Lifetime 6424 Quick start guide

5/1/2006

VISIT THE LIFETIME WEB SITE:

WWW.LIFETIME.COM

30” Shed Extension Kit

MODEL #6424

ASSEMBLY

INSTRUCTIONS AND

OWNER’S MANUAL

Save this instruction in the event that the manufacturer has to be contacted for replacement parts.

For Assistance, including missing or broken parts,

Call Customer Service at:

1 (800) 225-3865

** Do Not Contact the Store **

INSTRUCTION #1012324

3/24/2006

VISIT THE LIFETIME WEB SITE:

WWW.LIFETIME.COM

Hillcrest

30” Shed Extension Kit w/ Window

MODEL #6424

ASSEMBLY

INSTRUCTIONS AND

OWNER’S MANUAL

Save this instruction in the event that the manufacturer has to be contacted for replacement parts.

INSTRUCTION #1005147

For Assistance, including missing or broken parts,

Call Customer Service at:

1 (800) 225-3865

** Do Not Contact the Store **

BEFORE BEGINNING ASSEMBLY

Identify and inventory all parts using the checklist boxes on the Parts List. Keep the

hardware bags and their contents separate. If any parts are missing, call our Customer

Service Department.

**A MINIMUM OF TWO ADULTS ARE REQUIRED FOR ASSEMBLY**

SAFETY INSTRUCTIONS

Failure to follow these safety instructions may result in serious injury or property damage. Proper and complete

assembly, use and supervision is essential for proper operation and to reduce the risk of accident or injury. A high probability

of serious injury exists if this display is not installed, maintained, or operated properly. • If using a ladder during assembly,

use extreme caution. Follow all warnings and cautions on the ladder carefully. • 2 people are required for assembly. •

Misuse could result in system failure. • If technical assistance is required, contact the manufacturer.

Most injuries are caused by misuse and/or failure to follow instructions.

PARTS LIST

ID Part # Description Qty

108 ZS10882 Wall Panel 1

125 ZS12582 Window Wall Panel 1

110 CB11099 Center Floor Panel 1

114 CB11480E Lower Roof Panel 2

117 CB11780C Center Roof Cap 1

AA CH08580 Skylight 1

AB AR02406 Roof Truss Channels 2

AC 1001866 Roof Truss Brace 1

AD ZS01006 Roof Support 2

AE ZS01200 Window 1

Hardware Bag [1005273]

TA 1001865 Truss Connector 1

TB BB04500 Threaded Rod 1

TD BN00300 1/4” Cap Nut 2

TE BN01600 #10 Cap Nut 6

TF BS06100 #10 x 3/8” Pan-Head Screw 8

TH BS07500 .25” x .625” Screw 45

TI BS05900 #10 x .5” Pan-Head Screw 6

TJ BW01200 #10-1” Fender Washer 6

TK 1007360 Window Latch 2

108

110

114

117

125

4 5

HARDWARE IS ACTUAL SIZE

(unless otherwise indicated)

1. 7/16” Wrenches (2)

2. 3/8” Wrenches (2)

3. #2 Phillips screwdriver or

Electric drill with pillips head

Tools and Materials

Required for Assembly

(Not Included)

TI TJ

TD TF TH

If you are Installing a New Shed

1. Check contents of boxes and compare to parts listed on the Parts List.

2. Follow instructions that came with your shed, but add extra ﬂoor panel, wall panels, Roof Cap

and Skylight at appropriate points in the assembly.

If you are Extending an Existing Shed

1. Remove any objects from back shelves.

2. Remove any shelves, pegboards, or other objects hanging on the last two Side Wall Panels on

either side.

3. Check contents of boxes and compare to parts listed on the Parts List.

4. Follow the steps in this manual.

5. If you are extending an 8’ x 5’ shed you will need to modify the following instructions by not

removing as many parts as shown in the illustrations.

a. Remove last three skylights.

a. Remove the back 3 roof caps.

a. Remove the back Roof panels and Roof support bars.

**Save all hardware for re-assembly!**

6 7

a. Remove the next Roof panels and Roof support bars.

a. Remove the Roof Truss.

a. Remove the last two Side Wall Panels.

a. Slide the back section of the shed away from the front. You

will need to tip the back section forward slightly in order to disconnect

the ﬂoor panels

Be sure that there is

nothing on the back

shelves before moving thie

back section.

One person should

support the back wall

while it is being tipped and

moved.

a. Add new ﬂoor panel. Then, slide the back section into place

and connect the ﬂoor panels (you will need to tip the panels forward

slightly to connect the panels).

a. Add Wall panels.

Insert a wood block directly

under the tab you want to

insert, then slide block to

next tab and repeat.

