3
Remove the neck strap and attach the wrist strap before using the Waterproof Case underwater. Using the neck strap may
cause it to become wrapped around the neck and result in strangulation or other injuries.
Do not scratch the surface of the diffusion plate as this may prevent light from the fiash from being properly diffused.
The effctiveness of the diffusion plate may be impaired if the subject is too close to the camera.
Take care not to twisr it.
Attach the strap and diffusion plate included with the case.
1. Remove the waterproof seal as shown.Do not dig your fingernails into the seal,or pull on it forcibly.
2. Using a cotton swab,wipe off any debris in the mounting groove.
3. Apply a small amount(droplet)of grease to your fingertip, and evenly coat the entire surface of the waterproof seal.
4. Place the waterproof seal back in the seal moumting groove.
To ensure that the case remains watertight,you should replace the seal once a year.Please contact our company Customer
Support Help Desk for replacement seals.
Open the case,and apply silicom grease to the waterproof seal.
Remove the strap from the camera,and make sure the battery and memoty card are inserted.
Make sure the screen is facing outward,and then insert the camera into the waterproof case. You cannot shoot using the
viewfinder.
Insert the asmera into the case,then close it.
When in sea water:2 weights
When in fresh water:2 weights
Number of Separately Sold Waterproof Case Weights (WW-DC1)Recommended Mounting:
Using the Built-in flash
Do not attach any straps except for the ones included with the Waterproof Case.
3
Remove the neck strap and attach the wrist strap before using the Waterproof Case underwater. Using the neck strap may
cause it to become wrapped around the neck and result in strangulation or other injuries.
Do not scratch the surface of the diffusion plate as this may prevent light from the fiash from being properly diffused.
The effctiveness of the diffusion plate may be impaired if the subject is too close to the camera.
Take care not to twisr it.
Attach the strap and diffusion plate included with the case.
1. Remove the waterproof seal as shown.Do not dig your fingernails into the seal,or pull on it forcibly.
2. Using a cotton swab,wipe off any debris in the mounting groove.
3. Apply a small amount(droplet)of grease to your fingertip, and evenly coat the entire surface of the waterproof seal.
4. Place the waterproof seal back in the seal moumting groove.
To ensure that the case remains watertight,you should replace the seal once a year.Please contact our company Customer
Support Help Desk for replacement seals.
Open the case,and apply silicom grease to the waterproof seal.
Remove the strap from the camera,and make sure the battery and memoty card are inserted.
Make sure the screen is facing outward,and then insert the camera into the waterproof case. You cannot shoot using the
viewfinder.
Insert the asmera into the case,then close it.
When in sea water:2 weights
When in fresh water:2 weights
Number of Separately Sold Waterproof Case Weights (WW-DC1)Recommended Mounting:
Using the Built-in flash
Do not attach any straps except for the ones included with the Waterproof Case.
