Pelonis PFH15A2BGB User manual

READ AND SAVE THESE INSTRUCTIONS

Attention: Pictures in the IM are for reference only.

FAN HEATER

MODEL: PFH15A2BGB

This product is only suitable for well insulated spaces or occasional use.

OWNER’S MANUAL

[email protected]

When using electrical appliances,basic precautions should always be followed to

reduce the risk of fire,electric shock,and injury to persons,including the following:

1. Read all instructions before using heater.

2. This heater is hot when in use. To avoid burns, do not let bare skin touch hot

surface. If provided, always use handles when moving this heater. Keep

combustible materials such as furniture, pillows, bedding, papers, clothes and

curtains at least 3 feet (0.9m) from the front of the heater and keep them away

from the sides and rear.

3. Extreme caution is necessary when any heater is used by or near children or

invalids and whenever the heater is left operating and unattended.

4. Always unplug the heater when not in use.

5. Do not operate any heater with a damaged cord or plug or after the heater

malfunctions, has been dropped or damaged in any manner. Discard heater or

return heater to authorized service facility for examination, electrical or

mechanical adjustment, or repair.

6. Do not use the heater outdoors.

7. This heater is not intended for use in bathroom, laundry areas and similar moist

indoor locations. Never locate heater where it may fall into a bathtub or other

water container.

8. Do not run cord under carpeting. Do not cover cord with throw rugs, runners,

or similar coverings. Do not route cord under furniture or appliances. Arrange

cord away from traffic area and where it will not be tripped over.

9. CAUTION: This appliance has a polarized plug (one blade is wider than the

other). To reduce the risk of shock, this plug is intended to fit only one way in a

polarized outlet. If the plug does not fit fully in the outlet, reverse the plug. If it

still does not fit, contact a qualified electrician. DO NOT attempt to defeat this

safety feature. To do so could result in an electric shock hazard.

10. This heater draws 12.5 amps during operation. To prevent overloading a

circuit, do not plug the heater into a circuit that already has other appliances

working.

11. CAUTION: It is normal for the plug to feel warm to the touch; however, a loose

fit between the AC outlet (receptacle) and plug may cause overheating and

distortion of the plug. Contact a qualified electrician to replace loose or worn

outlet.

IMPORTANT INSTRUCTIONS

PLEASE READ AND SAVE THESE IMPORTANT SAFETY INSTRUCTIONS

PART FIGURE

12. To disconnect the heater, first turn controls to off, then remove plug from

outlet. Never pull by the cord.

13. Do not insert or allow foreign objects to enter any ventilation or exhaust

opening as this may cause an electric shock or fire, or damage the heater.

14. To prevent a possible fire, do not block air intakes or exhaust in any manner.

Do not use on soft surface, like a bed, where openings may become blocked.

15. A heater has hot and arcing or sparking parts inside. Do not use it in the areas

where gasoline, paint, or flammable liquids are used or stored.

16. Use this heater only as described in this manual. Any other use not

recommended by the manufacturer may cause fire, electric shock, or injury to

persons.

17. CAUTION: Always plug heaters directly into a wall outlet/receptacle. Never

use with an extension cord or reloadable power tap (outlet/power strip).

18. The output of this heater may vary and its temperature may become intense

enough to burn exposed skin. Use of this heater is not recommended for

persons with reduced sensitivity to heat or an inability to react to avoid burns.

19. “SAVE THESE INSTRUCTIONS”

Control panel

Safty grill

Stand

Do not cover

Pilot lamp

Considerate Hint: The machine is equipped with a pilot lamp that glows whenever the heater is plugged in and turned on.

When the machine is in the three air flow direction of 3、4、5, if the machine is in the Heater low“ ”

it will be forced to switch to the Heater high“ ” The Machine has the following 5 kinds of air flow direction.

Manual

Air flow direction adjustment

The Machine has the following 5 kinds of air flow direction

Dispaly area

TemperationTimer Function ON/OFF

1 2 3 4 5

Considerate Hint: When making the adjustment, do not place your hand on the saftu grill, to prevent injury.

setting

Timing function

Timing stop

When the machine is turned on, press the “ ” key to enter the timing stop state

(within 0-8 hours).The timing stop time starts from 0h. Each press of the “ ” key can

increase by 1 hour. After 8h, press the “ ” key again to start from 0h.

Timing start

When the machine is in the standby mode, press the “ ” key to enter the reservation

start mode (within 0-8 hours) .The reservation start time starts from 0h. Each press of

the “ ” key can increase by 1 hour. After 8h, press the “ ” key again to start from 0h.

Temperature sensor short circuit, open circuit protection function

No matter in what mode, the temperature sensor appears short circuit or open circuit,

digital screen displays "E1" or "E2" and constantly flicker, while any key operation is

invalid and the buzzer rings 10 times.

Safety protection

1.In the start state, when the room temperature TH is above 122

°F

, close all outputs

system, The digital screen displays "FF" and flashes 1 time per second.press any

key will not work, only the power down to exit the protection.

Check before turning on the machine

1. Check if the power wire is under good condition.

2. The product adopts 120V AC power supply, before use, please confirm if

the rated current of the power socket meets the local requirements with safe

grounding device, otherwise, please replace it with the qualified socket.

