Linksys WRT610N V1 User manual

Thank you for purchasing the 6dBi Antenna Mod Kit for your Linksys router. First we will show you how

to install the antennas for your router. Next we will provide you with a tool that will help test the

performance of your newly modified router.

WRT610N V1 Antenna Installation Instructions:

1. No soldering required

2. Open the unit. You can use a torque wrench (size T10) or the sharp end of a kitchen knife will

work(we don’t recommend this).

3. Remove the UFL antenna connectors. (If you use both 2.4 ghz and 5 ghz remove top one of each)

4. Now this part requires some patience.

5. Fitting your new UFL connectors into the little holes can take a little practice, and patience

6. So do this first: Practice removing the original UFL antenna cables and then putting them back on.

7. You will be attaching UFL cables to RED Antenna TX/RX (see images below for reference) if using

both bands, other wise use both TX/RX on either band.

8. Now you are ready to drill.

9. Detach the stock UFL cables and remove the board from the unit.

10. Mark on the unit with a pen or whatever where you want to drill.

11. Your mark should be just a fraction above center point so the RP-SMA adapter will clear the board.

<<Very important IF YOU DRILL TOO LOW THE BOARD WON’T CLEAR

12. Drill a smaller hole first with a smaller bit and then go ahead and finish the drilling with the 1/4" drill

bit.

13. You may want to get someone to help you hold the unit in place as you drill. Hold the unit vertically

on a solid service before drilling. Take your time. No hurry!

14. After drilling there will be a little plastic left around the inside hole that will need removing. Just use

a kitchen knife or other small knife to remove the plastic.

15. Attach the UFL cables and the RP-SMA Plugs and of course the 6dBi Antennas and you are set to go.

Do not remove any built in antennas.

Be sure the nut on the RP-SMA plug is nice and tight, otherwise your antennas will flop.

NOTE: When putting the case back together make sure none of the cables get pinched with screws.

You

can secure them in place by using clear tape.

Enjoy

WIFI Radar Scanner:

http://www.metageek.net/products/inssider/ (free download)

The WIFI Radar Scanner will show the signal strength of your router. We recommend using it before and

after installing the antennas to see the improvement of the signal strength. It can also show you which

antenna position and router location can give you the best signal. The closer to -0db the better the

signal, and the closer to -100db the worse.

Table of contents

Other Linksys Wireless Access Point manuals

Linksys

Linksys WAP2000 Operation manual

Linksys

Linksys WAP11 v2.2 User manual

Linksys

Linksys WAP11 - Instant Wireless Network Access... User manual

Linksys

Linksys WAP54GPE - Wireless-G Exterior Access Point User manual

Linksys

Linksys WAP51AB - Instant Wireless - Access Point Original operating instructions

Linksys

Linksys SPA400 Quick setup guide

Linksys

Linksys Instant Broadband Series Guide

Linksys

Linksys WAP54G - Wireless-G Access Point User manual

Linksys

Linksys WAP54G - Wireless-G Access Point Original operating instructions

Linksys

Linksys LAPAC2600 User manual

Linksys

Linksys Instant Wireles Series User manual

Linksys

Linksys WAP55AG - Wireless A+G Access Point User manual

Linksys

Linksys WAP54GPE - Wireless-G Exterior Access Point Operation manual

Linksys

Linksys Instant Broadband Series User manual

Linksys

Linksys WAP2000 Original operating instructions

Linksys

Linksys WAP55AG - Wireless A+G Access Point User manual

Linksys

Linksys LAPN600 User manual

Linksys

Linksys WAP54GPE - Wireless-G Exterior Access Point Operation manual

Linksys

Linksys WAP54G - Wireless-G Access Point User manual

Linksys

Linksys LAPN300 User manual

Linksys

Linksys WAP54G - Wireless-G Access Point User manual

Linksys

Linksys WAP51AB - Instant Wireless - Access Point User manual

Linksys

Linksys WAP200 Operation manual

Linksys

Linksys WAP11 - Instant Wireless Network Access... User manual

Popular Wireless Access Point manuals by other brands

D-Link

D-Link DWL-2100AP - AirPlus Xtreme G Quick installation guide

Ubiquiti

Ubiquiti NanoStation NSM2 quick start guide

Cisco

Cisco Aironet 1550 Series Getting started guide

Aruba

Aruba IAP-335 user guide

Advantek Networks

Advantek Networks AWN-AP-54MR user manual

IP-COM

IP-COM AP355 user guide

Buffalo

Buffalo AirStation WLA-L11G user manual

EnGenius

EnGenius EnStationACv2 user manual

D-Link

D-Link DAP-3662 Quick installation guide

xG Technology

xG Technology xMax CN1300 installation guide

Widelink

Widelink ezWave WAP-1100 Series user guide

Edimax

Edimax CAP1200 user manual

Ubiquiti

Ubiquiti LBE-5AC-Gen2 quick start guide

Aruba

Aruba AP-203R installation guide

LuXout Shades

LuXout Shades LUXSHADE MOTION manual

CreatComm

CreatComm TB5F user manual

SineDigital

SineDigital MW-1500AP(H) installation guide

TP-Link

TP-Link AP9650 V1 Quick installation guide