La Crosse Technology TX6 User manual

TX6U

Wireless 433 MHz

Temperature Sensor/Transmitter

Instruction Manual

QUICK SET-UP GUIDE

Hint: Use good quality Alkaline Batteries and avoid rechargeable batteries.

1. Have the indoor station and outdoor remote 3 to 5 feet apart.

2. Batteries should be out of both units for 10 minutes.

3. Place the batteries into the outdoor remote first then into the indoor station.

(All outdoor remotes must be started before the indoor station)

4. DO NOT PRESS ANY BUTTONS FOR 10 MINUTES.

In this time the display and sensor will start to talk to each other and the display will show both the indoor

temperature and an outdoor temperature. If the station does not display both temperatures after the 10

minutes please retry the set up as stated above. After both indoor and outdoor temperatures are displayed

for 10 minutes you can place your sensor outdoors and set your time.

The remote sensor should be placed in a dry, shaded area. The remote sensor has a range of 80 feet. Any

walls that the signal will have to pass through will reduce distance. An outdoor wall or window will have

20 to 30 feet of resistance and an interior wall will have 10 to 20 feet of resistance. Your distance plus

resistance should not exceed 80 ft. in a straight line.

NOTE: Fog and mist will not harm your remote sensor but direct rain must be avoided.

Battery Installation:

1. Remove the mounting bracket. The bracket snaps on and off easily.

2. Remove the battery cover, by sliding the cover down.

3. Observing the correct polarity install 2 AA batteries. The batteries will fit tightly (to

avoid start-up problems make sure they do not spring free).

4. Replace the battery cover by sliding upwards. Be sure battery cover is on securely.

MOUNTING THE REMOTE TEMPERATURE SENSOR/TRANSMITTER

The remote temperature sensor/transmitter can be mounted in two ways:

• with the use of screws, or

• using the adhesive tape.

A. MOUNTING WITH SCREWS

1) Remove the mounting bracket from the remote temperature sensor/transmitter.

2) Place the mounting bracket over the desired location. Through the three screw holes of the

bracket, mark the mounting surface with a pencil.

3) Where marked, start the screw holes into mounting surface.

4) Screw mounting bracket onto the mounting surface. Ensure that the screws

are flush with the bracket.

B. MOUNTING WITH ADHESIVE TAPE

1) With a nonabrasive solution, clean and dry the back of the mounting bracket

and the mounting surface to ensure a secure hold. The mounting surface

should be smooth and flat.

2) Remove the protective strip from one side of the tape. Adhere the tape to

the designated area on the back of the mounting bracket.

3) Remove the protective strip from the other side of the tape. Position the remote temperature

sensor/transmitter in the desired location, ensuring that the weather station can receive the signal.

Mounting

Bracket

SPECIFICATIONS

Temperature measuring range:

Outdoor: -21.8°F to 157.2°F with 0.2°F

resolution. (-29.9°C to 69.9°C

resolution) “OFL” displayed if

outside this range

Outdoor temperature checking

interval (remote temperature

sensor/transmitter):

Every 1 minute

Transmission Range: 80 feet (in open space)

Power Supply:

Temperature sensor/transmitter: 2 x AA, IEC LR6, 1.5V

Battery life cycle: Approximately 12 months

Recommended battery type: Alkaline

Dimensions (L x W x H)

Temperature sensor/transmitter: 1.57“ x 0.9“ x 5.04“

(40 x 23 x 128 mm)

WARRANTY INFORMATION

La Crosse Technology provides a 1-year warranty on this temperature sensor/transmitter. Contact La

Crosse Technology immediately upon discovery of any defects covered by this warranty.

Before sending the weather station in for repairs, contact La Crosse Technology. The temperature

sensor/transmitter will be repaired or replaced with the same or similar model.

This warranty does not cover any defects resulting from improper use, unauthorized repairs, faulty

batteries, or the temperature sensor/transmitter’s inability to transmit a signal due to any source of

interference.