Start the machine

Plug the unit into a grounded 120V outlet, the power light" "on , press the

ON/OFF key “ ”for start, the machine supplies air at Heater high“ ” after start,

the Heater high light “ ”on.The digital screen displays the current set temperature,

and the set temperature defaults to the maximum temperature 95

°F that can be set.

Press the key “ ” to set the function of the machine. Repeat the “ ” key, the machine

cycles through the functions of Heater high“ ”, Heater low “ ”, Fan high “F2”, Fan

low “F1”.

Temperature setting

If the machine is in the Heater low ” ” and the Heater high “ ” , press " " can set the

temperature value,set the range of 45-95

°F

.When the room temperature exceeds the

set temperature at 4

°F

, the machine stops working, and stay in the standby state.

When the temperature is lower than the set temperature, the machine starts to heat

up again.

2.In the start state, when machine internal temperature exceeds the threshold of the

thermal cut-off, the machine will stop working, the digital screen and lamp will go out,

press any key will not work, pull off the plug manually and then insert it into the

receptacle again when the machine is cooled.

MAIN TECHNOLOGY SPECIFICATIONS

MODEL Fan low

(F1)

Fan high

(F2) ( ) ( )

POWER REGULATION RANGE (W)

PFH15A2BGB20 30

Power supply: AC 120V ~ 60Hz

Heater low Heater high

600 1500

Troubleshooting

If the product does not operate or does not operate properly, first check according to the following

list. If the reason the product does not operate or does not operate properly is not included in the

following list, the product mayhave failed. At this time, it is recommended to send the product to

the dealer for treatment.

Problem Possible Cause Solution

After the power is

engaged,the machine does

not work.

The plug may not be

plug ged well.

Check whether the plug is

properly inserted intothe

receptacle.

The machine suddenly

stops during heating.

The temperature exceeds

the threshold of the

thermal cut- o .

and then insert it into the

receptacle again when the

machine is cooled.

CLEANING AND STORAGE

It is recommended that the heater be cleaned at least one time during the operating season in

order to provide the optimum level of performance. ALWAYS TURN THE POWER SWITCH

OFF AND UNPLUG THE HEATER BEFORE CLEANING. Be sure to save the box for off-

season storage.

Turn the heater “OFF”, unplug it and wait for the heater to cool down.

Use a dry cloth to clean only external surfaces of the heater.

Do not use any cleaning agents or detergents.

Never immerse the heater in water.

Pack the heater in the original carton and store it in a cool and dry place.

Table of contents

Other Pelonis Heater manuals

Pelonis

Pelonis HO-0203D User manual

Pelonis

Pelonis HO-201 User manual

Pelonis

Pelonis HO-0221 User manual

Pelonis

Pelonis PTH15A2BGB User manual

Pelonis

Pelonis HT-0605 User manual

Pelonis

Pelonis NTH15-17MR User manual

Pelonis

Pelonis NF15-9BMB User manual

Pelonis

Pelonis HC-1010 User manual

Pelonis

Pelonis HF-0063 User manual

Pelonis

Pelonis PSH20Q3ABB User manual

Pelonis

Pelonis PSH08F1ABBC User manual

Pelonis

Pelonis HF-0055 User manual

Pelonis

Pelonis PHTPU1501WC User manual

Pelonis

Pelonis NTY15-16LA User manual

Pelonis

Pelonis 1500W-II User manual

Pelonis

Pelonis PHT30D7BBC User manual

Pelonis

Pelonis HB-211 User manual

Pelonis

Pelonis PHTPU1501 User manual

Pelonis

Pelonis NTK15A User manual

Pelonis

Pelonis PSH700R User manual

Pelonis

Pelonis HC-0125D User manual

Pelonis

Pelonis PSH23FT3DSBC User manual

Pelonis

Pelonis HF-0060 User manual

Pelonis

Pelonis NT15-13L User manual

Popular Heater manuals by other brands

oventrop

oventrop Regucor Series quick start guide

Blaze King

Blaze King CLARITY CL2118.IPI.1 Operation & installation manual

ELMEKO

ELMEKO ML 150 Installation and operating manual

BN Thermic

BN Thermic 830T instructions

KING

KING K Series Installation, operation & maintenance instructions

Empire Comfort Systems

Empire Comfort Systems RH-50-5 Installation instructions and owner's manual

Well Straler

Well Straler RC-16B user guide

EUROM

EUROM 333299 instruction manual

Heylo

Heylo K 170 operating instructions

Eterna

Eterna TR70W installation instructions

Clarke

Clarke GRH15 Operation & maintenance instructions

IRSAP

IRSAP The Radiator Company Ovali Fitting instructions

Empire Heating Systems

Empire Heating Systems WCC65 Installation and owner's instructions

Wetekom

Wetekom 92 86 43 Original instructions

Desa

Desa SPC170-F owner's manual

Watlow

Watlow Watrod Electric Tubular Heaters Specifications

Haverland

Haverland ECO-DRY GPS Series Instruction & installation manual

Stelpro

Stelpro ASILVC2060 Series user guide