Panasonic ES-RC50 User manual
Operating Instructions
使用說明書
사용 설명서
(Household) Rechargeable Shaver
（家用 ) 充電式 刮鬍刀
( 가정용 ) 충전식 면도기
Model No.
型號
모델 번호
ES‑RC50
Before operating this unit, please read these instructions completely and save them for future use.
使用本產品前，請仔細閱讀此說明書，並妥善保存以備未來使用。
이 기기를 사용하기 전에, 이 사용 지침서를 잘 읽고 다음을 위해 보관하십시오.
English 2
中文 7
한글 11
ES-RC50_ASIA.indb 1 2011/10/03 20:09:25
4
English
Clean
Cleaning the shaver
1. Remove the shaver from the AC adaptor.
2. Apply some hand soap and some water
to the outer foil.
3. Turn the shaver on.
4. Turn the shaver off after 10‑20 seconds.
5. Remove the outer foil section and turn
the shaver on.
6. Clean the shaver and the outer foil
section with running water.
7. Wipe off any drops of water with a dry
cloth.
8. Dry the outer foil section and the shaver
completely.
9. Attach the outer foil section to the shaver.
Shave
Using the shaver
1
1Slide the power
switch upwards.
The switch on lamp
glows blue.
•
2
2Hold the shaver as
illustrated above and
shave.
Adequate ambient temperature for using is 0‑40 °C. If you use
the appliance in temperature outside of the recommended range,
it may stop functioning.
Start out shaving by applying gentle pressure to your face.
Stretch your skin with your free hand and move the shaver back
and forth in the direction of your beard.You may gently increase
the amount of pressure as your skin becomes accustomed to
this shaver. Applying excessive pressure does not provide a
closer shave.
•
ES-RC50_ASIA.indb 4 2011/10/03 20:09:26
5
English
After washing, water remaining on the switch on lamp may
reduce the lamp brightness, but this is not a malfunction.
Cleaning with the brush
Clean the inner blades using the short brush
by moving it in direction (A).
Clean the outer foil and the shaver body using
the long brush.
Do not move the short brush in direction (B)
as it will damage the inner blades and affect
their sharpness.
Do not use the short brush to clean the outer
foils.
•
•
Replacing the outer foil and the inner blades
outer foil once every year
inner blades once every two years
Replacing the outer foil
1. Press the foil frame release button and lift the
outer foil section upwards as illustrated.
1
2. Press the system outer foil release button and
pull down the system outer foil as illustrated.
3. Insert the system outer foil until it clicks.
Always insert the system outer foil to the foil
frame when attaching to the shaver.
•
Replacing the inner blades
1. Press the foil frame release button and lift the
outer foil section upwards.
1
2. Remove the inner blades one at a time.
Do not touch the edges (metal parts) of the
inner blades to prevent injury to your hand.
3. Insert the inner blades one at a time until they
click.
•
Replacement parts
Replacement parts are available at your dealer or Service Center.
Replacement parts for
ES‑RC50
Outer foil WES9863
Inner blades WES9064
ES-RC50_ASIA.indb 5 2011/10/03 20:09:26
6
English
Specifications
Power source See the name plate on the AC adaptor.
Motor voltage 1.2 V DC
Charging time Approx. 8 hours
This product is intended for household use only.
Removing the built-in rechargeable battery
Remove the shaver from the AC adaptor when removing the
battery.
For environmental protection and recycling of materials
This shaver contains a Nickel-Metal Hydride battery.
Please make sure that the battery is disposed of at an officially
assigned location, if there is one in your country.
•
ES-RC50_ASIA.indb 6 2011/10/03 20:09:26
Perform steps to and lift the battery, and then remove it.•
Remove the built-in rechargeable battery before disposing of the
shaver.
The battery is to be disposed of safely.
Please make sure that the battery is disposed of at an officially
designated location if there is one. Do not dismantle or replace the
battery so that you can use the shaver again. This could cause fire
or an electric shock. Replace it at an authorized service center.
•press the power switch to turn on the power and then keep the
power on until the battery is completely discharged.
