Philips SCF355 User manual
SCF355
1
6
General description (Fig. 1)
1 Bottle warmer
2 Light
3 Settings knob
4 Off setting
5 Defrost setting
6 Milk warming setting for contents up to 180ml/6oz
7 Food warming setting
8 Milk warming setting for contents over and including 180ml/6oz
Important
register your appliance at www.philips.com/
welcome.
Read this user manual carefully before you use the
bottle warmer and save it for future reference.
Warning
- Only use the appliance indoors.
- Keep the appliance and its cord out of the reach of
children aged less than 8 years.
-
water or other liquid.
- Do not let the mains cord hang over the edge of a
table or worktop. Excess cord can be stored in the
base of the bottle warmer.
- Keep the mains cord away from hot surfaces.
- Only connect the appliance to an earthed wall
socket.Always make sure that the plug is inserted
into the wall socket properly.
ENGLISH
- Check if the voltage indicated on the bottom of the
appliance corresponds to the local mains voltage
before you connect the appliance.
-
an earthed extension cord with a rating of at least
13 amperes.
-
or the appliance itself is damaged. If the mains cord
- Do not place the appliance on or near a hot gas or
- This appliance can be used by children aged from
8 years and above and persons with reduced
experience and knowledge if they have been given
supervision or instruction concerning use of the
appliance in a safe way and understand the hazards
involved. Children shall not play with the appliance.
Cleaning and user maintenance shall not be made
by children unless they are 8 years and above and
supervised.
- Do not preheat the appliance.
- Always place a fully assembled bottle with cap in the
bottle warmer before you add water.
- Make sure you add water before you switch on the
bottle warmer.
ENGLISH 7
- Hot water can cause serious burns. Be careful when
the bottle warmer contains hot water.
- The accessible surfaces of the appliance may
become hot during use.
- Do not move the appliance when it contains hot
water.
- When the food or milk has reached the required
the bottle warmer. If you leave food or milk in the
increases.
- Always check the food temperature before you
feed your child.
Caution
- This appliance is intended to be used in household
type environments.
- Unplug the appliance when it is not in use.
- Let the appliance cool down before you clean it.
- Follow the descaling instructions to avoid
irreparable damage.
- Do not try to open or repair the appliance yourself.
in your country (see www.philips.com/support).
ENGLISH8
Using the bottle warmer
bottles and milk/baby food in containers and other baby food jars.
Note: Philips AVENT breast milk bags cannot be used in this bottle warmer.
Explanation of settings
- Off setting:The bottle warmer is switched off and the light is off.
is lit (Fig. 2).
- Defrost setting: Defrost a bottle/container of milk/baby food to liquid
- Milk warming setting for contents up to 180ml/6oz: Select this setting
when you want to warm a bottle of milk with a content up to
180ml/6oz.
- Food warming setting: Select this setting when you want to warm a
container/jar of baby food.
- Milk warming setting for contents over and including 180ml/6oz:
Select this setting when you want to warm a bottle of milk with a
content over and including 180ml/6oz.
Using the bottle warmer to warm milk
1 Put the mains plug in the wall socket (Fig. 3).
2 Place a bottle in the bottle warmer (Fig. 4).
3 Fill the bottle warmer with drinking water up to the level of the
milk in the bottle. In case of large amounts of milk, the maximum
level of water is approximately 1 cm below the top of the bottle
warmer.An accurate water level ensures correct warming
performance (Fig. 5).
ENGLISH 9
4 Select the desired setting. See the warming reference table at the
end of this chapter to check how long the milk needs to be
warmed in the selected setting (Fig. 6).
Note:The speed of warming milk depends on the amount of the milk
warmed and on its initial temperature, i.e. room temperature (20°C) or fridge
temperature (5°C).
5 The orange light goes on when you select a setting.This indicates
that the bottle warmer is on (Fig. 7).
Note:Whilst warming the milk circulates and heats evenly.
6 Check the warming reference table for the time required to warm
the milk. Remove the bottle from the bottle warmer after the time
indicated in the warming reference table has passed (Fig. 8).
back into the appliance for a maximum of 30 seconds of extra warming.
This will create a slightly warmer result but without overheating.
Caution: If you leave the bottle in the bottle warmer longer than the
time indicated in the settings table, the milk may become overheated.
Note: If you overheat breast milk, valuable nutrients and vitamins may be lost.
7 Always check the temperature before you feed your baby.
Gently shake the bottle or milk storage container and check the
temperature of the milk by sprinkling a few drops on the inside
of your wrist (Fig. 9).
8 Turn the knob back to the ‘off’ position. (Fig. 10)
Caution: If you do not turn the knob back to the ‘off’ position,
the water keeps warming.
ENGLISH10
Other manuals for SCF355
22
This manual suits for next models
1
Table of contents
Languages:
Other Philips Bottle Warmer manuals
Philips
Philips SCF355 User manual
Philips
Philips SCF355 User manual
Philips
Philips AVENT scf356 User manual
Philips
Philips HD4331/01 User manual
Philips
Philips AVENT scf356 User manual
Philips
Philips SCF355 User manual
Philips
Philips SBC SC215 User manual
Philips
Philips SCF255/51 User manual
Philips
Philips AVENT scf356 User manual
Philips
Philips SCF205/34 User manual
Philips
Philips AVENT SCF358 User manual
Philips
Philips AVENT scf356 User manual
Philips
Philips SCF355 User manual
Philips
Philips AVENT SCF358 User manual
Philips
Philips SBCSC230/05 User manual
Philips
Philips AVENT Anti-colic User manual
Philips
Philips AVENT SCF358 User manual
Philips
Philips SBC SC205 User manual
Philips
Philips SCF355 User manual
Philips
Philips SCF355/04 User manual
