IKEA MATÄLSKARE User manual
MATÄLSKARE
GB
FR
DE
IT
ENGLISH 4
DEUTSCH 14
FRANÇAIS 26
ITALIANO 39
Please refer to the last page
of this manual for the full list
of IKEA appointed Authorized
Service Centre and relative
national phone numbers.
Gehen Sie dazu auf die letzte
Seite dieser Broschüre. Dort
nden Sie eine Übersicht mit den
entsprechenden Telefonnummern
und Kontaktdaten unserer
autorisierten Kundendienste.
Consultez la dernière page de ce
manuel pour la liste complète des
centre d’entretien et de réparation
agréés IKEA avec leur numéro de
téléphone respectifs.
Siete pregati di contattare il
numero del Centro Assistenza
Autorizzato incaricato da IKEA
riportato sull’ultima pagina di
questo manuale.
ENGLISH 4
Contents
Before rst use
Your safety and that of others is
paramount.
Remove cardboard protection
pieces, protective lm and
adhesive labels from accessories.
Check the appliance for any
transport damage.
To avoid any damage do
not place any weights on the
appliance. Do not expose the
appliance to atmospheric agents.
This manual and the appliance
itself provide important safety
warnings, to be read and
observed at all times.
This is the attention symbol,
pertaining to safety, which
alerts users to potential risks to
themselves and others.
All safety warnings are preceded
by the attention symbol and the
following terms:
DANGER: indicates a
hazardous situation which, if
not avoided, will cause serious
injury.
WARNING: Indicates a
hazardous situation which, if
not avoided, could cause serious
injury.
All safety warnings give specic
details of the potential danger/
warning present and indicate how
to reduce risk of injury, damage
and electric shock resulting from
improper use of the appliance.
Carefully observe the following
instructions.
Precautions and general
recommendations
• The electrical installation and
the electrical connection must
be carried out by a qualied
technician according to the
manufacturer’s instructions
and in compliance with the
local safety regulations. Do not
repair or replace any part of
the appliance unless specically
stated in the user manual.
• The appliance must be
disconnected from the power
supply before carrying out any
installation work.
WARNING: Failure to install
the screws or xing device in
accordance with these instructions
may result in electrical hazards.
• Earthing of the appliance is
compulsory. (Not possible for
class II hoods identied by the
symbol on the dataplate).
Safety Information
Safety information 4
Use 7
Product description 8
Control panel 8
Cleaning and maintenance 9
What to do if ... 11
Technical data 12
Environmental concerns 13
ENGLISH 5
• Do not pull the power supply
cable in order to unplug the
appliance.
• The electrical components must
not be accessible to the user
after installation.
• Do not touch the appliance
with any wet part of the body
and do not operate it when
barefoot.
• This appliance can be used
by children aged from 8 years
and above and persons with
reduced physical, sensory or
mental capabilities or lack of
experience and knowledge
if they have been given
supervision or instruction
concerning use of the appliance
in a safe way and understand
the hazards involved. Children
shall not play with the
appliance. Cleaning and user
maintenance shall not be made
by children without supervision.
• All other maintenance services
must be carried out by a
specialised technician.
• When drilling through the wall
pay attention not to damage
electric connections and/or
pipes.
• Air vents must always discharge
to the outside.
• The manufacturer rejects all
responsibilities for any damage
caused by improper use or
wrong settings.
•Appropriate maintenance
and cleaning ensure the good
working order and the best
performance of the appliance.
Regularly clean all stubborn
surface dirt to avoid grease
build up. Remove and clean
or change the lter regularly.
This must be completed in
accordance with the “Cleaning
and maintenance” instructions
provided.
• Never ame cook food (ambé)
under the appliance. Using free
ames might cause re.
• Failure to observe the
instructions for cleaning the
hood and replacing the lters
may result in a re.
• Exhaust air must not be vented
through a ue used for removal
of fumes produced by gas
combustion appliances or other
combustible materials, but must
have a separate outlet. All
national regulations governing
extraction of fumes must be
observed.
• There shall be adequate
ventilation if the hood is being
used at the same time as other
appliances using gas or other
combustible materials. The
negative pressure of the room
must not exceed 4 Pa (4x 10-5
bars). For this reason ensure
that the room is well ventilated.
In case of doubts, please
consult an autorized service
assitance center or similar
qualied person.
• Do not leave frying pans
unattended when frying, as the
frying oil may catch re.
ENGLISH 6
• Before touching the light bulbs,
ensure that they are cold.
• Do not use or leave the hood
without the light bulb correctly
tted, as this may cause electric
shock.
• The hood is not a work surface,
therefore do not place any
objects on top of it or overload
it.
• During all installation and
maintenance operations wear
appropriate working gloves.
• This appliance is not suitable
for outdoor use.
WARNING: when the hob is in
use, accessible parts of the
hood may become hot.
Installation and connection
In the event of problems, contact
the Authorized Service Centre. To
prevent any damage, only remove
the appliance from its packaging
at the time of installation.
Preparing for installation
WARNING: this is a heavy
product; the hood should only
be lifted and installed by two or
more people.
The minimum distance between
the hob and the bottom part of
the hood must not be less than 65
cm for burning gas or other fuels
and 50cm for electric cookers.
Before installation also check the
minimum distances stated in the
manual of the cooker.
If the installation instructions
for the cooker specify a greater
distance between cooker and
hood, this distance must be
observed.
Electrical connection
Make sure the power voltage
specied on the appliance rating
plate is the same as the mains
voltage.
