Grizzly G4816 User manual
G4816 G4817 G4818 G4819 Instructions
Grizzly Industrial, Inc © 1996
1. Remove band saw blade per instructions in your manual.
2. Remove both upper and lower blade guides.
3. Install ball bearing guides in place of old guides.
4. Re-install blade.
5. Set the bearing guide so the bearing just clears the teeth of the blade. The blade will be damaged if
the bearing comes in contact with the teeth during operation.
6. Loosen both thumb screws on the upper bearing guide.
7. Rotate each eccentric shaft until the bearing just touches the side of the blade. Tighten down the
thumb screws. Make sure the bearing guides are not pinching the blade. This can cause premature
bearing wear.
8. Repeat steps 5-7 for the bottom bearing guide.
9. If access to the thumb screws is limited or they interfere with a guard or bracket, replace them with
hex bolts. Be sure not to over tighten!
10. Reset the back-up bearing per the instructions in your bandsaw manual.
This manual suits for next models
3
Table of contents
Other Grizzly Accessories manuals
Grizzly
Grizzly G1763 User manual
Grizzly
Grizzly G8987 User manual
Grizzly
Grizzly H8165 User manual
Grizzly
Grizzly G0750G User manual
Grizzly
Grizzly G1705 User manual
Grizzly
Grizzly H8370 User manual
Grizzly
Grizzly g5749 User manual
Grizzly
Grizzly H8068 User manual
Grizzly
Grizzly G0577 User manual
Grizzly
Grizzly D3080 User manual
Grizzly
Grizzly H6329 User manual
Grizzly
Grizzly G5960 User manual
Grizzly
Grizzly H7197 User manual
Grizzly
Grizzly G1026 User manual
Grizzly
Grizzly G5938 User manual
Grizzly
Grizzly G1763 User manual
Grizzly
Grizzly G1023SLW User manual
Grizzly
Grizzly POWER FEED H8370 User manual
Grizzly
Grizzly H8371 User manual
Grizzly
Grizzly G1822 User manual
