Lightolier 1102P1 User manual

1. FRAME-IN (FIG. A)

Fasten MOUNTING FRAME to wood joist. Line-up bottom edge of

ADJUSTABLE MOUNTING BAR with bottom of wood joist (Fig. E). Wire to

supply leads. White fixture lead to neutral supply lead. Black fixture lead

to hot (120V) supply lead. Bare fixture wire to supply ground. Use

wirenuts (local hardware items). Place all electrical connections in the J-

BOX. Attach J-BOX COVER onto J-BOX. (Use built-in Cable Clamp in J-

BOX for non-metallic sheathed cable (Romex) or armored cable (BX).)

NOTE:

1. ADJUSTABLE MOUNTING BARS are pre-assembled on long side

of MOUNTING FRAME for rigidity and ease of installation (Fig. E).

MOUNTING BARS must be removed and installed on narrow side

of MOUNTING FRAME if required. Locking screws are provided to

lock frame in a desired position. (Fig. F)

2. MOUNTING BARS can be extended to 24”. The MOUNTING

FRAME can be mounted off-center. CENTERING SLOTS are provid--

ed as guides to align adjacent frames.

3. For suspended ceilings, make certain that bottom of MOUNTING

FRAME is no higher than 1” above ceiling line and notched area

of ADJUSTABLE MOUNTING BARS are positioned on top of

T-BAR (Fig. G).

2. CLOSE-IN (FIG. B)

Install plasterboard or other dry type ceiling. Hole in board can be cut

either on floor or after the board is secured in the ceiling. Use MOUNT-

ING FRAME opening as cutting guide (make sure ROTO CLIPS are rotated

out of hole area). ROTO CLIPS can only be rotated counter-clockwise. A

lanced stop detail is provided to prevent ROTO CLIPS from rotating clock-

wise. This detail allows easy removal of REFLECTOR TRIM by rotating

TRIM counterclockwise and permits installing REFLECTOR TRIM tightly

against the ceiling surface by rotating TRIM clockwise after pushing

TRIM into ceiling.

NOTE: For wet plaster ceiling, use Plaster Ring Accessory (order sepa-

rately): No. 1960 for 1002P1 Frame-In Kit; No. 1961 for 1102P1 Frame-In

Kit.

3. SNAP-ON (FIG. C) SEE SEPARATE REFLECTOR TRIM

4. PUSH-UP (FIG. D) INSTRUCTION SHEETS.

READ AND UNDERSTAND THESE INSTRUCTIONS BEFORE INSTALLING FIXTURE.

This fixture is intended for installation in accordance with the National Electrical Code and local or Federal

code specifications. To assure full compliance with codes and regulations, check with your local electrical

inspector before installation. To prevent electrical shock, turn off electricity at fuse box before proceeding.

Retain these instructions for maintenance reference.

INSTRUCTION SHEET NO.

IS:1102P1

A0403 Page 1 of 2

INSTALLATION PROCEDURE FOR FRAME-IN KIT 1102P1

(MAY BE USED FOR EITHER 7•11 OR LYTECASTER TRIM)

NEW CONSTRUCTION

LIGHTOLIER a GENLYTE THOMAS company.

631 Airport Road, Fall River, MA 02720

FIG. A

1. FRAME-IN

FIG. B

2. CLOSE-IN

FIG. C

3. SNAP-ON

FIG. D

4. PUSH-UP

WARNING-(RISK OF FIRE) DO NOT INSTALL INSULATION WITHIN 3 INCHES OF FIXTURE SIDES OR WIRING

COMPARTMENT, NOR ABOVE FIXTURE IN SUCH A MANNER TO ENTRAP HEAT.

1. CUT OPENING (FIG. A)

Use MOUNTING FRAME opening as template.

2. WIRE-IN (FIG. B)

Wire to supply leads. (Use built-In Cable Clamp in J-Box for non-

metallic sheathed cable (Romex) or armored cable (BX)).

3. PUT THROUGH (FIG. C)

a. Remove ADJUSTABLE MOUNTING BARS.

b. Break off BRIDGE on MOUNTING FRAME as shown in FIG. G

(break WEBS on SLOTS with cutting plier).

c. Pass MOUNTING FRAME into CEILING as shown.

