LRS CurbAlert Manual
IInnttaallllaattiioonn,, WWaarrrraannttyy aanndd SSeerrvviiccee IInnffoorrmmaattiioonn
CurbAlert
Paging System Transmitter
I N S TA L L M A N U A L
Long Range Systems UK Ltd | Link House | Leek Road | Milton | Stoke on Trent | Staffordshire | ST2 7AH | 01782 537000
www.lrspagers.co.uk | www.pagers.co | www.hospitalpagers.co.uk
Table Of Contents
System Installation . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 2
Tools Require . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 2
Camera Installation . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 3
Selecting Camera Mounting Height . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 4
Basic Power Connections . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
Camera Signal Connections (Preferred Connection) . . . . . . . . . . . . . . . . . . . . . 5
Using a Laptop to a just the Curbsi e Camera . . . . . . . . . . . . . . . . . . . . . . . . . . . . 6
Live Vi eo Setup . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 6
Laptop Manual Network Setup . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 8
Network Signal Connections (Alternate Connection . . . . . . . . . . . . . . . . . . . . . 11
Configure System . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 12
General Proce ure . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 12
Setup System Screen . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 13
Network . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 13
Camera . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 13
Software Upgra e . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 13
Setup Paging Screen . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 14
Pagers . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 14
Setup Sche ule Screen . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 15
Manager Paging . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 15
Duty Paging . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 15
Zones Screen . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 16
Alert Zone Setup . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 16
Greet Zone Setup . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 17
Tuning Screen . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 18
Location Setting Screen . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 19
OEM TX Setup . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 20
Service Questions and Answers . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 21
Warranty . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 22
Long Range Systems 1CurbAlert User Manual
Long Range Systems 2CurbAlert User Manual
SYSTEM INSTALLATION
Tools Required
Generally many of these are items normally carrie by an installer. However this list shoul be consulte to
ensure specialty items are at the site.
Note: If possible a survey of the site prior to installation will assure the proper equipment is on
site.
• Laptop running Win ows 2000 or XP an LRS camera a justment software.
• Crossover cable (connecte to camera)
• CAT 5 cable on a reel (enough to o a 100-ft installation)
• CAT 5 crimping tool
• 18/2 speaker wire (enough to o a 100-ft installation)
• Surge Protector (in case an extra is nee e )
• Phillips Hea Screw river
• Wire Cutters/Strippers
• RJ-45 cable tester
• Volt-ohm Meter
• #8, #10 pan hea Phillips screws (assorte lengths)
• Wire Nuts an /or Electrical Tape
• Jeweler’s screw river kit.
• (2) Walkie Talkies or (2) cell phones
• La ers
• Con uit
• Drill with assorte bits (e.g., masonry bit or 12” long bit).
• OEM TX Kit
CAMERA INSTALLATION
Selecting Camera Mounting Heig t
1. Locate the 4 spaces a jacent to the buil ing that will be use for curbsi e viewing.
2. Determine the closest normal position of vehicles in the space. This is the Target area.
Note: Camera shoul align with the center of the
parking slots an have an unobstructe
view.
3. Measure the istance to the structure where the camera will be mounte (A).
4. Calculate the Require mounting height (B). Note: approximate mounting height can be calculate
using the following chart.
Mounting below 15 feet is not recommmen e
Note: This table is set for the minimum focus length for the camera. The zoom can be use to
exten the range.
Example: A is 30 feet. The camera can be mounte at any of the heights in the table (higher the bet-
ter) an zoome to a just for the target area.
TABLE GENIE
A
6 - 8 ft
8 - 10 ft
10 - 12 ft
Mounting Height
20 ft
19 ft
18 ft
A
12 - 14 ft
More then 14 ft
Mounting Height
16 ft
15 ft
Long Range Systems 3CurbAlert User Manual
BASIC POWER CONNECTIONS
1. Determine where monitor will be mounte .
2. Route AC source power to the monitor
3. Select the “To Go” parking area where the camera will be mounte .
4. Route 24 VAC source power to the camera housing fan an heater.
• Locate the wire at the camera housing marke 24VAC/15VDC.
• Splice a connecting wire to the 24VAC/15VDC power supply
• Splice the wire to the 24VAC/15VDC power supply
5. Route 24 VAC source power to the camera.
• Locate the wires at the camera housing marke 24VAC/15VDC.
