Nyce Control NCZ-3041 User manual
How to Install a
NYCE Control Motion Sensor
STEP 1: INSTALL BATTERY
To open the
battery cover, use
a flathead
screwdriver in the
recessed slot as
shown.
Remove the packing tape, if
present, from the battery
cover and install the CR2
battery with polarity as
shown.
STEP 2: INSTALL DRIVER + IDENTIFY
Install the device’s driver:
Driver is named: DriverWorks_HA_Profile_MSensor.c4i
Download driver from: www.nycecontrol.com/support
or from Control4’s online database
Copy driver to My Documents\Control4\Drivers
Open Composer and add device to project
(Manufacturer = “Nyce Control”)
Identify the device by pressing the button 4 times while
its identify window is open.
The device’s 64-bit address should appear in the
identify window’s text box.
STEP 3: VERIFY DEVICE + CLOSE
Verify the device is sensing
motion.
The red LED should flash and
motion should be indicated in
Navigator’s and Composer’s
List View.
Snap the battery cover into
place.
Please visit our website if you have any installation questions www.nycecontrol.com/support
STEP 4: PLACEMENT GUIDELINES
STEP 5: INSTALL MOTION SENSOR
READING & WRITING ATTRIBUTES
To Read:
In Composer, under the Actions tab, click on
Read Attributes.
Wake up device with a double button press.
Check updated attribute value under the
Properties tab. The Attributes Status field
should read: “Attributes are up to date”.
To Write:
In Composer, change the attribute value (4-
65534 seconds) under the Properties tab
and click Set.
Under the Actions tab, click on Write
Attributes.
Wake up device with a double button press.
Check the Occupancy Attributes Status. It
should read: “Attributes are up to date”.
Install the Motion Sensor on a clean
surface using the 2-sided tape
provided.
The Motion Sensor can be installed on
a flat surface or in a corner.
It can be installed vertically,
horizontally or upside down.
Orient the Motion Sensor to best use
of its detection zones.
*all measurements are approximate
PRODUCT FUNCTION + LED INDICATORS
BUTTON AND LED LOCATION
Button Press
LED w/Press
Action
LED Action
Description
2 Times
Network Status
Not Joined
Joined
4 Times
Network Join
Join Successful
Join Unsuccessful
6 Times
Network Leave
Leave Successful
10 Times
Restore Defaults
Leave (if joined) and
Defaults Restored
No Action
Unsupported Command
Network Error, retry
Device Busy
Normal Operation
Motion Detected
Other Nyce Control Accessories manuals
