KBS CD 290 User manual

www.kbs-gastrotechnik.de

Stand Juli 2018

BEDIENUNGSANLEITUNG

Glastürkühlschrank

CD 290

KBS Gastrotechnik GmbH - Johannes-Kepler-Str. 14 - 55129 Mainz













CD290-1004, CD350-1003, CD350-1313, FKU 290 G

CD351, KSCD 350.1

CD350-311, CD350-1D, CD350







CD350-1004, CD350-2D, KS CD 350.2, CD350-2

SAFETY INSTRUCTIONS

Carefully read the Instruction manual! If instructions are not followed,

there is a risk of injury, damage of the appliance and loss of the right to

free warranty service. We recommend to keep the Instruction manual the

whole time you have the appliance. When you sell the appliance pass the

Instruction manual to the new owner of the appliance.

WARNING!

–Do not cover the ventilation holes at the top and on the sides of the

appliance.

–Do not use any mechanical means or electrical devices to hasten the thawing

process when cleaning the freezer compartment.

–Do not use electrical appliances inside the food storage compartments of the

appliance, unless they are of the type recommended by the manufacturer.

–If the supply cord is damaged it must be replaced by the manufacturer, manufacturer

service agent or a similarly qualified person, in order to avoid a hazard.

–Disposal of the appliance should be according to national rules.

–Do not damage the appliance refrigeration system. It contains the refrigerant

gas R600a. If the refrigeration system is damaged:

Do not use any open flame.

Avoid sparks ―do not turn on any electrical devices or lighting

fixtures.

Immediately ventilate the room.

•The appliance should be used only for storing foodstuffs.

•This appliance is not designed for the storage of explosive substances such as

aerosol cans with a flammable propellant.

•It is prohibited to store petrol and other flammable liquids near the appliance.

CONNECTION TO THE MAINS

–The appliance must be plugged into an earthed electricity supply socket. The

earthed electrical socket by which the appliance is connected to the mains

should be in an accessible place.

–IF THE APPLIANCE IS PRODUCED WITH THE SPECIAL SUPPLY CORD

IT CAN BE EXCHANGED ONLY BY THE SAME SPECIAL SUPPLY CORD

PROVIDED BY THE MANUFACTURER.

–TO AVOID HAZARDS, DAMAGED POWER SUPPLY CORDS SHOULD

ONLY BE REPLACED BY THE MANUFACTURER, A MAINTENANCE

TECHNICIAN OR A PERSON WITH AN EQUIVALENT QUALIFICATION.

–DO NOT USE extension cords or connectors (adapters), or hubs.

–The frequency and power of the electricity supply must conform to the

general data parameters of the appliance as it is shown in the product label.

–When positioning the appliance be careful that the electrical cord isn’t

squeezed in order to avoid its damage. Do not store heavy objects such as

cooling devices, furniture or other devices next the appliance in such a way

that they could squeeze and damage the electrical cord. This can cause a

short circuit and a fire.

–Make sure that the plug of the electrical cord is not squeezed by the back

wall of the appliance or otherwise damaged. A damaged plug can be the

cause of a fire!

–WARNING! DO NOT OPEN THE COVER OF THE LED

ILLUMINATION. In case that LED illumination is used the service

representative must be contacted when the LED light is defected.

•IF THE APPLIANCE IS UNPLUGGED (FOR CLEANING, MOVING TO

ANOTHER PLACE, ETC.), IT MAY BE REPEATEDLY SWITCHED ON AFTER

15 MIN.

•It is forbidden to use a technically damaged appliance.

•The appliance can’t be disposed of by burning.

•Do not place any switched on electrical devices (such as microwave ovens,

hair dryers, irons, electric kettles or other electrical devices) on top of the

appliance because this may cause ignition of plastic parts.

•Do not place any dishes with liquids on top of the appliance and do not keep

flowers in vases or other liquid-filled vessels on the appliance.

•Do not climb on or sit on the appliance, do not lean on or hang on the

appliance doors.

