Miele DG 155-2 User manual

Installation instructions for the

DG 155

DG 155-1 / DG 155-2

Steam oven

To prevent accidents and

machine damage,

read these instructions

before installation or use.

05 229 050

M.-Nr.

General Notes. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 3

Appliance and cut out dimensions . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 4

Installation in tall cabinetry . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 4

Installation under a counter top . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 5

Installation above a Miele oven . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 6

Installing the oven . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 7

Securing the oven . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 7

Contents

Important - Save for the local electrical inspector's use

Installation

This equipment has not been de-

signed for maritime use or for use

in mobile installations such as aircraft

or recreational vehicles. However, un-

der certain circumstances it may be

possible for an installation in these ap-

plications. Please contact the nearest

Miele Dealer or the Miele Technical Ser-

vice Department with specific require-

ments.

This steam oven is designed for instal-

lation in cabinetry or beneath a counter

top.

Keep these installation instructions in a

safe place and pass them on to any fu-

ture user.

Illustrated dimensions are in millime-

ters. For converting to inches, use the

enclosed table.

General Notes

Installation in tall cabinetry

aSteam oven

bCabinet opening

cTerminal block

dOutlet or junction box. This should be accessible after the appliance has been

installed.

ePower supply cord

Appliance and cut out dimensions

916

22 22

716

116

916

456mm)

450mm)

595mm)

560-568mm)

330mm)

22mm)

min.330)

547mm)

447mm)

100mm)

15 16

22 22

716

Installation under a counter top

aSteam oven

bCabinet opening

cTerminal block

dOutlet or junction box. This should be accessible after the appliance has been

installed.

ePower supply cord

Appliance and cut out dimensions

min.370)

456mm)

595mm)

560-568mm)

447mm)

716

916

547mm)

916

330mm)

22mm)

116

22 22

450mm)

Installation above a Miele oven

aSteam oven

bCabinet opening

cTerminal block

dOutlet or junction box. This should be accessible after the appliance has been

installed.

ePower supply cord

gOven

Note:

The steam oven must be supported by ledges or shelving. It must not rest di-

rectly on top of the oven.

Appliance and cut out dimensions

550mm)

450mm)

593-595mm)

560-568mm)

330mm)

22mm)

min.330)

560mm)

547mm)

447mm)

580mm)

100mm)

15 16

116

22 22

116

22 22

116

13 16

456mm)

596mm)

595mm)

716

23 - 23

Securing the oven

After aligning the oven it must be se-

cured in position.

Open the oven door and using the sup-

plied screws g, secure it to the cabinet

through the holes on either side of the

vertical oven trim.

Installing the oven

All electrical work should be performed

by a licensed electrician, in strict accor-

dance with national and local safety

regulations and standards.

–Note to installer:

Please leave these instructions with

the consumer.

–Power supply:

Please check the dataplate for verifi-

cation of:

240 VAC; 60 Hz

15A, 240 V

L1, L2, Ground

Caution:

Disconnect main power supply be-

fore servicing. To reduce the risk of

electrical shock, make sure that the

appliance is properly grounded after

installation.

WA NING : THIS APPLIANCE

MUST BE G OUNDED

For USA only

The appliance is provided with 3 termi-

nal leads, 1 black wire (L1), 1 red wire

(L 2) and 1 green wire (GND) which

have to be connected to a dedicated

junction box. Connect the black wire to

L1, the red wire to L2 and the green

wire to GND.

ALSO SEE THE WI ING DIAG AM

P OVIDED WITH THE APPLIANCE.

For CDN only

The appliance is provided with 3 termi-

nal leads: 1 black wire, 1 red wire and 1

green wire which have to be connected

to a separate overcurrent protection de-

vice (fusebox or circuit breakers).

All hot wires (black and red) have to be

fused individually before connecting

them to the main power supply leads.

Use 15 Amp fuses or circuit break-

ers for appliances rated 240 VAC.

Connect black terminal wire to L1

(black) and red terminal wire to L2

(red). The green terminal wire (ground)

has to be connected directly to the

equivalent colored power supply leads.

All connections must be done in a

proper way.

ALSO SEE THE WI ING DIAG AM

P OVIDED WITH THE APPLIANCE.

Installing the oven

Other manuals for DG 155-2

Table of contents

Other Miele Oven manuals

Popular Oven manuals by other brands

Bosch

Bosch HVA531NS0 instruction manual

Electrolux

Electrolux EOF6P46X user manual

NEFF

NEFF B44S32 5GB Series instruction manual

Combi

Combi BLODGETT BC142GDS Specifications

AEG

AEG COMPETENCE 311704300 Installation and operating instructions

Falcon

Falcon DOMINATOR PLUS G3106 Series Servicing instructions

Rational

Rational SCC WE 61G installation manual

Smeg

Smeg DOSPA38X User manuals

Electrolux

Electrolux air-o-convect 20 GN 2/1 user manual

KHIND

KHIND OT50 instruction manual

Henny Penny

Henny Penny Smoker Box installation manual

Lang

Lang ECOD-AP Installation and operation instructions

AEG

AEG BEK455310M user manual

Frigidaire

Frigidaire FNGE90JGR user manual

Hotpoint

Hotpoint FE9 S831 JSH IX user manual

GE Advantium SCB2000 owner's manual

AEG

AEG DE401301DM user manual

DeLonghi

DeLonghi XA660 Directions for use