4. ANCHOR (FIG. D)

a. Using NAIL CLIPS, (order separately; Cat. #1985N for 1002

Frame-In Kit, Cat. #1985S for 1102 Frame-In Kit).

5. SNAP-ON (FIG. E)

6. PUSH-UP (FIG. F)

INSTRUCTION SHEET NO.

IS:1102P1

A0403 Page 2 of 2

INSTALLATION PROCEDURE FOR FRAME-IN KITS

1002P1 & 1102P1 EXISTING CONSTRUCTION

LIGHTOLIER a GENLYTE THOMAS company.

631 Airport Road, Fall River, MA 02720

WARNING-USE ONLY REFLECTOR TRIMS PROVIDED BY LIGHTOLIER INC. USE OF OTHER MANUFACTUR-

ERS’REFLECTOR TRIMS VOIDS THE UNDERWRITERS LABORATORIES LISTING AND COULD CONSTITUTE

A FIRE HAZARD.

SEE SEPARATE REFLECTOR TRIM

INSTRUCTION SHEETS.

FIG. A

1. CUT-OPEN

FIG. B

2. WIRE-IN

FIG. C

3. PUT THRU

FIG. D

4. ANCHOR

FIG. E

5. SNAP-ON

FIG. F

6. PUSH-UP

Table of contents

Other Lightolier Light Fixture manuals

Lightolier

Lightolier Lytespan 6170 User manual

Lightolier

Lightolier Lytecaster 300XTC User manual

Lightolier

Lightolier Lytecaster 1179M1 User manual

Lightolier

Lightolier ProSpec 26036 User manual

Lightolier

Lightolier SIS2GPF228 User manual

Lightolier

Lightolier Lytespan 8119 User manual

Lightolier

Lightolier Calculite ProSpec PA4P3810 User manual

Lightolier

Lightolier Coffaire II CFA2GPF217 User manual

Lightolier

Lightolier 22SS2 User manual

Lightolier

Lightolier Calculite ProSpec PA1A7050 User manual

Lightolier

Lightolier Lytespan 8171WH User manual

Lightolier

Lightolier Lytespan 8338 User manual

Lightolier

Lightolier Soli 48024ALU User manual

Lightolier

Lightolier Coffaire II CFH1GPF User manual

Lightolier

Lightolier D13 User manual

Lightolier

Lightolier Lytecaster 1101H User manual

Lightolier

Lightolier QVS2GPFOS232 User manual

Lightolier

Lightolier STA 1'x4' 2 LAMP User manual

Lightolier

Lightolier QVS2GPFOS332 User manual

Lightolier

Lightolier WIRING OF AGILI-T FIXTURES Instructions for use

Lightolier

Lightolier Lytespan 9530 User manual

Lightolier

Lightolier VRB SERIES 1'x4 User manual

Lightolier

Lightolier PowerArc Modular spot reflector Guide

Lightolier

Lightolier Pristine Series User manual

Popular Light Fixture manuals by other brands

Emos

Emos CLASSIC ZY1431T manual

Westinghouse

Westinghouse Outdoor Lighting Fixture owner's manual

Hedler

Hedler C 12 silent Operation manual

Blizzard Lighting

Blizzard Lighting Puck: CSI manual 

Energetic Lighting

Energetic Lighting ELYSL-5004 Series installation instructions

Lightmaxx

Lightmaxx Shaft 5R user manual

Triarch

Triarch 31083 Assembly instructions

Philips

Philips 32614 Series user manual

IKEA

IKEA TIVED Assembly instructions

Chauvet Professional

Chauvet Professional ROGUE R1 BEAM WASH user manual

Martin

Martin MAC 250 Krypton user manual

Cooper Lighting

Cooper Lighting Halo L3232E Specification sheet

Stageline

Stageline ODW-2410RGBW instruction manual

Light Sky

Light Sky Tornado Series user manual

ArtFox

ArtFox Beam 15R extreme manual

GLG

GLG multispot 330 user manual

Home Accents Holiday

Home Accents Holiday TY052-1924-1 Assembly instructions

SELF Electronics

SELF Electronics FLEX instruction manual