Lidén Weighing RWS User manual
Bench - & Floor scale
User manual
RWS
www.liden-weighing.com
Key Board
KEY
FUNCTION
Turn the power On/ Off
Used to reset to Zero. In setting mode can use to confirm entry
Used to recording tare values and change the value from gross value
to net value. Insetting mode can use to increase the value and scroll
forward in menu.
When the scale has been tared and display is in gross or net mode.
When using the settings mode, can use to move active digits right.
For print the results, to the PC or printer using the optional RS-232
interface. It also adds the value to the accumulation memory if the
accumulation function is not automatic. When using the settings
mode, can use to clear digits.
In settings mode, escape back to menu/ weighing mode and use to
move active digits left.
RWS 17-11-30 www.liden-weighing.com
Display
DISPLAY
FUNCTION
HI
OK
LOW
Check weighing
ZERO
Indicator for Zero display
TARE
Indicator for Tare display
GROSS
Indicator for Gross weight
NET
Indicator for Net weight
STABLE
Indicator for Display stability
AUTO
Indicator for Auto Accumulation
M+
Indicator for Accumulation
ANIMAL
Indicator for Animal Weighing Mode
HOLD
Indicator for Hold/ Lock
Indicator for Charging status of battery.
Operations
Initial Start – Up:
Warm-up time of 15 minutes stabilizes the measured values after switching on.
1. Power ON/OFF:
Switch on the balance by pressing key.
The display is switched on and the test is started and if want to switched off, press
again the key.
2. Zero
Environmental conditions can lead to the balance exactly zero in spite of the
platform not taking any strain. However, you can set the display of your balance to
zero any time by pressing key and therefore ensure that the weighing starts at
zero.
RWS 17-11-30 www.liden-weighing.com
3. Tare
The weight of any container can be tared by pressing button so that with
subsequent weighing the net weight of the object being weighed is always displayed.
•Load weight on the platform.
•Press key. Zero is displayed, and tare is subtracted.
•Remove weight on the platform. Tared weight is displayed. It can set only one tare
value. It can display with a minus value.
•Press G/N to change between gross weight and net weight.
•To clear the tare value, remove the load and press key. Zero is displayed,
tare weight is cleared.
4. Sample weighing
•Place goods to be weighed on the platform.
•Wait few seconds for stability display.
•Read the result.
•Avoid overloading. When display appears “ol” reduce the load or unload.
RWS 17-11-30 www.liden-weighing.com
Table of contents
Other Lidén Weighing Scale manuals
Lidén Weighing
Lidén Weighing LI-101 User manual
Lidén Weighing
Lidén Weighing LW-MKP User manual
Lidén Weighing
Lidén Weighing LUW-2000 User manual
Lidén Weighing
Lidén Weighing BW-0635 User manual
Lidén Weighing
Lidén Weighing ferax FAW User manual
Lidén Weighing
Lidén Weighing LEP-184 User manual
Lidén Weighing
Lidén Weighing Limit LBC User manual
Lidén Weighing
Lidén Weighing LUW2001/LBW User manual
Lidén Weighing
Lidén Weighing BW-0520 User manual
Lidén Weighing
Lidén Weighing BW-0365 User manual