LA CROSSE TECHNOLOGY WILL NOT ASSUME LIABILITY FOR INCIDENTAL,

CONSEQUENTIAL, PUNITIVE OR OTHER SIMILAR DAMAGES ASSOCIATED WITH THE

OPERATION OR MALFUNCTION OF THIS WEATHER STATION. THIS PRODUCT IS NOT TO BE

USED FOR MEDICAL PURPOSES OR FOR PUBLIC INFORMATION. THIS PRODUCT IS NOT A

TOY. KEEP OUT OF CHILDRENS’ REACH.

This warranty gives you specific legal rights. You may also have other rights specific to your state. Some

states do no allow the exclusion of consequential or incidental damages therefore the above exclusion of

limitation may not apply to you.

For warranty work, technical support or information contact:

La Crosse Technology

1116 South Oak Street

La Crescent, MN 55947

Phone: 507.895.7095

Fax: 507.895.8000

e-mail: [email protected] (warranty work)

[email protected] (information on other products)

web: www.lacrossetechnology.com

FCC ID: OMO-01TX

THIS DEVICE COMPLIES WITH PART 15 OF THE FCC RULES. OPERATION IS SUBJECT TO THE FOLLOWING

TWO CONDITIONS:

1. THIS DEVICE MAY NOT CAUSE HARMFUL INTERFERENCE, AND

2. THIS DEVICE MUST ACCEPT INTERFERENCE RECEIVED, INCLUDING INTERFERENCE THAT MAY CAUSE

UNDESIRED OPERATION.

This manual suits for next models

Table of contents

Other La Crosse Technology Accessories manuals

La Crosse Technology

La Crosse Technology TX7U User manual

La Crosse Technology

La Crosse Technology TX-63U-IT User manual

La Crosse Technology

La Crosse Technology LTV-R1 User manual

La Crosse Technology

La Crosse Technology La Crosse Alerts TX60U-IT User manual

La Crosse Technology

La Crosse Technology TX8U User manual

La Crosse Technology

La Crosse Technology LTV-R3 User manual

La Crosse Technology

La Crosse Technology D000.104 User manual

La Crosse Technology

La Crosse Technology CYCLONE PRO SENSOR User manual

La Crosse Technology

La Crosse Technology BREEZE PRO SENSOR User manual

La Crosse Technology

La Crosse Technology TX191 User manual

La Crosse Technology

La Crosse Technology TX15U User manual

La Crosse Technology

La Crosse Technology TX12U User manual

La Crosse Technology

La Crosse Technology TX141TH-BV4 User manual

La Crosse Technology

La Crosse Technology TX145R User manual

La Crosse Technology

La Crosse Technology TX9U User manual

La Crosse Technology

La Crosse Technology LTV-THP1-T1 User manual

La Crosse Technology

La Crosse Technology TX60U-IT User manual

La Crosse Technology

La Crosse Technology TX141TH-BCHv3 User manual

La Crosse Technology

La Crosse Technology TX14RBL User manual

La Crosse Technology

La Crosse Technology WCLTV-WSDR1 User manual

La Crosse Technology

La Crosse Technology TX141-Bv2 User manual

La Crosse Technology

La Crosse Technology TX23U User manual

La Crosse Technology

La Crosse Technology 925-1418 User manual

La Crosse Technology

La Crosse Technology LTV-R2 User manual

Popular Accessories manuals by other brands

Hillco

Hillco 2810 Operator's manual

Siemens

Siemens QSA2700D Basic documentation

Contours

Contours ZY024 manual

Saivod

Saivod VS621 manual

Virtuox

Virtuox VirtuCLEAN 2.0 user manual

SCE

SCE ENVIRO-THERM SCE-TE170B24VSS user manual

Z-Wave

Z-Wave HSD-200Z user manual

turck

turck FMX-IM-2UPLI63FX quick start guide

Decagon Devices

Decagon Devices 10HS manual

UPPAbaby

UPPAbaby Cup Holder user manual

Elko

Elko SmartSensor Leakage Wireless manual

Grizzly

Grizzly H8371 instructions

Panasonic

Panasonic HG-T Series user manual

IFM Electronic

IFM Electronic Efector 250 Series Brief instructions

DigiDesign

DigiDesign 888/24 I/O installation guide

PROZIS

PROZIS QUAY user manual

patagonia

patagonia PSI Vest user manual

SFC Energy

SFC Energy EFOY GO! manual