Pentair AURORA Edwards 80 User manual

Edwards Model 20 / Model 80

Pump Ma

1-1

General 1

Introduction

The Edwards Model 20and Model 80 pumps(Figure 1-1) are standard-duty high-speed gear-driven

positive-displacement rotary pumpswith gear-type rotors. The pumpsare self-priming.

Edwards rotary pumps are available in many configurations. While they may look alike,

there may be significant differences from one pump to another. Differences include

construction material, sealing method, rotor type, etc.

Figure 1-1. Edwards Model 20 & Model 80 Pumps

2-1

Maintenance 2

Edwards rotary pumps are available in many configurations. While they may look alike,

there may be significant differences from one pump to another. Differences include con-

struction material, sealing method, rotor type, etc. This manual covers only one config-

uration, which is defined by a model number and a serial number. Check the name plate

on the pump to make certain the model number is 20-420 and the serial number is

________________. If the numbers do not match, contact Edwards - Pentair Water.

Most pump repairs can be performed by maintenance personnel using normally avail-

able tools.

Consumable Materials

Cleaning materials, lubricants, and other products needed during pump maintenance

are listed in Table 2-1.

Do not perform maintenance using this manual if the model number on the

pump is not 20-420 or the serial number is not ________________. Performing

maintenance using the wrong manual could result in pump failure or personal

injury.

Table 2-1. Consumable Materials

Item Nomenclature Specification Common Name

1 Lint-Free Cloth MIL-C-85043

2 “Dry” Cleaning Solvent Acetone, Brake

Cleaner

3 Emery Cloth 220 Grit 3M, Anderson,

Sandvik, Mirka

4 Anti-Seize Compound “Nev’r Seize”

5 Red Loctite PermaLoc HH-120

6 High-Tack Gasket Spray Loctite, Permatex

2-2

Model 20 / Model 80 Pumps

Lubrication

To ensure a long service life, the pump should be lubricated routinely with approved

grease (7, Table 2-1). If the pump is operating under normal loads and temperatures,

use the intervals defined in Table 2-2. If the pump is operating at over 180°F, contact

Edwards - Pentair Water for recommended lubrication interval for your application.

Troubleshooting

Table 2-3 provides assistance in diagnosing and correcting malfunctions that may occur

during normal operation.

7 General Purpose Grease MIL-G-18709

NLGI #2

Chevron Ulti-Plex,

Shell Retina LC

8 Lapping Compound D51804, 180 Grit

Silicon Carbide

Felpro “Clover”

Brand

Ta b l e 2 - 2 . Lubrication Schedule

Item Interval Amount of Grease

Bearings 6,000 Hours 0.25 Ounce

Timing Gears 6,000 Hours 1.00 Ounce

Table 2-3. Troubleshooting

Trouble Probable Cause Remedial Action

1. Pump does

not turn

1a. Seized pump. 1a. Repair or replace pump.

1b. Faulty or misaligned

coupling.

1b. Replace or realign

coupling.

1c. Damaged or missing

shaft key.

1c. Replace key.

2. Excessive

Noise

2a. Loose or misaligned

coupling.

2a. Tighten, align, or replace

coupling.

2b. Cavitation. 2b. Check suction piping with

a vacuum gauge. Gauge

should read less than 10-

in. Hg in most cases.

Contact Edwar ds for the

exact reading for your

application.

Table 2-1. Consumable Materials (Continued)

Item Nomenclature Specification Common Name

Zerk fittings do not

have check balls.

This prevents bear-

ings from being

over-greased.

Excess grease will

run out of the fit-

ting when pump is

in operation.

The pump has

heat-treated steel

timing gears,

which can be very

noisy when oper-

ated above 900

rpm. This is a nor-

mal condition, and

does not require

maintenance

action.

2-3

Maintenance

Removal

1. Before removing pump, refer to troubleshooting chart (Table 2-3) to determine if

the problem is actually the pump.

2. Ensure adequate clearance exists for removal of pump. Disassemble adjacent com-

ponents as required for adequate working clearance.

