IL4076
Thank you for purchasing this Alice flush ceiling light. Please read the instructions
carefully before use to ensure safe and satisfactory operations of this product.
Please keep this instruction for future reference.
Warnings!
For your safety, this product must be installed in accordance with local Building
Regulations.
If in any doubt, or where required by the law, consult a competent person who is
registered with an electrical self-certification scheme. Further information is
available online or phone your Local Authority.
To prevent electric shock, switch off the mains supply before installing or
maintaining this product. Ensure other persons cannot restore the electricity supply
without your knowledge.
Always use the correct bulb type with the correct wattage as indicated in the
specification table. This product is Class II = and should be fitted to a lighting
Supply protected by a 5 amp fuse or equivalent circuit breaker.
When changing the bulb, always switch off at the mains and allow the old bulb to
cool down before handling. Dispose of used bulbs carefully.
Caution! The bulb and surrounding parts can become hot during use.
For indoor use only.
Care instructions
We recommend cleaning with a soft dry cloth. Do not use abrasive materials as
these will damage the finish.
Replace bulb from John Lewis or established brand of the same type and
compatibility.
Parts list
Assembly
Never install your appliance on a wet, freshly painted or plastered surface. Ensure
the house electricity supply is switched off at the fuse box. If removing an existing
fitting, note down all wiring connections. Check the fixings will not touch any
existing wiring before drilling and attaching the light to the ceiling.
Ensure you thread the ceiling wires through the black insulating tube fixed to the
appliance.
Step 1
Remove mounting bracket from fitting by removing the
retaining screws and any washers, retain for later. Using
the mounting bracket as a template, mark and then drill
the fixing holes in the ceiling (ensure the screws are firmly
fixed into a solid or other suitable mounting and not just
the plasterboard.). Take care not to damage wiring.
Attach mounting bracket to the mounting surface using
suitable fixings. Do not attach fitting to mounting bracket
at this stage. Make sure no wires are trapped in the
process.
Step 2
Ensuring that the power has been isolated, connect the
electrical supply wires to the connector blocks corresponding
terminals. Make the electrical connections as follows:
•Connect the supply live (normally brown or red) to fitting live
(marked “L”) on the terminal block housing.
•Connect the supply neutral (normally blue or black) to fitting
neutral (marked “N”) on the terminal block housing.
NO EARTH must be connected to any part of this fitting.
Please note that residential wiring can vary, if you are unsure
about the correct polarity please consult a qualified
electrician. Ensure electrical connections are tight and no loose strands of wire
protrude from the terminal block then close connector block cover by snapping
back together.
Step 3
Excess cable must be carefully located
inside the ceiling cup or within the
ceiling cavity itself. Carefully offer fitting
over mounting bracket then secure in
place with the screws and washers
removed earlier.
Fit the bulb: type and wattage as indicated on the fitting.
The wattage indicated must not be exceeded.
Fit the diffuser: Insert diffuser into the shade diagonally. Once
the diffuser is fully inserted inside the shade, gently lower the
diffuser until it comes to rest on the inside edges of the main
shade frame.
Once installation is complete, the house electricity may be
restored at the fuse box.
Step 3