• Splice connecting wires to the 24VAC/15VDC power supply
• Splice the wires to the 24VAC/15VDC connections at the power supply.
Note: The 24VAC Power Supply provi e for camera must be connecte positive-positive, neg-
ative-negative.
NOTICES:
• T e Surge protector must be mounted near t e MONITOR and all items s own are connected to it!
• T is is a touc screen monitor it must be accessible to t e users.
OFF
ON
Power Supplies
Surge Protector
Splice
Monitor
Camera
Heater/Fan
Splice
Extension Wire Suppied
by Installer
24VAC/15VDC
Parking Spaces
Long Range Systems 4CurbAlert User Manual
CAMERA SIGNAL CONNECTIONS (PREFERRED CONNECTION)
System is configure for crossover connection
1. Focus an a just camera fiel of view (See Cameral Installation page 2).
2. Route an connect crossover signal cable from the camera to the monitor.
3. Set up an test Monitor Alert parameters (see Configure System page 18).
NOTICE:
• Any junction boxes or cable routing must be sealed and weat er protected.
OFF
ON
Surge Protector
Camera
Cat 5 Coupler
Cat 5 Network Cable Supplie by Installer
Cat 5 Network Cable Supplie in Kit
Cat 5 Crossover Cable Supplied in Camera Housing
Parking Spaces
Monitor
Long Range Systems 5CurbAlert User Manual
Long Range Systems 6CurbAlert User Manual
Using a Laptop to adjust t e Curbside Camera
This is an OPTIONAL setup using a portable laptop computer. It allows an installer to a just the camera
while in the vicinity of the camera. The Laptop must be setup for using a crossover cable an the IP a ress
must be set to facilitate this function.
Note: The operating monitor an ra io communication can be use as an alternate metho of
a justing the camera
Live Video Setup
1. Locate the camera where it will be use an apply power.
2. Setup the laptop IP a ress on the computer being use for the a justment (see Laptop Manual
Network Setup on next page).
3. Connect the camera network output through the orange or re crossover cable from the camera
housing to the computer an apply power to the camera.
4. Open Internet Explorer Browser, select A ress: 192.168.0.100. The program opens with Network
Camera SNC-CS3N view.
5. Select Active X Viewer.
6. If the Active X warning appears, click on the warning to install Active X (passwor an user name
= a min).
Note: Check pop up bar if pop up blocker is active.
7. Install the Active X program.
Use Live Vi eo to a just camera.
8. When finishe with camera a justment, return Laptop to normal network mo e an connect cam-
era to system for final setup.
Long Range Systems 7CurbAlert User Manual
Long Range Systems 8CurbAlert User Manual
Laptop Manual Network Setup
C anging to Static
CAUTION: When changing the configuration, be ure to note the propertie BEFORE you make change
o that you can return the computer to it original configuration.
Note: This proce ure may vary slightly epen ing upon the version of Win ows being use .
1. From Settings Menu, select Local Area
Connection.
2. Select Properties.
3. Highlight Internet Protocol (TCP/IP) then select
Properties.
Note: Before changing, make note of the
TCP/IP properties of the local area
connection so they may be reset
when one.
4. Select “Use the Following IP a ress”
5. Set the manual properties as shown.
• IP A ress 192.168. 0 .254
• Subnet mask 255.255.255. 0
• Default Gateway 192.168. 0 .254
Optional Preferre DNS server
192.168. 0 .254
6. Select Okay until returne to normal isplay screen.
C anging to DHCP or preset Static
1. When a justments are complete, return lap-
top to normal settings.
Note: This proce ure may vary slightly e-
pen ing upon the version of Win-
ows being use .
2. From Settings Menu, select Local Area Con-
nection.
3. Select Properties.
4. Highlight Internet Protocol (TCP/IP) then se-
lect Properties.
Long Range Systems 9CurbAlert User Manual
Table of contents
Other LRS Transmitter manuals
Popular Transmitter manuals by other brands
Dejero
Dejero EnGo 3x manual
Rosemount
Rosemount 4600 Reference manual
Speaka Professional
Speaka Professional 2342740 operating instructions
trubomat
trubomat GAB 1000 instruction manual
Teledyne Analytical Instruments
Teledyne Analytical Instruments LXT-380 instructions
Rondish
Rondish UT-11 quick start guide
