ML Accessories MLRCTM2 Instruction Manual

INSTALLATION & MAINTENANCE MANUAL

MLRCTM2

These instructions should be read carefully and retained after installation by the end user for

future reference and maintenance.

These instructions should be used to aid installation of the following product:

MLRCTM2

GENERAL INSTRUCTIONS

• This product must be installed in accordance with the latest edition of the IEE Wiring Regulations (BS7671)

and current Building Regulations. If in any doubt, consult a qualiﬁed electrician

• Please isolate mains prior to installation or maintenance

• Check the total load on the circuit (including when this luminaire is ﬁtted) does not exceed the rating of the

circuit cable, fuse or circuit breaker

• Please note the IP (Ingress Protection) rating of this product when deciding the location for installation

• This product is for indoor use only

• This product is Class I and must be earthed

• This product is IP44 rated

SAFETY

Note - If this product is being used in conjunction with an external PIR or sensor, please conﬁrm with the

manufacturer of the sensors that they are compatible with LED luminaires.

• Provide power to the required point of installation

• Remove the mirror from the base by unfastening the four screws on the sides

• Using the base as a template, mark the location for, and drill the ﬁxing holes ensuring not to infringe with any

gas/water pipes or electrical cables (see Fig. 1)

INSTALLATION

• Feed the mains cable through the rubber grommet on the rear of the ﬁtting to retain IP rating

• Ensuring the pullcord is at the bottom, secure the base to the surface using the screws, washers and wall

plugs provided

• Connect the luminaire to the mains supply ensuring the correct polarity is observed: L - Live (brown),

E - Earth (green/yellow), N - Neutral (blue)

• Refasten the mirror to the base ensuring to align the cut-outs for the shaver socket and pullcord

• Switch on and check for correct operation

Fig. 1

WARNING

This product must be disconnected from the circuit if subjected to any high voltage or insulation resistance

testing. Irreparable damage will occur if this instruction is not followed.

GENERAL

This product contains a light source of energy efﬁciency class D to Regulation (EU) No 2019/2015.

This product contains an LED light source and a control gear which can be replaced by a professional.

Clean with a soft dry cloth only, do not use aggressive cleaning products or solvents which may damage the

product. A glass cleaning solution may be used on the mirror surface.

This product is non-dimmable.

This product should be dismantled for disposal when it reaches the end of its life. Please see website for

dismantling instructions.

This product should be recycled in the correct manner when it reaches the end of its life. Check local authorities

for where facilities exist.

WARRANTY

This product has a warranty of 1 year from date of purchase. Failure to install this product in accordance with

the current edition of the IEE Wiring Regulations (BS7671), improper use, or removal of the batch code will

invalidate the warranty. If this product should fail within its warranty period, it should be returned to the place

of purchase for a free of charge replacement. ML Accessories does not accept responsibility for any installation

costs associated with the replacement product. Your statutory rights are not affected. ML Accessories reserve

the right to alter product speciﬁcation without prior notice.

DCJUL21_V1

ML Accessories Limited LU5 4LT

www.mlaccessories.co.uk

101

INTERNATIONAL

CONTACT DETAILS

INTERNATIONAL

CONTACT DETAILS

INTERNATIONAL

CONTACT DETAILS

Table of contents

Other ML Accessories Lighting Equipment manuals

ML Accessories

ML Accessories EA1 Series Instruction Manual

ML Accessories

ML Accessories NH023AW Instruction Manual

ML Accessories

ML Accessories T8LED Series Instruction Manual

ML Accessories

ML Accessories NH016W Instruction Manual

ML Accessories

ML Accessories AX CCT Instruction Manual

ML Accessories

ML Accessories OWALL1 Series Instruction Manual

ML Accessories

ML Accessories NCLB12 Instruction Manual

ML Accessories

ML Accessories OSPCKIT Instruction Manual

ML Accessories

ML Accessories SPIKE5S Instruction Manual

ML Accessories

ML Accessories FLP Series Instruction Manual

ML Accessories

ML Accessories RW6WW Instruction Manual

ML Accessories

ML Accessories LEDFRA1 Instruction Manual

ML Accessories

ML Accessories SHE1BEMP Instruction Manual

ML Accessories

ML Accessories TRIBCCW Instruction Manual

ML Accessories

ML Accessories OPRCDKIT Instruction Manual

ML Accessories

ML Accessories Knightsbridge LEDF24RGB Manual

ML Accessories

ML Accessories AC65118 Instruction Manual

ML Accessories

ML Accessories Knightsbridge SFPL Series Instruction Manual

ML Accessories

ML Accessories 5410A Instruction Manual

ML Accessories

ML Accessories WP15CTP Instruction Manual

ML Accessories

ML Accessories UNDKIT3WWW Instruction Manual

ML Accessories

ML Accessories MLBA6045 Series Instruction Manual

ML Accessories

ML Accessories ENM5C Instruction Manual

ML Accessories

ML Accessories TRLED14EM Instruction Manual

Popular Lighting Equipment manuals by other brands

Brizo

Brizo 8SP-MU-4 manual

LUCE&LIGHT

LUCE&LIGHT BROM 1.0 installation instructions

IKEA

IKEA BJÖRKSPIREA manual

Laserworld

Laserworld Evolution Series ES-400RGB manual

Alien

Alien RG STAR user manual

EuroLite

EuroLite LED B-40 user manual

Qazqa

Qazqa Suplux SL 3 Black 103062 instruction manual

Commercial Electric

Commercial Electric 54568141 Use and care guide

CREE LIGHTING

CREE LIGHTING 304 Series installation instructions

Goobay

Goobay 49867 user manual

ECOMAN ITALIA

ECOMAN ITALIA LED T8 instruction manual

Alkalite

Alkalite Krypton KT-81 user manual

Clas Ohlson

Clas Ohlson GU10 manual

DTS

DTS DELTA 10 F user manual

ring

ring Solar Steplight manual

One Stop Gardens

One Stop Gardens 57696 Owner's manual & safety instructions

Chauvet DJ

Chauvet DJ COREpar UV120 ILS user manual

SIREM

SIREM Swimeo A2 instructions