Philips QT4014 User manual

User manual

QT4015,

QT4014,

QT4013,

QT4011

QT4015, QT4015, QT4014, QT4013, QT4011

ENGLISH 4

ESPAÑOL 13

FRANÇAIS 23

INDONESIA 33

한국어 42

BAHASA MELAYU 51

PORTUGUÊS 61

ภาษาไทย 70

 78

繁體中文 88

简体中文 96

Introduction

Congratulations on your purchase and welcome to

Philips! To fully benet from the support that Philips

offers, register your product at

www.philips.com/welcome.

General description (Fig. 1)

1 Trimming comb

2 Cutting unit

3 Precision Zoom Lock™ adjustment ring

4 On/off slide with battery indicator

5 Socket for appliance plug

6 Pouch

7 Brush

8 Appliance plug

9 Adapter

Important

Read this user manual carefully before you use the

appliance and save it for future reference.

Danger

- Make sure the adapter does not get wet.

Warning

- The adapter contains a transformer. Do not cut

off the adapter to replace it with another plug, as

this causes a hazardous situation.

- This appliance is not intended for use by persons

(including children) with reduced physical, sensory

or mental capabilities, or lack of experience

and knowledge, unless they have been given

supervision or instruction concerning use of the

appliance by a person responsible for their safety.

- Children should be supervised to ensure that they

do not play with the appliance.

ENGLISH

Caution

- Never immerse the appliance in water or rinse it

under the tap. Only the cutting unit can be rinsed

under the tap.

- Use, charge and store the appliance at a

temperature between 5°C and 35°C.

- Only use the adapter supplied.

- If the adapter is damaged, always have it replaced

with one of the original type in order to avoid a

hazard.

- This appliance is only intended for trimming

the human beard. Do not use it for any other

purpose.

- Do not use the appliance if the cutting unit or the

trimming comb is damaged or broken, as this may

cause injury.

Electromagnetic elds

This Philips appliance complies with all standards

regarding electromagnetic elds (EMF). If handled

properly and according to the instructions in this

user manual, the appliance is safe to use based on

scientic evidence available today.

General

- The appliance is equipped with an automatic

voltage selector and is suitable for mains

voltages from 100 to 240 volts.

- The adapter transforms 100-240 volts to a safe

low voltage of less than 24 volts.

ENGLISH 5

Charging

Charge the appliance fully before you use it for the

rst time.

It takes approximately 1 hour to fully charge the

appliance.

When it is fully charged, the appliance has a cordless

operating time of up to 60 minutes.

Note:You can use the appliance cordless as well as

connected to the mains.

1 Make sure the appliance is switched off.

2 Insert the appliance plug into the appliance.

3 Put the adapter in the wall socket.

,The charging light starts to ash green to

indicate that the appliance is charging.

,When the battery is fully charged, the charging

light lights up green continuously.

After 30 minutes, the charging light goes out.

4 After charging, remove the adapter from the

wall socket and pull the appliance plug out of

the appliance.

Battery low

When the battery is almost empty (when there are

only 5 or fewer trimming minutes left), the charging

light ashes orange.

Optimising the lifetime of the rechargeable

battery

When you have charged the appliance for the rst

time, we advise you to use it until the battery is

completely empty. Continue to use the appliance

until the motor almost stops running during a

session. Then recharge the battery. Follow this

procedure at least twice a year.

ENGLISH6

Using the appliance

Always comb the beard and/or moustache with a

ne comb before you start trimming.

When you trim for the rst time, be careful.

Do not move the trimmer too fast. Make smooth

and gentle movements.

Trimming with comb

1 Turn the Precision Zoom Lock™adjustment

ring to the desired setting.The selected setting

is the setting in the centre of the adjustment

ring.

See the table below for an overview of

the settings and the resulting hair lengths.

Setting Resulting hair

length

Setting Resulting hair

length

. 0.5mm . 5.5mm

1 1mm 6 6mm

. 1.5mm . 6.5mm

2 2mm 7 7mm

. 2.5mm . 7.5mm

3 3mm 8 8mm

. 3.5mm . 8.5mm

4 4mm 9 9mm

. 4.5mm . 9.5mm

5 5mm 10 10mm

3•

4••1

ENGLISH 7

Note: When you trim for the rst time, start at the

highest setting (10) to familiarise yourself with the

appliance.

