HAMPTON BAY Sabitini User manual

Hanging the Fan

REMEMBER to turn off the power.

Follow the steps below to hang your fan

properly.

NOTE: This ceiling fan is supplied

with two types of hanging

assemblies; the standard ceiling

installation using the downrod with

ball and socket mounting, and the

"close-to-ceiling" mounting. The

"close-to-ceiling" mounting is

recommended in rooms with less

than 8-foot ceilings or in areas

where additional space is desired

from the floor to the fan blades.

When using standard downrod

installation, the distance from the

ceiling to the bottom of the fan

blades will be approximately 15

inches. The "close-to-ceiling"

installation reduces the distance

from the ceiling to the bottom of the

fan blades to approximately 9 inches.

Once you have decided which ceiling

installation you will use, proceed with

the following instructions. Where

necessary. each section of the

instructions will note the different

procedures to follow for the two types of

installation.

STANDARD CEILING

MOUNTING

1. Remove the canopy ring from the

canopy by turning the ring to the right

until it unlocks (Figure 5).

2. Remove the mounting plate from

the canopy by loosening the four screws

on the top of the canopy. Remove the

two non-slotted screws and loosen the

slotted screws. This will enable you to

remove the mounting plate (Figure 6).

Turn Canopy Ring to Remove

Figure 5

Loosen but Do Not Remove Remove

Figure 6

3. Route the wires exiting the top of

the fan motor through the decorative

motor collar cover then the canopy ring.

Make sure the slot openings are on top.

Route the wires through the canopy and

then through the ball/downrod assembly

(Figure 7).

4. Loosen, but do not remove, the set

screws on the collar on the top of the

motor housing.

5. Align the holes at the bottom of the

downrod with holes in the collar on top

of the motor housing (Figure 7).

Carefully insert the hanger pin through

the holes in the collar and downrod. Be

careful not to jam the pin against the

wiring inside the downrod. Insert the

locking pin through the hole near the end

of the hanger pin until it snaps into its

locked position.

WARNING

FAILURE TO PROPERLY INSTALL

LOCKING PIN AS NOTED IN STEP 5

COULD RESULT IN FAN LOOSENING AND

POSSIBLY FALLING.

6. Re-tighten the set screws on the

collar on the top of the motor housing.

7. Make sure the grommet is properly

installed in the collar cover, then slide

the collar cover on the downrod until it

rests on the motor housing. Be sure that

the canopy and the collar cover are both

oriented correctly.

8. Proceed to "Installing the Fan"

section. 4.

Making the Electrical

Connections

REMEMBER to disconnect the power. If

you feel that you do not have enough

electrical wiring knowledge or experience,

have your fan installed by a licensed

electrician.

Follow the steps below to connect the fan

to your household wiring. Use the wire

connecting nuts supplied with your fan

and supplied with remote control. Secure

the connectors with electrical tape. Make

sure there are no loose strands or

connections (Figure 13).

l. Connect both green wires from the

downrod and mounting plate to the bare

copper (Ground) from the electrical box.

2. Connect the black wire (AC IN L)

from the receiver unit to the black wire

from the electrical box.

3. Connect the white wire (AC IN N)

from the receiver unit to the white wire

from the electrical box.

4. Connect the white wire (To Motor N)

from the receiver unit to the white wire

from the fan assembly.

5. Connect the black wire (To Motor L)

from the receiver unit to the black wire

from the fan assembly.

6. Connect the blue wire (For Light)

from the receiver unit to the blue wire

from the fan.

After wires are connected, carefully tuck

them into the electrical box. Insert the

receiver unit into the mounting plate;

make sure the black antenna wire sits on

top of the receiver unit.

NOTE

THE FREQUENCIES ON YOUR RECEIVER AND

TRANSMITTER HAVE BEEN PRESET AT THE

FACTORY, BEFORE INSTALLING THE

RECEIVER, MAKE SURE THE DIP SWITCHES

ON THE RECEIVER AND TRANSMITTER ARE

SET TO THE SAME FREQUENCY. THE DIP

SWITCHES ON THE TRANSMITTER ARE

LOCATED INSIDE THE BATTERY

COMPARTMENT.

WARNING

EACH WIRE NUT (WIRE CONNECTOR)

SUPPLIED WITH THIS FAN IS DESIGNED TO

ACCEPT UP TO ONE 12 GAUGE HOUSE WIRE

AND TWO WIRES FROM THE FAN. IF YOU

HAVE LARGER THAN 12 GAUGE HOUSE

WIRING OR MORE THAN ONE HOUSE WIRE TO

CONNECT TO THE FAN WIRING, CONSULT AN

ELECTRICIAN FOR THE PROPER SIZE WIRE

NUTS TO USE.

Figure 13

Table of contents

Other HAMPTON BAY Fan manuals

HAMPTON BAY

HAMPTON BAY 52139 User manual

HAMPTON BAY

HAMPTON BAY FANELEE User manual

HAMPTON BAY

HAMPTON BAY Carriage House-2 138 108 User manual

HAMPTON BAY

HAMPTON BAY 52" ELKTON User manual

HAMPTON BAY

HAMPTON BAY 91126 User manual

HAMPTON BAY

HAMPTON BAY Trusseau 324-683 User manual

HAMPTON BAY

HAMPTON BAY Mediterranean 52" User manual

HAMPTON BAY

HAMPTON BAY AG524PR-FB User manual

HAMPTON BAY

HAMPTON BAY Carlsbad User manual

HAMPTON BAY

HAMPTON BAY MENA HUGGER 92402 User manual

HAMPTON BAY

HAMPTON BAY AG524-BN User manual

HAMPTON BAY

HAMPTON BAY FB50-16H User manual

HAMPTON BAY

HAMPTON BAY Devereaux II User manual

HAMPTON BAY

HAMPTON BAY Spoleto II Spoleto II User manual

HAMPTON BAY

HAMPTON BAY Redington 740-125 User manual

HAMPTON BAY

HAMPTON BAY Portsmouth User manual

HAMPTON BAY

HAMPTON BAY 50248 User manual

HAMPTON BAY

HAMPTON BAY Larson User manual

HAMPTON BAY

HAMPTON BAY ASBURY User manual

HAMPTON BAY

HAMPTON BAY 786-756 User manual

HAMPTON BAY

HAMPTON BAY Gazebo 473-131 User manual

HAMPTON BAY

HAMPTON BAY Moonlight 458-241 User manual

HAMPTON BAY

HAMPTON BAY 68144 User manual

HAMPTON BAY

HAMPTON BAY BANNERET YG730-MWH User manual

Popular Fan manuals by other brands

ELTA FANS

ELTA FANS H03VV-F installation guide

Hunter

Hunter 20714 Owner's guide and installation manual

Emerson

Emerson CARRERA VERANDA CF542ORB00 owner's manual

Hunter

Hunter Caraway Owner's guide and installation manual

Panasonic

Panasonic FV-15NLFS1 Service manual

Kompernass

Kompernass KH 1150 operating instructions

VES

VES FALA100/12V/TR Original instructions

Vertiv

Vertiv Liebert DCD user manual

Westinghouse

Westinghouse GFP Series owner's manual

Venmar

Venmar KUBIX HRV PLUS Series user guide

Maico

Maico ECR 31 installation instructions

Sonnenkonig

Sonnenkonig Dinky instruction manual

S&P

S&P ECOWATT HXBR manual

Wider

Wider IMP03369BH instruction manual

Panasonic

Panasonic F-60DHN Operating and installation instructions

Hinkley

Hinkley HIGHLAND instruction manual

Broan

Broan 766BN installation guide

Premium

Premium PFS16022 Use manual