Tip up one ﬂoor panel and line up tabs

and then lay ﬂoor panel ﬂat.

a. Remove plastic sheeting from Window (AE) and slide Window

into slot on the Window Wall Panel (125).Attach a Window Latch (TK)

above each corner of the Window as shown. When tightening screws

(TH), be sure that Window Latches will slide freely. Do not overtighten.

Insert screw (TF) into the hole in the window. Set panel aside.

8Assemble Window TH

Insert window with bent edge

at top and pointing away from

the wall.

Place screw (TF) in this hole to keep

window from sliding up too far. Insert

until ﬂush with the window

10 11

b. Use Truss Connector (TA) to attach Roof Truss Channels at top. Secure with screws (TF) and nuts

(TE). Before completely tightening, lay assembly on its side to be sure Channels and Brace are parallel.

Completely tighten all hardware.

11 Assemble Truss

a. Attach Brace (AC) to two Roof Truss Channels (AB) (one on

each side of Brace. Secure Brace with screws (TF) and nuts (TE).

Be sure that Truss Connector

is aligned with the Truss

Channels.

Follow picture above to connect

Brace to a Truss Channel at each

end of the Brace.

The nut goes on

outside of the truss.

c. Slide a Threaded Rod through the Truss

Support Brace and the top of the Truss Connector. TD

d. Secure the top and bottom of the Threaded Rod with a 1/4” Cap Nut (TD).

12 13

a. Add Truss.

a. Add Roof panels and Roof

Supports.

b. Add a center Roof Cap.

Roof Panel Ridge

Roof Panel

Wall

a. Add Truss.

a. Add Roof panels and Roof

Supports.

b. Add a center Roof Cap.

14 15

b. Add the last Center Roof Cap and the End Roof Cap.

a. Add Roof panels and Roof

Supports.

a. Add Skylights

Congratulations on your Lifetime®Outdoor Shed purchase. By following the instructions

below, your new Lifetime shed should provide you with years of service and enjoyment.

Cleaning and Care

The polyethylene walls and shelves are stain- and solvent resistant. To clean, use a mild soap and a soft-bristled

brush. Abrasive cleaning materials may scratch the plastic and are not recommended. Repair scratches or rust

spots on the metal by Sanding the affected area lightly; using a rust preventative spray primer; and ﬁnally, spraying

with a high-gloss spray enamel paint. Avoid placing a direct heat source on or near surfaces unless using a heat

barrier.

For warranty details or to register your product, visit

www.lifetime.com or call 801-776-1532

Model #

0110 Corner Shelf (2 pack)

Two 10” radius shelves with hardware.

0130 32” Shelf Kit w/ hardware (3 pack)

Three 32” x 10” Steel-Reinforced Shelves with shelf brackets and

hardware.

0150 8’Shelf Kit w/ hardware

One 96” x 9” Steel-Reinforced Shelf with shelf bracket and hardware.

0170 Pegboard w/ hardware

One 22.5” x 22.5” Pegboard Panel with hooks. Great for hanging large

and small items such as: rakes, shovels, and hand tools.

0190 Shelf Support Channel

Two Shelf Support Channels that allow the 32” shelves on either of the

side walls of your shed.

Enhance your Lifetime®Outdoor Shed by purchasing the

following Shed Accessories:

Or call:

1 (800) 424-3865

To purchase shed accessories,

visit us at:

www.buylifetime.com

0110 0130 0150 0170

Other manuals for 6424

Table of contents

Other Lifetime Outdoor Storage manuals

Popular Outdoor Storage manuals by other brands

USP

USP DURAMAX 10 Ft x 8 Ft StoreMax Plus owner's manual

TYGO

TYGO Nyland Building Instruction

Duratuf

Duratuf GL105 Assembly instructions

Viking

Viking SD5300SS Use & installation guide

USP

USP DURAMAX Apex Pro 10.5 Ft x 8 Ft 40116 owner's manual

ModuLaro

ModuLaro Lojo WC202200 manual

rollaway container

rollaway container ARPCA24 manual

Duratuf

Duratuf Havelock Assembly instructions

X-METAL

X-METAL 4065 owner's manual

Outdoor Life Products

Outdoor Life Products FP2030 F Assembly instructions

Royalcraft

Royalcraft Faro 295L Storage Box Assembly instructions

Riverlea

Riverlea Duratuf KIWI KS3 Assembly instructions

OLT

OLT GS84D-FJ-Plywood Assembly manual

Rubbermaid

Rubbermaid 5L45 manual

garofalo

garofalo TUSCANY EVO user manual

Duratuf

Duratuf Kiwi MK1 Assembly instructions

Eden

Eden CA2988 Assembly instructions

Palram

Palram CANOPIA RUBICON 6x10 How to assemble