2 Switch on the appliance.

3 To trim most effectively, move the trimmer

against the hair growth direction. Make sure

the surface of the comb always stays in contact

with the skin.

4 If a lot of hair has accumulated in the beard

trimming comb, remove the comb and blow and/

or shake the hair out of it.The selected setting

does not change when you do this.

Trimming at the unique ‘stubble look’

setting

1 To create a ‘stubble look’, trim with the beard

trimming comb set to setting 1.

Trimming without comb

Use the trimmer without beard trimming comb to

trim full beards and single hairs.

Be careful when you trim without comb because

the cutting element removes every hair it touches.

1 Pull the beard trimming comb off the appliance

as shown in gure 8.

2 Switch on the appliance.

ENGLISH8

3 Make well-controlled movements.Touch the

hair lightly with the trimmer.

Corded trimming

If the battery is low, you can also use the appliance

from the mains:

1 Switch off the appliance, insert the adapter in

the wall socket and wait a few seconds before

you switch on the appliance.

Cleaning

Never use scouring pads, abrasive cleaning agents

or aggressive liquids such as alcohol, petrol or

acetone to clean the appliance.

1 Make sure the appliance is switched off and

disconnected from the mains.

2 Wipe the housing of the appliance with a dry

cloth.

Never immerse the appliance in water or rinse it

under the tap.

3 Remove the trimming comb and clean it with

the brush.

4 Remove the cutting unit by pushing against the

teeth of the cutting unit and clean it with the

brush or rinse it under the tap.

ENGLISH 9

5 Shake off excess water and place the cutting

unit back by inserting the lug of the cutting unit

into the guiding slot.

6 Push the cutting unit back onto the appliance

(‘click’).

Replacement

Only replace a worn or damaged cutting unit with

an original Philips cutting unit, available from

authorised Philips service centres.

1 Open the cutting unit.

2 Remove the old cutting unit by pushing against

the teeth of the cutting unit.

3 Insert the lug of the new cutting unit into the

guiding slot.

4 Push the cutting unit back onto the appliance

(‘click’).

ENGLISH10

This manual suits for next models

Table of contents

Languages:

Other Philips Electric Shaver manuals

Philips

Philips OneBlade QP6650 User manual

Philips

Philips HQ6762/33 User manual

Philips

Philips QT4045 User manual

Philips

Philips S91xx User manual

Philips

Philips HQ7180 User manual

Philips

Philips HQ 8870 User manual

Philips

Philips Norelco 3405LC User manual

Philips

Philips HQ4866/16 User manual

Philips

Philips RQ1297CC User manual

Philips

Philips S131 Series User manual

Philips

Philips HQ7100 User manual

Philips

Philips Norelco BG2040 User manual

Philips

Philips S9781/31 User manual

Philips

Philips QS6141/33 User manual

Philips

Philips NT8110/60 User manual

Philips

Philips HQ402/17 Configuration guide

Philips

Philips QG3371 User manual

Philips

Philips Luxury A6 BW User manual

Philips

Philips NT9141 User manual

Philips

Philips QP2531/26 User manual

Philips

Philips HQ132 User manual

Philips

Philips Headgroom QC5570/32 User manual

Philips

Philips HQ8894/01 User manual

Philips

Philips RQ1295CC User manual

Popular Electric Shaver manuals by other brands

Norelco

Norelco Quadra 7610X owner's manual

Braun

Braun WaterFlex WF2s manual

Daga

Daga MT-400 Directions for use

Remington

Remington BHT100 user manual

Kompernass

Kompernass KH 5537 operating instructions

Remington

Remington BHT6100 manual

MIA

MIA Aqua Body manual

Matheo

Matheo MLR 15 manual

CTC Union

CTC Union Clatronic HSM 3441 NE instruction manual

Remington

Remington XR7000 user manual

Eldom

Eldom G47 manual

Braun

Braun silk-epil 5 manual

SEVERIN

SEVERIN SÉRIE E700 0533 Dimensions

Remington

Remington PR1355 manual

Aurora

Aurora AU 3543 manual

Braun

Braun InterFace 3614 user manual

Wahl

Wahl 8061 5-STAR operating manual

Norelco

Norelco 4404LC Specifications