IF THE APPLIANCE IS OUT OF ORDER AND IT IS NOT POSSIBLE TO

REPAIR IT BY MEANS OF GIVEN RECOMMENDATIONS, UNPLUG IT,

OPEN THE DOORS AND CALL THE SERVICE EXPERT. ONLY A SERVICE

REPRESENTATIVE CAN REMEDY ALL TECHNICAL OR CONSTRUCTION

FAULTS

GENERAL INFORMATION

The appliance is a vertical display cooler with glass doors and with a fan and is designed for

storage of foodstuffs and for chilling of drinks and for a short-term storage of them.

This ppl i nce is intended f or commerci l u se!

THE APPL ANCE S ECOLOG CALLY CLEAN, CONTA N NG NO MATER ALS HARMFUL TO THE

OZONE LAYER: the refrigerant used is R600a, the foaming agent used for the appliance insulation

is cyclopentane C

THE MANUFACTURER GUARANTEES REL ABLE OPERAT ON OF THE REFR GERATOR WHEN THE

AMB ENT TEMPERATURE S +16 TO +32 DEGREES CELS US AND THE RELAT VE A R HUM D TY

NOT GREATER THAN 60 PER CENT.

The appliance climate class is 3. nside temperature class – S (from –2 °C to +14 °C)

NOTE. The manufacturer reserves the right to make future changes to technical parameters and

specifications.

Model CD290-1004

FKU 290 G

CD350-1003/1004

KSCD 350.1/KS CD 350.2

CD350-1D/ CD350-2D

CD351, CD350, CD350-2

Refrigerator total gross volume, L 290 350

Refrigerator net volume, L 275 320

Dimensions (H x W x D), cm

145 x 60 x 60

173 x 60 x 60

Shelf area, dm

115 115

Average air temperature inside the

refrigerator, °C from 0 to +10

Rated current, A 1,5 1,7

Weight, kg 58 67

Voltage used

220 - 230V/50HZ

Rated input, W 200 230

Data according to requirements of standard EN SO 23953-2:2005

Product temperature ranges, °C from -2 to +14

Door opening area, m² 0,66 0,80

General product exposure area, m² 0,51 0,62 / 0,58

0,33 l 270 329

Loading of the refrigerator

quantity of bottles, pcs.

0,5 l

PET

197

Maximum loading of one shelf, kg 50 50

At switched on

lighting At switched

off lighting

At switched on

lighting At switched off

lighting

Energy consumption at ambient temperature

+25 °C:

kWh/24 h

kWh/year

2,05

748

2,02

737

2,14

781

2,07

756

Nominal imput of luminaire, W 3

For model CD350-1313, CD350-311

The appliance is a refrigerator with glass doors and is designed for storage and chilling of wine.

The appliance may be used in cafes, bars and etc.

THE APPL ANCE S ECOLOG CALLY CLEAN, CONTA N NG NO MATER ALS HARMFUL TO THE

OZONE LAYER: the refrigerant used is R600a, the foaming agent used for the appliance insulation

is cyclopentane C

THE MANUFACTURER GUARANTEES REL ABLE OPERAT ON OF THE REFR GERATOR WHEN THE

AMB ENT TEMPERATURE S +16 TO +32 DEGREES CELS US AND THE RELAT VE A R HUM D TY

NOT GREATER THAN 70 PER CENT.

The appliance climate class is N.

NOTE. The manufacturer reserves the right to make future changes to technical parameters and specifications.

STORAGE OF WINE

Temperature in the storage compartment depends on the

ambient temperature, on the position of the thermostat knob.

Thermostat knob position is set according to the table.

Wine temper ture, °C

Model CD350-1313, CD350-311

Refrigerator total gross volume, L 350

Refrigerator net volume, L 330

Dimensions (H x W x D), cm

173 x 60 x 60

Shelf area, dm

120

Average air temperature inside the refrigerator, °C from +4 to +14

Rated current, A 1,0

Weight, kg 67

Voltage used

220 - 230V/50HZ

Rated input, W 150

Door opening area, m² 0,80

General product exposure area, m² 0,62

Loading of the refrigerator (quantity of bottles) 0,75 l

105 pcs.

