Step 3:
Fasten the lateral cross braces (4) to the
upright supports (2 and 3) by using bolts
(12), washers (18), and plastic nuts (20).
Repeat the same procedure for both sides.
See Fig. A – Step 3.
Step 5:
Insert the leg caps (10) into all of the base feet.
See Fig. A – Step 5.
Step 1
Step 2
Step 3
Step 4
Step 5
Fig. A
Step 1:
Fasten the front and rear upright supports (2
and 3) at the top by using bolts (11), washers
(17), and plastic nuts (19). Repeat the same
procedure for both sides. Keep the bolts loose.
See Fig. A – Step 1. Do not tighten the bolts
after step 1, fasten all of
the bolts after Fig A.
Step 2:
At both ends, insert the assembled upright
supports (2 and 3) into the top cross beam w/
adjustable teeth (1). Tighten all of the plastic
nuts and bolts now. See Fig. A – Step 2.
Step 4:
Fasten the rear cross brace (5) to the rear
upright supports (3) by using bolts (12),
washers (18), and plastic nuts (20). Tighten all
of the nuts and bolts. See Fig. A – Step 4.
11 17
17
17
17
11
12
18
18 20
12
10
10
10
10
18
18 20
2
2
2
3
2
3
3
3
3
3
3
2
23
2
4
5
4
3
1
NOTE: When fastening with nuts and bolts,
always use a washer (17 or 18) between the
tube and the bolt or the tube and the nut.
19
19
4
