Nokia BH-216 User manual

Nokia Bluetooth Headset BH-216

9215318

Issue 2.0

11 12

DECLARATION OF

CONFORMITY

Hereby, NOKIA

CORPORATION declares that

this BH-216 product is in

compliance with the

essential requirements and

other relevant provisions of

Directive 1999/5/EC. A copy

of the Declaration of

Conformity can be found at

http://www.nokia.com/

phones/

declaration_of_conformity/.

reserved.

Nokia, Nokia Connecting

People and the Nokia

Original Accessories logo

are trademarks or

registered trademarks of

Nokia Corporation. Nokia

tune is a sound mark of

Nokia Corporation. Other

product and company

names mentioned herein

may be trademarks or

tradenames of their

respective owners.

Reproduction, transfer,

distribution, or storage of

part or all of the contents in

this document in any form

without the prior written

permission of Nokia is

prohibited.

Bluetooth is a registered

trademark of Bluetooth

SIG, Inc.

Nokia operates a policy

of ongoing development.

Nokia reserves the right

to make changes and

improvements to any of the

products described in this

document without prior

notice.

To the maximum extent

permitted by applicable

law, under no

circumstances shall Nokia

or any of its licensors be

responsible for any loss of

data or income or any

special, incidental,

consequential or indirect

damages howsoever

caused.

The contents of this

document are provided "as

is". Except as required by

applicable law, no

warranties of any kind,

either express or implied,

including, but not limited

to, the implied warranties

of merchantability and

fitness for a particular

purpose, are made in

relation to the accuracy,

reliability or contents of

this document. Nokia

reserves the right to revise

this document or withdraw

it at any time without prior

notice.

The availability of

particular products may

vary by region. Please check

with your Nokia dealer for

details.

Export controls

This device may contain

commodities, technology or

software subject to export

laws and regulations from

the US and other countries.

Diversion contrary to law is

prohibited.

Introduction

With the Nokia Bluetooth

Headset BH-216, you can

make and answer calls

hands-free with your

compatible mobile device.

Read this user guide

carefully before using the

headset. Also, read the user

guide for the device that

you connect to the headset.

This product may contain

small parts. Keep them out

of the reach of small

children. The surface of this

device is nickel-free.

Bluetooth wireless

technology

Bluetooth wireless

technology allows you to

connect compatible devices

without cables. The headset

and the other device do not

need to be in line of sight,

but they should be within

10 metres (33 feet) of each

other. Connections may be

subject to interference

from obstructions, such as

walls, or other electronic

devices.

The headset is compliant

with the Bluetooth

Specification 2.1 + EDR

supporting the following

profiles: Headset Profile 1.1

and Hands-Free Profile

(HFP) 1.5. Check with the

manufacturers of other

devices to determine their

compatibility with this

device.

Get started

The headset contains the

following parts shown on

the title page: power key

(1), volume key (2), answer/

end key (3), earpiece (4),

indicator light (5), charger

connector (6), earloop (7),

and microphone (8).

Before using the headset,

you must charge the

battery and pair the

headset with a compatible

device.

Parts of the device are

magnetic. Metallic

materials may be attracted

to the device. Do not place

credit cards or other

magnetic storage media

near the device, because

information stored on them

may be erased.

Charge the battery

Before charging the

battery, carefully read

“Battery and charger

information”.

Warning: Use only

chargers approved

by Nokia for use with this

particular model. The use

of any other types may

invalidate any approval

or warranty, and may be

dangerous.

When you disconnect the

power cord of any

accessory, grasp and pull

the plug, not the cord.

1. Connect the charger to

a wall outlet.

2. Connect the charger cable

to the charger connector.

The red indicator light is

displayed during charging.

Charging the battery fully

may take up to 1 hour and

15 minutes.

3. When the battery is fully

charged, the green

indicator light is displayed.

Disconnect the charger

from the headset, then

from the wall outlet.

The fully charged battery

has power for up to 6 hours

of talk time or up to 160

hours of standby time.

To check the battery charge

when the headset is not

connected to a charger,

press the power key when

the headset is switched on.

If the indicator light is

green, the charge level is

sufficient. If the light is

orange, you may need to

recharge the battery soon.

If the light is red, recharge

the battery.

When the battery charge is

low, the headset beeps

every 5 minutes and the red

indicator light flashes.

Switch on or off

To switch on, press and hold

the power key for about 4

seconds. The headset beeps,

and the green indicator

light is displayed. The

headset tries to connect to

the last connected device.

To switch off, press and

hold the power key for

about 2 seconds. The

headset beeps, and the red

indicator light is briefly

displayed. If the headset is

not connected to a device

within about 30 minutes, it

switches off automatically.

Pair and connect the

headset

1. Ensure that your mobile

device is switched on

and the headset is off.

2. Press and hold the power

key (for about 6 seconds)

until the green indicator

light starts to flash quickly.

3. Within about 3 minutes,

activate Bluetooth

connectivity on the mobile

device, and set it to search

for Bluetooth devices.

4. Select the headset from

the list of found devices.

5. If necessary, enter the

passcode 0000 to pair

and connect the headset

to your device. In some

devices, you may need to

make the connection

separately after pairing.

When the headset is

connected to your device

and is ready for use, the

green indicator light

flashes slowly.

You can pair the headset

with up to eight devices,

but you can connect it to

only one device at a time.

To manually connect the

headset to the last used

device, switch the headset

off and on, or press and

hold the answer/end key for

about 2 seconds.

You may be able to set your

device so that the headset

connects to it

automatically. To activate

this feature in a Nokia

device, change the paired

device settings in the

Bluetooth menu.

Table of contents

Other Nokia Headset manuals

Popular Headset manuals by other brands

Sena

Sena SMH10 quick start guide

IASUS

IASUS Stealth IA-NT4-BASIC-BT manual

Sennheiser

Sennheiser EPOS ADAPT 230 user guide

Doro

Doro Flexus HS2005 user guide

GE 98971 datasheet

Hama

Hama 00184070 quick start guide

Plantronics

Plantronics Blackwire 3200 Series user guide

Blue Tiger

Blue Tiger Advantage PLUS user manual

Jawbone

Jawbone Icon user manual

Jabra

Jabra FR 20 user guide

Roxcore

Roxcore Flow A+ manual

Turtle Beach

Turtle Beach XP 510 user guide

Philips

Philips SHB6101 Specification sheet

Jabra

Jabra PRO 9460 Duo datasheet

HyperX

HyperX HyperX Cloud Flight manual

Bose

Bose MIE2 Mobile owner's guide

Jabra

Jabra Steel quick start guide

HyperX

HyperX cloud ii quick start guide