Doc: 04-11-22, v1.0,r1 www.havkon.com
Warnings
Before using the device, read the user manual
carefully and follow the instructions.
Responsibility for damages, losses and personal
accidents caused by not following the warnings in the
user manual belongs to the user. In this case, the
device is out of warranty in case of malfunctions.
The device must be used in accordance with the
instructions. There should be no electricity in the
connecting cables during assembly. The device must be
protected from moisture, vibration and pollution. Attention
should be paid to the operating temperature.
Shielded and twisted cord cable should be used for input
and output lines that are not connected to the mains.
These cables should not be passed near high power lines
and devices. The shield line must be grounded at the
device side. Installation and electrical connections must
be made by technical personnel in accordance with the
instructions in the user manual.
Before starting the assembly of the device, it should be
visually checked against any damage that may occur
during transportation. Installation and commissioning
must be done by mechanical and electrical technicians.
This responsibility belongs to the buyer.
If there is a danger that may arise from any error or
malfunction on the device, turn off the energy of the
system and disconnect all electrical connections of the
device from the system.
There is no switch on the device to turn off the device's
energy.A switch and fuse must be added to the system by
the user to turn off the energy at the supply input of the
device.
It is necessary to check the supply voltage range of the
device and apply the appropriate supply voltage. This
control process will prevent damage to the device or
system and possible accidents by applying the wrong
supply voltage.
In order to prevent electric shocks and similar accidents,
the device and the installation system should not be
energized before all connections of the device are
completed.
Do not modify or attempt to repair the device.
Interventions on the device may cause malfunction of the
device, damage to the device and the system, electric
shocks and fire.
Never use the device in environments where flammable
and explosive gases are present.
Necessary precautions must be taken regarding all parts
that may pose a danger to the mechanical part where the
device will be mounted. These precautions are necessary
for the safety of the personnel who will do the installation.
The device must be mounted on the system with its own
fixing parts. Do not assemble the device with unsuitable
fixing parts.
In case the device is used for purposes other than
those specified in this user manual, all responsibility
belongs to the user.
The Wattanty period 2 (two) years from the date of
purchase of the device.
