2
Introduction
Congratulation on buying this ENTRYALERT!With this ALERT center,you
can know the statusofthe doorsof your premise without going outside or leaving
yourroom. TheAlertis working on wirelessand microcomputertechnology.
Content
3.Door sensor (Magnetic) transmitter 1
4.Magnetstrip 1
6.Large double side tape (for transmitter) 2
7.Lithium battery(CR2032) 2
Description of keys and connectorsof theMagnetic sensor
transmitter.
Figure2. Transmitter u magnet strip nit and
Installation
1.Installing the batteryto the transmitter units
-Open the batteryonthetransmitter unit frontcabinetandinsert thebattery as
indicated on theinside of the batterydoor.
-Close the batterydoor
2.Connectingthe AC adapter to the main receiving unit.Theadapter
connector can befound on the rear of the unit. FourAAbatteries can be
used. This is recommendedfor backup purpose.
3.Testing the sensor transmitter and the receiving unit.
3.2 Magneticsensor transmitter
Place the transmitter close to the main unit.The default zone iszone 2 for
magnetic sensor transmitter. Place the magnet strip nearthe vertical side of the
transmitterunit meansthedoor is closed. The main unit will show a door close light
for zone 2. Move the magnetstrip awayfrom the sensor; this meansthe dooris open.
The mainunit will give dooropen light and beeping sound.
Figure4. Testing of themagnet sensor transmitter unit andthe main receiving unit
2.Mount the magnetic sensor unit to the door
Figure6. Mountingthe magnetic sensorunit
3.Thereispaperlabelonthe front of the ENTRYALERT covered by the
transparent lens.Writedowndescriptiontomatchwith the transmitterunits
for easyrecognition.
Also fill in the zone label forthe corresponding transmitter.
Setting of newtransmitter code with theTransmitter and the
Receiver
Unless the user finds that thetransmitterdoes notworkwith the main
receiving unit or there is interferencefrom other wirelessappliance, it is not
recommended to change the transmittercode bythe user.
1.At the rear panelofthe mainunit,there is a smalllearnkey. Upon pressingthe
key,the unit willbeinthelearncodemode. Both open andclose lightsfor thezone
flash in thismode. Press this keyto select the zone.
2.Underneath the transmitter cabinet,you will find ahole wheremaybe
covered with the adhesive tape.You can use somepointed objectto press the tiny
buttoninside.Uponpush thelittleswitch,thecodefor thetransmitter is emitted. When
the main unit receives a valid code, a long beep will be heard.Eachzone can accept
up to 4 different transmitters.
3.Repeat for all the zonesand matched transmitter.Make sure onlyone
transmitteris transmitting the code duringthe process.
Zone Lable
Battery door
Code setting
button
Magnet
Door Closed
Door Closed
Sensor
Strip
Door
