Mutamix Manual v1.00
Instructions
While in Mutamix’s default Main Mode, it functions as an audio and CV mixer. It can even be
used to process both types of signal simultaneously due to the flexible bus routing architecture.
Simply plug your signals into the inputs, select an OUTPUT BUS using the switches at the
bottom of each channel, and make the necessary connections, then adjust your fader levels as
desired.
Channels can be muted by pressing their associated buttons at the top, or soloed by double
pressing. Arrangements of mutes can be saved by holding the SAVE button for approximately 1
second, until the X-MODE LED flashes, and then pressing the button where you want to save
this arrangement as a preset. These arrangements can then be loaded by holding the LOAD
button for approximately one second and then pressing the button with the desired preset.
These presets can be saved to EEPROM for recall after power cycling by holding the SAVE
button for a few seconds, until it flashes rapidly.
The MUTE CTRL/X-MODE FUNCTIONS inputs will mute channels when they receive a gate or
trigger signal. Their behaviour will depend on the GATE/PULSE settings. Pressing and holding
the GATE or PULSE buttons will cause the channel fader LEDs to light up if they are in the
selected mode. For example if you hold the GATE button, the channels set to GATE mode will
light up.
Channels in GATE mode will mute while the signal on their respective input is high. Channels in
PULSE mode will cause toggle between being muted and unmuted on every trigger received on
their input. GATE mode is optimized for square wave LFOs and sustained gate notes, while
PULSE is meant to be used with short momentary triggers or pulses.
Holding down X-MODE enters the other mode of the Mutamix, which changes the behaviour of
the buttons and the MUTE CTRL/X-MODE FUNCTIONS inputs. The buttons now instantly recall
saved presets when pressed. Furthermore, the MUTE CTRL/X-MODE FUNCTIONS inputs have
now switched from providing MUTE CTRL to their X-MODE FUNCTIONS. The respective
functions of each input is displayed in blue below the input jacks. These functions can also be
accessed by double tapping their associated button.
Connecting a clock signal to the CLK input causes Mutamix to step through saved presets on
each clock pulse. RESET will jump to the first preset, DIR will change the direction Mutamix
steps through presets, RANDOM will jump to a random preset, INV will invert the current mute
state of all channels, and MUTE-ALL will mute or unmute all channels. The number of presets
used in this sequence can be set by holding down the PULSE button and then selecting the last
preset to be used.
Page 8