Intermec EasyCoder 501 SA User manual

EasyCoder 501/601

Sensor Kit

P/N 1-960411-02

Edition 3

September 1998

Installation Instructions

EasyCoder 501/601 – Installation Instructions

SENSOR KIT

Intermecoffersakitcontainingtwosensors,thatdetecttherotation

of the paper supply spool and the ribbon unwind shaft and update

two counters, one for each sensor. By means of custom-made

applicationprograms,thecounterscanbereadandusedforindicate

paper-lowandribbon-low conditions (asopposedto out-of-paper-

out and out-of-ribbon conditions, which are supported by the

standard error handling). See SYSVAR system array in Intermec

Fingerprint 6.13 Reference Manual1.

The Sensor Kit is available for the following printer models:

Model Ribbon Low Sensor Paper Low Sensor

EasyCoder 501 E yes yes

EasyCoder 501 SA yes yes

EasyCoder 601 S yes no

EasyCoder 601 E yes yes

Thesensorkitconsistsoftwophoto-electric sensors and two #T10

Torx screws.

The sensors require no regular cleaning. However, should any

malfunctionbedetected,youmaytrytoblowthesensorclearfrom

dust or paper residue before replacing it.

The sensitivity of these sensors cannot be adjusted.

Introduction

Ribbon Low Sensor Paper Low Sensor

The illustration shows the sensor kit fitted on an EasyCoder 501 E

printer.

1/. The system variable SYSVAR reads

the counters as follows:

SYSVAR (12) reads the paper counter

SYSVAR(13)readstheribboncounter

EasyCoder 501/601

Sensor Kit

Installation Instructions

Edition 3, September 1998

Part No. 1-960411-02

EasyCoder 501/601 – Installation Instructions

SENSOR KIT, cont'd.

Installation

Ribbon Low Sensor

• Open the right hand door.

• Turn off the power and remove the left-hand cover.

• Fromthe papercompartmentside,inserttheconnectorandcable

through the square hole in the centre-line wall.

• Insertthesensorunderthecodediskoftheribbonunwindunitso

the disc will run in the U-shaped slot between the receiver and

transmitter.

• Attach the sensor to the centre-line wall by means of one #T10

Torx screw. Check that the code disc can rotate freely.

• ConnectthecabletoconnectorP-605atthetopoftheCPUboard

(marked ➀).

• Continue by fitting the paper low sensor.

Paper Low Sensor

• Remove the three #T20 Torx screws holding the large crescent-

shapedguideplatethatsurroundsthepapersupply unit. Remove

the guide plate.

• Fit the sensor under the code disc of the upper supply unit using

the same method as with the ribbon low sensor.

• ConnectthecabletoconnectorP-602atthetopoftheCPUboard

(marked ➁).

• Fit back the guide plate and the left-hand cover.

Note!

The ribbon unwind unit and the paper

supply unit are shown dismounted in

the drawing only to improve visibility.

In reality, the only part that requires

dismounting is the guide plate.

Guide Plate

(remove)

Ribbon Unwind Unit

(do not remove) Paper Supply Unit

(do not remove)

Sensor

#T10 Torx screw

#T20 Torx screw (3x)

Sensor

#T10 Torx screw

Other manuals for EasyCoder 501 SA

This manual suits for next models

Table of contents

Other Intermec Printer Accessories manuals

Intermec

Intermec EasyCoder 501 SA User manual

Intermec

Intermec EasyCoder 4420 User manual

Intermec

Intermec EasyCoder 501 E User manual

Intermec

Intermec EasyCoder F4 User manual

Intermec

Intermec PB2 Series Manual

Intermec

Intermec EasyCoder PF2i User manual

Intermec

Intermec PM4I User manual

Intermec

Intermec UBI EasyCoder 601 E Guide

Intermec

Intermec EasyCoder 201II User manual

Intermec

Intermec 4820 Quick start guide

Intermec

Intermec EasyCoder F4 User manual

Intermec

Intermec EasyCoder PF4i User manual

Intermec

Intermec EasyCoder 101 Manual

Intermec

Intermec EasyCoder 501 SA User manual

Intermec

Intermec PW50 User manual

Intermec

Intermec 869 RFID Reader Operating instructions

Intermec

Intermec PC43d User manual

Intermec

Intermec Font Card User manual

Intermec

Intermec EasyCoder F4 User manual

Intermec

Intermec EasyCoder 3400e User manual

Intermec

Intermec PM4I User manual

Intermec

Intermec EasyCoder 501 SA User manual

Intermec

Intermec EasyCoder PF2i User manual

Intermec

Intermec EasyCoder PD41 User manual

Popular Printer Accessories manuals by other brands

Star Micronics

Star Micronics TSP800 Series install guide

REA

REA JET HR pro 2K user manual

HP Laserjet,Color Laserjet 4si user guide

oliser

oliser MS 45 instructions

Roland

Roland DU2-64 Supplementary manual

Xerox

Xerox EFI EXP6000 Specification sheet

Canon

Canon Finisher-T1 Service manual

Sharp

Sharp FO-1MK Service manual

Labelmate

Labelmate PM-300 user manual

Epson

Epson T6248 Product information sheet

Epson

Epson OT-BZ20 user manual

Canon

Canon TonerRobot EP-27 instruction manual

Ricoh

Ricoh LCIT RT5100 Field service manual

GBC

GBC 16 Series user guide

Canon

Canon INNER 2-WAY TRAY-E1 INSTALLATION PROCEDURE

Develop

Develop SD-509 installation manual

Kyocera

Kyocera KM-6230 Instruction handbook

Triumph Adler

Triumph Adler DF-710 Instruction handbook