Olympia electronics BS-655 User manual

OPTICAL SMOKE DETECTOR

18-30V DC

150µA for 50 sec

103 (diam.) x 48 (height) mm

0.120dB/m

Alarm LED

To panel / to external LED driver (BS-572)

20-30mA

IP20

EN 54-7

50µA

-10 to 60 C

Up to 95%

2 years

160gr.

TECHNICAL CHARACTERISTICS

BS-655

START UP POWER CONSUMPTION

STAND BY POWER CONSUMPTION

ALARM POWER CONSUMPTION

PRODUCED IN ACCORDANCE WITH

OPERATION TEMPERATURE RANGE

DEGREES OF COVER PROTECTION

OPERATION VOLTAGE

RELATIVE HUMIDITY

TYPICAL WEIGHT

EXTERNAL DIMENSIONS

GUARANTEE

SENSITIVITY

INDICATORS

OUTPUT

921655000_23_018

Page 1 from 2

GENERAL

Beforeinstallingthedetector, the user must read these instructions

carefullyandstorethismanualforfuture reference.

The detectorsBS-655werecreatedtoofferquickdetectionincase

offire.

They have two parts, one plastic base which is installed on the

ceiling and the main unit of the detector which is fastened to the

base by a simple turning to the right. The detectors have an

indication led which lights continuously in case of fire detection

until there is a reset signal from the panel. The indication led also

flashes every 4 sec to indicate good operation. These detectors

can cooperate with conventional fire alarm panels like BS-632 and

BS-636.

OPERATIONCHECK

The operation check can be done by spraying a small amount of

smokeinto the detector’schamber.You can use the special smoke

deviceA-752ofourcompany,orasimilardevice.

It is advised to conduct a good operation test every 6 months and

everytimethedetector positionischanged.

It is essential to have good air circulation inside the detector.

Therefore care must be taken so that the vents of the detector are

notcovered.

NOTE

The detectors must be placed in the ceiling on visible areas with no

side obstacles and away from sides with no air circulation or strong

aircurrentsandvapors.Eachdetectorcoversalmost50m andthe

distance between two detectors must not exceed 15m. Also the

detectors must be placed away from fluorescent tubes at least 50

cm.2

Thecablescrosssectionmustbefrom0.5to1.5mm .

ATTENTION!!

After the device is installed, care must be taken, so that the

detectorvents arenotblocked by anything(i.e. dust,paint).Failing

to do so will prevent the smoke particles to enter the detection

chamber.

After the installation, it is the sole responsibility of the

user to maintain the detector for good operation.

Certification

The optical smoke detector BS-655 is certified from

LPCB. Also LPCB controls the production under CPR

number:

ΚΟLINDROS

PIERIAS

60061

GREECE

BS-655

Optical smoke detector 0832

0832-CPR-F0122 95

EN-54-7

Thank you for your trust in our products.

Olympia Electronics - European manufacturer.

921655000_23_018

Page 2 from 2

1.Detachthedetectorfromit’sbasebyturningitanticlockwiseuntilthesidemarksarealigned.

2.Installthebasewiththeincludedmountingparts(point5).

3.Connectthepowercables(respecttopolarity)accordingtotheinstallationrequirements(figure1,2).

4.Placecarefullythedetector,soastoalignthesidemarksandturnitclockwisealltheway.

Powerthedeviceandafter3-5secondswillbereadytooperate.

CONNECTION

1.IN-OUT-L:It is connected to thezoneof the panelor tothe(IN-OUT-L)contact of the previous detector.

2.OUT+R:Itisconnectedtothenextdetector(IN+L) or if it is the last one to the terminalresistor.

3.OUT+R and-R:It is connected with BS-572.

4.IN+L:It is connected to thezoneof the panelor tothe(OUT+R)contact of the previous detector.

Mounting base

Figure 1.

-R

Installation procedure

Indication marks

Connection

with external

LED BS-572

Terminal

resistor

Figure 2

Connection

Youcanconnectupto30detectorsBS-655oneachzone.

Ifthepowerofthedetectorsisturnedoff,waitfor3-5secondsbeforeyouturnthepoweronagain.

From zone

of the panel

-R

WARRANTY

Olympia Electronics guarantees the quality, condition and operation of the goods. The period of warranty is specified in the official catalogue of

Olympia Electronics and also in the technical leaflet, which accompanies each product. This warranty ceases to exist if the buyer does not

follow the technical instructions included in official documents given by Olympia Electronics or if the buyer modifies the goods provided or has

any repairs or re-setting done by a third party, unless Olympia Electronics has fully agreed to them in writing. Products that have been

damaged can be returned to the premises of our company for repair or replacement, as long as the warranty period is valid.

Olympia Electronics reserves the right to repair or to replace the returned goods and to or not charge the buyer depending on the reason of

defection. Olympia Electronics reserves the right to charge or not the buyer the transportation cost.

HEAD OFFICE

72nd km. O.N.R. Thessaloniki-Katerini

P.C. 60061 Greece

www.olympia-electronics.gr

[email protected]

Indication

LED

Table of contents

Other olympia electronics Smoke Alarm manuals

olympia electronics

olympia electronics BSR-6157 User manual

olympia electronics

olympia electronics BSR-6055/A/MAR User manual

olympia electronics

olympia electronics BS-506/ALKALINE User manual

olympia electronics

olympia electronics BSR-6155/MAR User manual

olympia electronics

olympia electronics BS-655/A User manual

olympia electronics

olympia electronics BSR-6055/A Operator's manual

olympia electronics

olympia electronics BS-506/LITHIUM User manual

olympia electronics

olympia electronics BS-655 User manual

olympia electronics

olympia electronics BSR-6055 User manual

olympia electronics

olympia electronics BS-116 User manual

olympia electronics

olympia electronics BSR-6057/A/MAR User manual

olympia electronics

olympia electronics BS-657 User manual

olympia electronics

olympia electronics BS- 655/A User manual

olympia electronics

olympia electronics BS- 657/A User manual

olympia electronics

olympia electronics BSR-6155 User manual

Popular Smoke Alarm manuals by other brands

x-sense

x-sense SD19-W user manual

BRK electronic

BRK electronic First Alert P1010 quick start guide

FireAngel

FireAngel Thermoptek ST-622 user manual

teko

teko Astra-42A user guide

Safetec

Safetec SDS-2/6 Additional Fault Finding Instructions

Siemens

Siemens PE-11C installation instructions

System Sensor

System Sensor DH500ACDC Installation and maintenance instructions

Resolution Products

Resolution Products RE612 CryptiX quick start guide

First Alert

First Alert PC900V user manual

Eminent

Eminent EM6590 E-Domotica user manual

Ei Electronics

Ei Electronics Ei Ei168RC user manual

Carrier

Carrier Kidde Quell Q301 user manual

VESDA

VESDA VLF-500 Product guide

ELRO

ELRO FS8110 instruction manual

Heiman

Heiman SMOKI NS-626PHS user manual

Regin

Regin SDD-S65 instruction manual

Family Gard

Family Gard FG225 user manual

Greystone

Greystone DSD120 Installation and maintenance instructions