Green Brook T80-C User manual
IMPORTANT
This unit should be installed to current IEE wiring regulations if in doubt
consult a qualified electrician.
T80-C Instructions – Simplified
Setting current time and Day
Press and hold down
Set current time by press ‘h+’ (Hours) & ‘m+’ (minutes)
Set current day by press ‘Day’
http://waterheatertimer.org/Din-rail-timers-and-manuals.html
IMPORTANT
This unit should be installed to current IEE wiring regulations if in doubt
consult a qualified electrician.
Setting Switching Times (6 on offs available)
Press ‘Timer’ button once
Set O time by press ‘h+’ (Hours) & ‘m+’ (minutes)
Set DAY by pressing ‘Day’
Press ‘Timer’ button once
Set OFF time by press ‘h+’ (Hours) & ‘m+’ (minutes)
Set DAY by pressing ‘Day’
Pressing ‘Timer’ button once again will move the timer to programme 2.
IMPORTANT
This unit should be installed to current IEE wiring regulations if in doubt
consult a qualified electrician.
Note: To review your switching times press ‘Timer’ repeatedly
To exit press
Important Note:
If you set an ‘O time’ which is before the current time, the timer will not
switch O until it reaches that set O time again. (next day)
Example –
If the current time is 10am and you set the programme up for O at 8am
and OFF at 11am, then you will have to wait until the following day for it to
switch on at 8am.
The only way around this is you can use the override switch. The timer will
switch on and turn off at next programmed off time.
Installation
ot suitable for mounting in distribution boards / Consumer units as Timer
requires good ventilation.
Do not mount Timer within 50mm of a contactor as can cause
interference and heating issues.
IMPORTANT
This unit should be installed to current IEE wiring regulations if in doubt
consult a qualified electrician.
Volt Free Contact –
There is no voltage on the relay contacts (between terminals 3 & 4). So
you can switch any system up to 240V, 16A Resistive or 2A inductive.
You need to supply your own signal voltage to terminal 3. The voltage that
is present is whatever you supply.
Please ensure the load requirement across terminal 3 is protected by the
relevant circuit brea er as per latest regulations.
W. www.greenbrook.co.uk
Table of contents
Other Green Brook Timer manuals
Green Brook
Green Brook T106A-C Manual
Green Brook
Green Brook T40S Manual
Green Brook
Green Brook T612-C Installation manual
Green Brook
Green Brook KingShield T102-C User manual
Green Brook
Green Brook T108A-C Manual
Green Brook
Green Brook T105-C Operating instructions
Green Brook
Green Brook T105A-C Installation and user guide
Green Brook
Green Brook KingShield T106A-C Manual
Green Brook
Green Brook T105-C Operating instructions
Green Brook
Green Brook T105A Manual
