a position

where it can become damaged by direct

sunlight or other heat source.

- Before first use or

- if the shaver has not been used for a

month or longer

it should be charged for a period of at

least 8 hours (irrespective of the reading

on the display).

If the batteries are completely empty, it may

take some time (3-5 minutes) before

information appears in the display.

• Please bear in mind that your skin may

need two to four weeks to become fully

accustomed to the Philishave shaving

system.

920

100

920

100

■■■ Important English

■■■ Switching on/off.

3 The slider switch has a locking

knob which prevents the shaver

from being switched on

accidentally.

Keeping the small knob on the

switch pressed-in slide the switch

upwards/downwards.

■■■ Charging

• Ensure that the shaver is switched off.

•It is advisable to charge the shaver at

temperatures between 5°and 35°C (41°and 95°F).

This guarantees maximum life from the

rechargeable batteries.

•If you keep the shaver in the case when

charging ensure that the lid is left open to

prevent overheating.

•Before first use (or if the shaver has not been

used for long time) it should be charged for a

period of at least 8 hours.

To protect the environment, this

rechargeable Philishave appliance is

equipped with nickel-hydride batteries.

These contain less than 0.01% cadmium.

Yet we advise you to ensure that the batteries

are separated from the normal household

refuse and that they are disposed of at an

officially assigned place when discarding your

appliance in due course. Please refer to section

“Protecting the environment”.

•Recharging: 60 minutes.

The shaver can also be charged from a 12 - 24 Volts

(DC) supply using cord connector type HP 1957.

(Available from Philips retailers or Authorised Service

Dealers.) Charging from a 12 - 24 Volts (DC) supply

requires approx. 24 hours.

• Regular cleaning of the shaver means that less

battery energy is consumed, so that more shaving

time becomes available.

• The shaver will not be damaged by leaving it

connected to the mains supply after it is fully

charged. However, it is not advisable to charge the

shaver permanently as this would shorten the life of

the rechargeable batteries.

4 Insert the small plug into the

shaver. Ensure that the plug is

pushed fully home. (Note the

indication mark.)

Mains voltages: 100 - 240 Volts.

(The shaver adjusts

automatically.)

5One of the blocks of the charge meter

will start flashing.

If the batteries are almost empty, the

first block will be red.

When it turns green, there is enough

energy in the rechargeable batteries for

one cordless shave (3 minutes).

6Each time when 20% of the full charge

has been accomplished the next block

of the energy meter will start to flash.

920

100

920

100

920

100

7After 60 minutes, block “100” comes on

flashing. This block stops flashing as

soon as the shaver is fully charged.

■■■ Cordless shaving

When switching on and off, the blocks of the energy

meter become visible for approx. 8 seconds.

You can then check how much charge is still

available in the rechargeable batteries, until the

reserve capacity will be reached.

8After shaving cordless with the fully

charged shaver for some time, the fifth

block will no longer be visible.

Thereafter, the other blocks will

disappear successively.

9When the last block turns red, the

reserve energy has been reached.

(You will be able to complete the

shave.)

As the shaver is switched off you will

hear a sound signal for 4 seconds

and the red block will start flashing.

This indicates that it is time to

recharge the shaver.

920

100

920

100

920

100

■■■ Have you missed out charging?

When the batteries are completely empty and the

shaver stops, you can give the shaver a quick

charge (sufficient for one cordless shave):

- Charge the shaver until the last block turns from red

into green.

■■■ Shaving directly from the mains supply

(wall socket)

- If you wish you can connect the shaver to a wall

socket using the mains cord and shave directly from

the mains supply.

■■■ Shaving

10 Switch on.

11 The comfort control can be adjusted to suit

skin sensitivity.

Start with the control set to position 1 (for sensitive

skin) and then try other positions to find the one

that suits you best.

12 Move the shaving unit quickly over the skin

and especially against the direction of the hair

growth, stretching the skin with your free hand to

bring the hairs into an upright position.

• Best results are obtained if the skin is dry.

Preferably shave before or some time after

washing.

• If required apply a pre-shave lotion. This can be

particularly helpful if the climate is warm and humid.

1 2 3 4 5 6 7 8 9

11 12

■■■ Trimmer

The trimmer can be engaged whilst the motor is

running.

13 To engage the trimmer push the slide

upwards.

To disengage move the slide downwards.

Brush the trimmer clean after each use.

14 The trimmer has been especially designed for

grooming sideburns, moustache and beard.

The trimmer is not required for long hairs in the

neck area; these hairs can easily be shaved off

with the shaving unit.

15 Maintenance (every six months)

Apply two drops of light machine oil to the teeth of

the trimmer.

13 15

OIL

Other manuals for LASERFAX 920

This manual suits for next models

Table of contents

Languages:

Other Philips Electric Shaver manuals

Philips

Philips Philishave HQC282/60 User manual

Philips

Philips RQ111/52 User manual

Philips

Philips RQ1175 User manual

Philips

Philips BT720 Series User manual

Philips

Philips Norelco BodyGroom BG2030 User manual

Philips

Philips NT1150/10 User manual

Philips

Philips QT4014 User manual

Philips

Philips Philishave HQ 662 User manual

Philips

Philips BT1235 User manual

Philips

Philips Philishave HQ 6735 User manual

Philips

Philips S1520 User manual

Philips

Philips S1203 User manual

Philips

Philips Norelco 8270XL User manual

Philips

Philips SW3700 User manual

Philips

Philips T870 User manual

Philips

Philips HS8420/40 Owner's manual

Philips

Philips Norelco Arcitec 1050X User manual

Philips

Philips S3520 User manual

Philips

Philips S529 User manual

Philips

Philips Lumea 9000 Series User manual

Philips

Philips Lumea SC2001/01 User manual

Philips

Philips HQ7141 User manual

Philips

Philips Essence 5000 Series User manual

Philips

Philips AT754 User manual

Popular Electric Shaver manuals by other brands

Norelco

Norelco Quadra 7610X owner's manual

Braun

Braun WaterFlex WF2s manual

Daga

Daga MT-400 Directions for use

Remington

Remington BHT100 user manual

Kompernass

Kompernass KH 5537 operating instructions

Remington

Remington BHT6100 manual

MIA

MIA Aqua Body manual

Matheo

Matheo MLR 15 manual

CTC Union

CTC Union Clatronic HSM 3441 NE instruction manual

Remington

Remington XR7000 user manual

Eldom

Eldom G47 manual

Braun

Braun silk-epil 5 manual

SEVERIN

SEVERIN SÉRIE E700 0533 Dimensions

Remington

Remington PR1355 manual

Aurora

Aurora AU 3543 manual

Braun

Braun InterFace 3614 user manual

Wahl

Wahl 8061 5-STAR operating manual

Norelco

Norelco 4404LC Specifications