This information can be found
on the inside of the hood, under
the grease lter. Power cable
replacement (type H05 VV-F)
must be carried out by a qualied
electrician. Contact an authorized
service centre.
If the hood is tted with an electric
plug, connect the plug to a socket
complying with current regulations,
located in an accessible place.
WARNING: if no plug is tted
(direct wiring to the mains), or
if the socket is not located in an
accessible place, a qualied
electrician should install a
standardised double pole power
switch that will enable complete
isolation from the mains in case of
category III overvoltage
conditions, in accordance with
wiring rules.
ENGLISH 7
Use
The hood has been designed to be installed
and used either as a “Exhausted model”, or
as a “Recirculation model”.
Exhausted model (see symbol in
installation booklet)
Cooking steam is sucked and channelled
outside the house through a discharge duct
(not supplied), tted to the hood steam
outlet.
Ensure that the discharge duct is correctly
tted to the air outlet, unit using an
appropriate connection system.
Important: If already installed, remove the
charcoal lter/s.
Recirculation model (see symbol in
installation booklet)
The air is ltered through one or more the
charcoal lters, and then resent into room.
Important: Ensure appropriate air circulation
around the hood.
Important: If the hood is supplied without
charcoal lters, these must be tted before
the hood can be used. Filters are available
in IKEA shops.
The hood should be installed away from
particularly dirty areas, windows, doors and
heat sources.
The accessories for wall xing are not
included because walls made of different
materials require different types of xing
accessories. Use xing systems suitable for
the walls of your home and the weight of
the appliance. For more details, contact a
specialized dealer.
Keep this booklet for future consultation.
ENGLISH 8
Product description
Control panel
1Chimney.
2 Control Panel.
3Light.
4 Grease lter.
A
Light ON/OFF
knob
B
Suction (power) speed selector knob
0OFF
Low suction (power) speed
Medium suction (power) speed
High suction (power) speed
Maximun suction (power) speed
ENGLISH 9
WARNING:
- Never use steam cleaning equipment.
- Disconnect the hood from the electric
power supply.
IMPORTANT: do not use corrosive or
abrasive detergents. If any of these products
accidentally comes into contact with the
appliance, clean immediately with a damp
cloth.
• Clean the surfaces with a damp cloth.
If it is very dirty, add a few drops of
washing up detergent to the water.
Finish off with a dry cloth.
IMPORTANT: do not use abrasive sponges
or metallic scrapers or scourers. Over time,
these can ruin the surface.
• Use detergents specically designed for
cleaning the appliance and follow the
manufacturer instructions.
IMPORTANT: clean the grease lters at
least monthly to remove any oil or grease
residuals.
To clean the grease lter
The metal grease lter has an unlimited life
and must be washed once a month by hand
or dishwasher at low temperature and with
a short cycle. With cleaning in a dishwasher
the grease lter may become dull; this does
not effect its ltering capacity.
Grease lter maintenance:
1. Disconnect the hood from the electric
power supply.
2 Remove the grease lters: pull the spring
release handle downwards, then remove
the lter.
3. After cleaning the grease lter, remount
in reverse order ensuring the entire
extraction surface is covered.
Cleaning and maintenance
ENGLISH 10
Charcoal lter maintenance (if the hood is
installed in recirculation mode)
1. Unplug the appliance or disconnect the
power supply.
2. Remove the grease lter as previously
indicated in the grease lter chapter.
3. Remove charcoal lter holder
4. Remove/add charcoal lter
5. Fix metal wire to keep the charcoal lter
in the correct position
6. Hook the carbon lter rstly to the metal
tab at the back on the hood.
7. Fix it at the front with the two knobs.
8. Ret the grease lter.
Unlike traditional charcoal lters, this
charcoal lter can be washed and
reactivated.
With normal hood use, the lter should
be cleaned once a month. The best way
to clean the lter is in a dishwasher at
the highest temperature possible, using
a normal dishwasher detergent. To avoid
particles of food or dirt settling on the
lter during washing and giving rise to
unpleasant smells, it is advisable to wash
the lter on its own. After washing, dry the
lter in the oven at 100°C for 10 minutes to
reactivate it.The lter will retain its odour-
absorbing capacity for three years, after
which it will have to be replaced.
Lamp maintenance
The hood is equipped with a lighting system
based on LED technology.
The LEDs guarantee an optimum lighting,
a duration up to 10 times as long as the
traditional lamps and allow to save 90%
electrical energy.
For replacement, contact the Authorized
Service Centre.
Other manuals for MATÄLSKARE
17
Table of contents
Languages:
Other IKEA Ventilation Hood manuals
IKEA
IKEA LAGAN User manual
IKEA
IKEA UNDERVERK User manual
IKEA
IKEA GRILJERA User manual
IKEA
IKEA BF570 User manual
IKEA
IKEA Range Hood User manual
IKEA
IKEA IHW7303WS0 User manual
IKEA
IKEA Range Hood Manual
IKEA
IKEA UDDEN HW320 User manual
IKEA
IKEA DATID HW570 User manual
IKEA
IKEA IHW8303WS0 Product information sheet
IKEA
IKEA IH6242WM0 Product information sheet
IKEA
IKEA LAGAN User manual
IKEA
IKEA LUFTIG User manual
IKEA
IKEA NUTID HF274 User manual
IKEA
IKEA IHW7302YS0 User manual
IKEA
IKEA Rytmisk User manual
IKEA
IKEA FINSMAKARE User manual
IKEA
IKEA RYTMISK 803.921.36 User manual
IKEA
IKEA LI25DA User manual
IKEA
IKEA MOLNIGT User manual
