Haier WD9900 User manual

THOR WASHER/DRYER

INSTALLATION GUIDE

MODEL: WD-9900

Unpacking the Machine

The Thor Combination Washer/

Dryer must be unpacked prior to

installation. All packaging should be

removed from the machine. Two

water supply hoses with brass

pressure reducers, a drain hose U-

bracket, a wrench, and three plastic

inserts will be located in a bag inside

the drum.

VERY IMPORTANT

The shipping bolts located in the

back of the machine must be

removed prior to operating the

machine.

Unpack the machine. Properly

dispose of all packing

materials.

Check for two (2) water supply

hoses with two (2) brass

pressure reducers on the red

end, one (1) drain hose bracket,

one (1) wrench, and three (3)

plastic insert caps.

Summary

Open the door to the drum and

remove the bag containing

parts.

Unscrew the three shipping

bolts on the back of the

machine using the wrench

provided or a 13 mm socket.

Once the bolts are unscrewed

fully they can be removed from

the machine.

5. Cover the holes left by the bolts

with the plastic inserts located

in the bag of parts.

Locations

of Shipping Bolts

NOTE - ONCE SHIPPING BOLTS ARE REMOVED RUBBER SPACERS MAY FALL

DOWN AND OUT THROUGH BOTTOM OF MACHINE. THIS IS NORMAL AND WILL

NOT CAUSE ANY HARM OR MALFUNCTION.

Connecting Water Supply and Drain

The machine should be located

within easy reach of the water

supply, the drain pipe, and an

electrical outlet The water supply

should be connected once the

machine is in the correct location,

followed by the drain hose. Drain

hose should be secure. All hoses

and connections should be checked

thoroughly before leaving machine

unattended.

IMPORTANT

For ease of installation only one (1)

pressure reducer needs to be used.

Both should be used under VERY

high pressure situations.

Normally only one pressure

reducer is needed. For above

normal pressure both reducers

may be necessary. For very

low pressure situations you

may leave both off.

Summary

1. The brass pressure reducer

must be removed from both

hoses before they can be

attached to the machine.

When hoses are attached to the

machine care must be taken to

not strip the inlet valves.

COLD HOT

Attach both inlet hoses to the

machine. The red end MUST

be attached to the machine, as

it has metric threading.

4. Attach both hoses to the water

supply. Be sure that the

correct hose is on the correct

inlet valve. (Hot-Hot; Cold-Cold)

Tighten all connections to

prevent leaks, but do not over

tighten.

With Adaptor

The U-bracket must be attached

to the hose to hold it in the

drain. It is recommended that

4-6 inches of hose should be

left to go into the pipe.

5. Put the drain hose into the

drain pipe, securing it to make

sure that it cannot slip and

flood.

4-6”

Leveling the Machine and Finishing Up

The QuietLine washer/dryer should

be installed on a level surface that is

well supported to prevent vibration.

Preferably the machine should be

installed on a solid and level floor

surface.

The machine must be leveled

properly before operation. This will

prevent excessive noise, vibration,

and possible damage to machine.

The QuietLine has four leveling legs

which can be adjusted and locked

for proper leveling.

Put the machine into its final

operating location.

Using a level, check both front

to back and side to side on the

machine. If it is not level, make

appropriate adjustments to the

feet until it is.

Summary:

To adjust feet, loosen locknuts

using the leveling leg wrench,

and screw the foot up or down

until the machine does not rock

and is level.

REFER TO MACHINE’S MANUAL AND EZ WASH GUIDE FOR

OPERATING INSTRUCTIONS.

Hand tighten the locknuts

against the base of the

machine.

Once the machine is level plug

into electrical outlet.

6. Turn it on/off using the button

located in the center of the

panel.

Using the leveling leg wrench,

firmly secure the locknuts to

prevent the legs from slipping.

FOR TECHNICAL SERVICE, HELP, OR

QUESTIONS ABOUT INSTALLING OR

INITIAL OPERATION OF YOUR THOR

COMBINATION WASHER/DRYER PLEASE

CALL

888-876-8002

www.OasisAppliance.com

Other manuals for WD9900

Table of contents

Other Haier Washer manuals

Popular Washer manuals by other brands

Tricity Bendix

Tricity Bendix AW 1000 W Operating & installation instructions

Panasonic

Panasonic NA-F60L5WRB operating instructions

GE WSLP1500 Dimensions and installation information

Electrolux

Electrolux EWF1284EDW Service manual

Bosch

Bosch WAN2829BSN User manual and installation instructions

LG TV2516DV3B owner's manual

LG TH2517DSAV owner's manual

VESTEL

VESTEL CMH-XL 7510 TE user manual

AEG

AEG 74335 User information

Johnson

Johnson JWF721A user manual

Beko

Beko WTE7604XLW0 owner's manual

Danby

Danby DTT100A1WDB Owner's use and care guide

Amica

Amica WA 14 Ex operating instructions

Daewoo

Daewoo DWD-F1222 instruction manual

Bosch

Bosch WAS28461AU instruction manual

Miele

Miele PW 6080 Vario manual

Finlux

Finlux FLX108CF220 user manual

Whirlpool

Whirlpool 3LBR5132AN0 Use and care guide