3. Before removal, clean exterior parts to remove accumulated dirt, grease, or foreign

material.

4. Apply tags to identify parts of similar configuration to ensure correct installation.

2c. Worn or damaged

bearing(s).

2c. Repair or replace pump.

3. Excessive

vibration

3a. Loose or misaligned

coupling.

3a. Tighten, align, or replace

coupling.

3b. Cavitation. 3b. Check suction piping with

a vacuum gauge. Gauge

should read less than 10-

in. Hg in most cases.

Contact Edwards for the

exact reading for your

application.

3c. Worn or damaged

bearing(s).

3c. Repair or replace pump.

4. Reduced flow 4a. Clogged suction screen. 4a. Clean or replace screen.

4b. Cavitation. 4b. Check suction piping with

a vacuum gauge. Gauge

should read less than 10-

in. Hg in most cases.

Contact Edwards for the

exact reading for your

application.

4c. Pump liners and/or

rotors worn or damaged.

4c. Repair or replace pump.

4d. Low pump speed 4d. Increase pump speed.

To avoid injury, always de-energize the input driver and lock-out or red-tag the

controller. Let the pump cool before removing.

Table 2-3. Troubleshooting (Continued)

Trouble Probable Cause Remedial Action

This manual suits for next models

Table of contents

Other Pentair Water Pump manuals

Pentair

Pentair Flex Vane FP710 User manual

Pentair

Pentair Nocchi Omnia 80/5 User manual

Pentair

Pentair Compli 1010/4 BWE User manual

Pentair

Pentair Nocchi MCP 4 User manual

Pentair

Pentair HYDROMATIC HTS33A1 Manual

Pentair

Pentair HYDROMATIC BV40 Guide

Pentair

Pentair Sta-Rite SCM 4 PLUS Series User manual

Pentair

Pentair Hydromatic HRS Manual

Pentair

Pentair Berkeley LTHH Series User manual

Pentair

Pentair Aurora 1060B Series Operating instructions

Pentair

Pentair WhisperFloXF User manual

Pentair

Pentair Myers MVPH-100 User manual

Pentair

Pentair PGA Series User manual

Pentair

Pentair Flotec FPSS5700A User manual

Pentair

Pentair AURORA 3801 Operating instructions

Pentair

Pentair HYDROBOOST User manual

Pentair

Pentair myers aplex Series Manual

Pentair

Pentair JUNG PUMPEN SIMER User manual

Pentair

Pentair HYPRO 2100 Series Use and care manual

Pentair

Pentair CX series Troubleshooting guide

Pentair

Pentair Hypro 9915-DP803 User manual

Pentair

Pentair WHISPERFLOXF VS User manual

Pentair

Pentair SHURFLO 4048 User manual

Pentair

Pentair NOCCHI PRIOX 250/8 User manual

Popular Water Pump manuals by other brands

Neptun

Neptun NPHW 5500 operating instructions

Sensidyne

Sensidyne Gilian BDX-II Operation & service manual

Draper

Draper 47808 instructions

Trolla

Trolla 12820 manual

Sunfab

Sunfab SVH Series installation guide

WilTec

WilTec 50740 Operation manual

Fieldmann

Fieldmann FVC 5015 EK user manual

Everbilt

Everbilt EFSUB5-122HD Use and care guide

Graco

Graco Husky 3300e manual

esotec

esotec 101018 operating manual

moyno

moyno 2000 CC Service manual

Becker

Becker BASIC VASF 2.80/1-0.AC230 operating instructions

Sykes AmeriPumps

Sykes AmeriPumps GP100M Operation and maintenance instructions

DUROMAX

DUROMAX XP WX Series user manual

BRINKMANN PUMPS

BRINKMANN PUMPS SBF550 operating instructions

Franklin Electric

Franklin Electric IPS Installation & operation manual

Xylem

Xylem e-1532 Series instruction manual

Milton Roy

Milton Roy PRIMEROYAL instruction manual