Ikelite 6184.93 User manual

Digital Housing

i n s t r u c t i o n m a n u a l

6184.93 for Nikon S9200, S9300

Lens

Port

Thank you for your purchase of Ikelite equipment. Please read this

instruction manual completely before attempting to operate or dive

with this product. Please refer to the back page of this manual to

Table of Contents

Specifications ..............................................................P. 3

ackage Contents ........................................................P. 3

Product Registration........................................................P. 3

reparation ..................................................................P. 3

Initial Camera Setup........................................................P. 4

Housing Controls - Front View ........................................P. 5

Housing Controls - Back View ........................................P. 6

Opening the Housing ......................................................P. 7

Installing the Camera ......................................................P. 7

Closing the Housing ........................................................P. 8

Usage ..........................................................................P. 9

Turn Camera On..............................................................P. 9

Zoom Control ..................................................................P. 9

Using the Camera’s Built-in Flash ..................................P. 9

Diffuser and Deflector Use ..............................................P. 10

Entering the Water ..........................................................P. 11

Maintenance ................................................................P. 11

Lens Port ........................................................................P. 11

Lubricant..........................................................................P. 11

Housing Maintenance......................................................P. 12

Control Maintenance ......................................................P. 13

hoto Tips ..................................................................P. 15

Troubleshooting ........................................................P. 16

Replacement arts ....................................................P. 19

Recommended Accessories ....................................P. 19

Technical Support ....................................................P. 21

Limited Warranty ........................................................P. 22

Returning Products for Service ......................................P. 23

- Ikelite Digital Housing

- Housing Lanyard (attached)

- Silicone Lubricant

- Vinyl Port Cover

ackage Contents

- Diffuser

- Deflector

- Extra Control Tips

This product has been water pressure tested at the factory and is depth

rated to 200 ft. (60m). Thoroughly inspect and immerse the empty

housing completely in water before installing a camera. If any fogging

occurs or droplets of water enter the housing, do not install a camera.

Clean the housing main o-ring and retest to make sure that it is

watertight. Refer to the Troubleshooting section, page 16.

Please read your Nikon camera manual thoroughly to have a full

understanding of each camera function.

If you are new to underwater photography, be sure to read the Photo

Tips section.

reparation

Width ......................6.8 in. (173mm) including controls

Height ....................5 in. (127mm) including controls

Depth ......................5.5 in. (140mm) including controls and lens port

Weight ....................2.8 lb (1270g)

Buoyancy ................Near neutral in freshwater

Specifications

Initial Camera Setup (before placing camera in housing)

- Remove any attached camera lanyard.

- Insert a fully charged battery. Due to the power required to operate the

camera and LCD screen, start each dive with a fully charged camera

battery.

- Insert and format a memory card.

- Set camera to “Auto mode .”

- Set Image Mode to “16m.”

- Set White Balance to “Auto.”

- Set Metering to “Center-weighted.”

- Set ISO sensitivity to “125.”

- Set AF area mode to “Center.”

- Set Autofocus mode to AF-S “Single AF.”

- Set camera Time Zone and Date.

- Set Vibration reduction to “On.”

- Set AF-assist beam to “Off.”

- Set Flash Mode to “Fill flash .”

- Set Auto off to “5 min.”

- Set Macro mode to “On” when shooting close-up. If

the image is overexposed, use “-” exposure compensation

and/or back away, zoom in, and then reshoot.

Lens

Port

Housing Controls - Front View

Zoom Control

Shutter

Release

Power Switch

Lens ort

External Tray Mounts

Lid Snap

Mode Dial

Housing Controls

1. Movie-record Button

2. Playback Button

3. Flash Mode

4. Self-timer

5. O , Apply Selection

Housing Controls - Back View

6. Exposure Compensation

7. Macro Mode

8. MENU Button

9. Delete Button

CAUTION:

Some camera tripod

socket threads are

plastic. The mounting

bolt is metal. Do not

cross thread or over

tighten as you may

damage the camera

tripod socket threads.

Installing the Camera

1. Pull out on each housing control until it stops. This will get the controls

out of the way for installation of the camera.

2. Remove the back from the housing.

3. Remove camera lanyard from camera if attached.

3. The mounting tray for the camera is secured to the housing back.

Position the camera on the tray.

4. Using a coin or screwdriver (preferred), secure the camera with the tray

mounting bolt which threads into the camera’s tripod socket - Diagram A.

Opening the Housing

Lid Snaps have a Lock.

To open housing, push Lid Snap

Lock forward and lift as shown.

eep pressure on the Lid Snap so it

does not fly open quickly.

Some Lid Snaps have a lot of

spring tension once they go over

center, so keep a firm grip on the Lid Snap.

Lid Snaps may be opened one at a time.

Push Forward

Lid Snap Lock

Lift

Diagram A

Nikon

COOLP I X

18x

WIDE

Full

Tray Mounting Bolt

Closing the Housing

1. Place housing face down in your lap or on flat surface.

2. Check to see that there is an o-ring on

the housing back and that it is clean

and in its proper location.

3. Guide the back into the housing front.

The o-ring should touch the housing all

the way around. There should be an

even gap all the way around between

the housing and the housing back.

4. Lift the lid snaps so they are extended

and place each lid snap into the

corresponding hook on the housing

back.