•Insulate the ⊕and ⊖terminals by applying tape to them.
(To prevent short circuit of terminals).
8
中文
部件說明
A保護蓋
B外層網面部分
1網層
2外層網面
3拆除外層網面的按鈕
C內層刀片
D主體
4網層拆除按鈕
5電源開關 [0/1]
6電源開關指示燈
7充電插座
E電源供應器 (RE7‑62)
8電源線
9充電狀態指示燈
F輕便旅行袋
G清潔毛刷
充電
為刮鬍刀充電
若感覺刮鬍刀速度下降，請依下列方式進行刮鬍刀充電。
1
1關閉刮鬍刀電源，將它插入電源供應器
直到卡住為止，如圖所示。
2
2將充電器插入家居插座。
充電狀態指示燈亮起紅燈。
充電約 8 小時後完成。
充電狀態指示燈會持續亮燈，直到從家居電插座拔下充電器為止。
建議的充電環境溫度為 0‑40℃。在極低或極高的溫度下，電池可
能不會充電。
刮鬍刀第一次充電時或未使用超過 6 個月，充電狀態指示燈可能
不會亮起。如繼續保持連結，最後會亮起。
刮鬍
使用刮鬍刀
1
1將電源開關向上滑
動。
電源開關指示燈亮起藍
燈。
•
2
2依照上圖示握著刮鬍刀使
用。
適當的使用環境溫度為 0‑40℃。如果在超出建議範圍外的溫度下
使用本設備，它可能停止正常運作。
•
•
•
•
•
ES-RC50_ASIA.indb 8 2011/10/03 20:09:27
9
中文
8.讓外層網面部分和刮鬍刀完全乾燥。
9.把外層網面部分安裝至刮鬍刀。
清洗後，留在電源開關指示燈上的水份可能會降低指示燈的亮度，
但這不是故障。
以毛刷清潔
利用毛刷依著 (A) 方向來清潔內層刀片。
利用長刷來清潔外層網面和刮鬍刀機身。
切勿以 (B) 方向來使用短刷，因此舉會損耗內
層刀片，令刀片不鋒利。
切勿以短刷清潔外層網面。
•
•
更換外層網面及內層刀片
外層網面 每年一次
內層刀片 每兩年一次
將刮鬍刀輕輕按壓在您的臉上。以另一隻手按著皮膚，並以刮鬍
刀來回刮鬍。當您習慣了這力道後，可慢慢加壓。過度加壓未必
可刮得更徹底。
清潔
清洗刮鬍刀
1.從電源供應器上取下刮鬍刀。
2.在外層網面上塗抹一些肥皂和水。
3.打開刮鬍刀電源。
4.10‑20 秒後，關掉刮鬍刀。
5.取出外層網面部分並打開刮鬍刀電源。
6.用流水清潔刮鬍刀和外層網面部分。
7.用乾布擦去水滴。
ES-RC50_ASIA.indb 9 2011/10/03 20:09:27
Table of contents
Languages:
Other Panasonic Electric Shaver manuals
Panasonic
Panasonic ESLA63 User manual
Panasonic
Panasonic ER-SB40-K User manual
Panasonic
Panasonic ER2201 User manual
Panasonic
Panasonic ER-407 User manual
Panasonic
Panasonic ES-8056 User manual
Panasonic
Panasonic ES?RT81 User manual
Panasonic
Panasonic ES-SL41 User manual
Panasonic
Panasonic ES-SL33 User manual
Panasonic
Panasonic ES-ST37 User manual
Panasonic
Panasonic ES-RF41 User manual
Panasonic
Panasonic ES-WF61 User manual
Panasonic
Panasonic ES2235 User manual
Panasonic
Panasonic ES-RT87 User manual
Panasonic
Panasonic Smooth Operator ES-204 User manual
Panasonic
Panasonic ES-4001 User manual
Panasonic
Panasonic ES-SL10 User manual
Panasonic
Panasonic ER-CSF1 User manual
Panasonic
Panasonic ER-GN70 User manual
Panasonic
Panasonic ER-GY60 User manual
Panasonic
Panasonic ES-RF41 User manual