Maximum loading of one shelf, kg 50

At switched off lighting At switched off lighting

Energy consumption at ambient temperature

25 °C:

kWh/24 h

kWh/year

0,930

340 0,880

321

Nominal imput of luminaire, W 3

Position of the thermostat

(ambient temperature

+25 ºC)

Zone

designation 1 2 3 4 5

1 zone 12 – 14 12 – 14 12 - 14 10 – 12 8 – 10

2 zone 10 – 12 10 – 12 9 – 11 8 – 10 6 – 8

3 zone 8 – 10 8 – 10 8 – 10 6 – 8 4 – 6

4 zone 8 – 10 8 – 10 6 – 8 4 – 6 4 – 6

5 zone 8 – 10 8 – 10 4 – 6 2 – 4 2 – 4

6 zone 6 – 8 6 – 8 4 – 6 2 – 4 1 – 3

DESCRIPTION OF THE APPLIANCE, BASIC PARTS (see fig. 1)

1 Switch -(ON/OFF); 6 Fan

2 Thermostat knob 7 Shelf

3 Thermostat indicator 8 Cleaner

4 Electricity supply indicator 9 Condenser

5 nterior light block (LED) 10 Compressor

REVIEW OF MECHANICAL CONTROL (see fig. 1)

1 ― On / off switch for interior light. On / off switch for interior light I -(ON) O –(OFF)

2 ― Thermost t knob. The thermostat is off when there is a zero (0) in the thermostat indicator

space. Turning the thermostat knob clockwise the temperature in the compartment lowers.

3 ― Thermost t indic tor. Marked with the symbol

4 ― Electricity supply indic tor, marked with the symbol

When the appliance is connected to the electricity supply, the green indicator light is

illuminated. WARNING! The fan switches on and continuously operates.

PREPARING THE APPLIANCE FOR OPERATION

t is recommended to prepare the appliance for operation with a helper.

•Remove package. Lift the appliance away from foamed polystyrene base.

If your ppli nce is fit with screwed h ndles. Do not rise or push it t king by

h ndles. H ndles m y bre k.

•Therefore take out adhesive tapes from sides and simply lift the appliance up and take out

the board. Strip adhesive tapes off and open the door. Remove the spacer above the door.

•When positioning the appliance in chosen location, it will move more easily into position if you

lift the front a little and incline it backward allowing it to roll on its casters.

•Suitably dispose the packaging material.

•Take two supports from the bag (see fig. 4) and insert them into the guides at the top back

part of the appliance.

POSITIONING

•Place the appliance in a dry, well ventilated room.

WARNING! The appliance should not be operated in an unheated room or

porch. Place the appliance away from heat sources such as kitchen stove/oven,

radiators, or direct sunlight.

WARNING! The appliance must not touch any pipes for heating, gas or

water supply or any other electrical devices.

•Do not cover the ventilation holes at the top of the appliances – it must be a good air circulation

around the appliance. There should be a gap of at least 10 cm between the top of the appliance

body and any furniture that may be above it. f this requirement is not followed, the appliance

consumes more electrical energy and its compressor may overheat.

•f the appliance is placed in a corner, a gap of at least 1 cm must be left between the appliance

body and the wall (see fig. 2).

•The appliance must stand on a level surface and must not touch the wall. f necessary, regulate

the height of the appliance by adjusting the levelling feet: by turning them clockwise – the front

of the appliance rises, by turning them counter clockwise – it comes down. f the appliance is

tilted slightly backward – the doors will close by themselves.

Table of contents

Languages:

Other KBS Accessories manuals

KBS

KBS S 56 SC User manual

Popular Accessories manuals by other brands

Hillco

Hillco 2810 Operator's manual

Siemens

Siemens QSA2700D Basic documentation

Contours

Contours ZY024 manual

Saivod

Saivod VS621 manual

Virtuox

Virtuox VirtuCLEAN 2.0 user manual

SCE

SCE ENVIRO-THERM SCE-TE170B24VSS user manual

Z-Wave

Z-Wave HSD-200Z user manual

turck

turck FMX-IM-2UPLI63FX quick start guide

Decagon Devices

Decagon Devices 10HS manual

UPPAbaby

UPPAbaby Cup Holder user manual

Elko

Elko SmartSensor Leakage Wireless manual

Grizzly

Grizzly H8371 instructions

Panasonic

Panasonic HG-T Series user manual

IFM Electronic

IFM Electronic Efector 250 Series Brief instructions

DigiDesign

DigiDesign 888/24 I/O installation guide

PROZIS

PROZIS QUAY user manual

patagonia

patagonia PSI Vest user manual

SFC Energy

SFC Energy EFOY GO! manual