5. To close the housing, push down on

the lid snaps until they snap into place.

Lid snaps on opposite sides of the

housing should be closed at the same

time. Be sure they are down far

enough to engage the lock.

Double check - Once the housing is

closed, check the o-ring seal. Check

the gap between the housing back and

the housing. It should be even all the way around the housing.

Look through the clear plastic back at the o-ring. You should see a

darkened area where the o-ring is compressed against the housing

back. If you do not see an even black compression seal all the way

around the back, open the lid snaps, reseat the housing back and close

the lid snaps. Visually check the seal again.

Housing Back

O-ring

Housing Back

O-ring

Even gap on

all four sides

Using the Camera’s Built-in Flash

If you are shooting with the camera’s built-in flash and the camera lens

is set to the widest angle setting, you may need to zoom the lens slightly

or a dark area may appear in a lower corner of close-up photographs.

The lens port may block some of the light. Install the Diffuser and zoom

in to eliminate any dark areas noted in your photographs (You can test

this above water). See Diffuser/Deflector Installation - page 10.

For the best results, we recommend using an external Ikelite Substrobe.

Zoom Control (lever type only)

After you have used the housing's

zoom control, it must be returned to the

center position to disengage. If the

housing zoom control is pushing the

zoom lever in either direction, you may

not be able to take a picture or access

other functions. This is because the

camera is receiving a signal from the

engaged zoom control.

Zoom Control

“Engaged”

Zoom Control

“Disengaged”

(Center Position)

Turn Camera On

Turn the camera on and operate each of the housing controls to get a

feel for using the camera in the housing.

You are now ready to shoot underwater photos!

Usage

The camera’s built-in flash CANNOT be used with optional Wide Angle or

Accessory lenses.

Diffuser Use

The diffuser should be installed when using the camera flash. When

shooting close-up photographs with the camera flash and at the camera

lens’s widest angle setting, the lens port on the housing can block a

portion of the light from the camera flash. This can result in a shadow in

a lower corner of the frame. Zoom the lens to eliminate the shadow (You

can test this above water).

Deflector Use

The deflector should be installed when using an Ikelite external strobe.

The deflector will block and redirect the camera’s flash to the AF35 slave

unit or EV-controller which controls the external strobe’s output.

Remove the diffuser before attempting to install the deflector.

Diffuser/Deflector material

Small hole

Cut-out

Section

A diffuser and deflector are

included with the housing. The

diffuser is white transparent plastic.

The deflector is also white but is

not transparent.

To install the diffuser or deflector,

push the “Cut-out” Section into the

port groove until it stops.

Note the Small Hole. To avoid

losing the diffuser or deflector, you

can attach a fishing line or string to

this hole.

Diffuser and Deflector Installation

Lens Port

Diffuser/Deflector properly

installed in port groove

Table of contents

Other Ikelite Camera Accessories manuals

Ikelite

Ikelite Digital Housing User manual

Ikelite

Ikelite 5509.15 User manual

Ikelite

Ikelite 6801.52 User manual

Ikelite

Ikelite 4077.01 Specification sheet

Ikelite

Ikelite 6871.06 User manual

Ikelite

Ikelite DCR-HC14 Owner's manual

Ikelite

Ikelite SLR-DC Housing User manual

Ikelite

Ikelite 6951.07 User manual

Ikelite

Ikelite 6242.11 Owner's manual

Ikelite

Ikelite 6950.12 User manual

Ikelite

Ikelite 6146.19 User manual

Ikelite

Ikelite 5510.45 User manual

Ikelite

Ikelite 12 Owner's manual

Ikelite

Ikelite DSC-RX100M3/B User manual

Ikelite

Ikelite Nikon Coolpix 8400 User manual

Ikelite

Ikelite 9306.35 User manual

Ikelite

Ikelite WD-4 User manual

Ikelite

Ikelite 6801.32 User manual

Ikelite

Ikelite 6060 Owner's manual

Ikelite

Ikelite 6146.07 User manual

Ikelite

Ikelite PowerShot IXUS SD900 Ti User manual

Ikelite

Ikelite 6282.68 Owner's manual

Ikelite

Ikelite 6842.35 User manual

Ikelite

Ikelite 69531 User manual

Popular Camera Accessories manuals by other brands

Viltrox

Viltrox EF-NEX Mount instructions

Calumet

Calumet 7100 Series CK7114 operating instructions

Ropox

Ropox 4Single Series User manual and installation instructions

Cambo

Cambo Wide DS Digital Series Main operating instructions

Samsung

Samsung SHG-120 Specification sheet

Ryobi

Ryobi BPL-1820 Owner's operating manual

Aegis

Aegis ABL-36020P user manual

Pentax

Pentax Data Back Fc operating manual

Fantasea

Fantasea EyeGrabber F Series instruction manual

Honeywell

Honeywell HDZ20HD user manual

EGO

EGO BA1400T Operator's manual

Sima

Sima SRW-62 user guide

Shape

Shape A7SSMKIT Assembly manual

Slide Kamera

Slide Kamera HST-2 user manual

Power works

Power works 2902613 Original instructions

SES

SES SE-2047-2 user manual

Olympus

Olympus PT-EP05L instruction manual

Starlite

Starlite OctoDome nxt instructions