shown ;the network-join is allowed to last for one minute
and automatically shut down after one minute. If pressing the binding key and the
function button for 1 second again during the process of allowing the network-join
process, and the device will turn off the function.
3.6 Power, power, voltage, current switching display
In the power display interface, press the function button to switch to voltage (in volts),
current (in amps), power (in watts), and power (in kWh).
3.7 Restore factory settings
After the Z808B joins the network , it will save its assigned network address. If users
want to join a new network, users need to restore the device to the factory settings
first. Press and hold the bind button for 15 seconds ( icon flashes for 3 times). After
releasing the button, press the function button for 2 seconds to restore the factory
settings. The LCD value area display which means
that the factory reset is successful. The device automatically restarts, and the network
can be re-joined.
3.8 Erase power information
The power information detected by Z808B will be stored in the eeprom memory.
When the factory value is restored, the power information will not be erased. Users
can erase the power information by the following method. Press and hold the binding
key for 20 seconds ( icon flashes for 4 times). Release and press the function key
within 2 seconds. Z808B will erase power information and the power information is
displayed as 0, the LCD numerical display power information area , as shown in FIG.
.
