Graco HVLP 2500 Manual

www.graco.be

HVLP 2500/3800/4900

Quick Operator’s Guide

SETUP

This procedure is for water-base paints and flushing fluids. For solvent-base paints and flushing

fluids (i.e. mineral spirits), you must read Fire and Explosion Hazard in the Operating Instructions.

* check the Graco operations manual delivered with the unit for more details.

WARNING

Remove cup. Fill 3/4 full. DO NOT

OVERFILL. Reattach and latch cup.

Turn fluid control out until trigger movement is not restricted.

Caution: Turning knob too far will remove it.

Connect air hose to gun and turbine.

CHOOSE THE RIGHT FLUID NOZZLE

For low flow rates or light

viscosity fluid, select smaller

nozzle sizes.

For high flow rates or high

viscosity fluid, select larger

nozzle sizes.

Installing the Fluid Set

Use your hand to loosen and remove the air cap retaining (A) and the air cap

housing (B).

While triggering the gun, use your hand to loosen and remove the nozzle (C)

from the gun.

Use your hand to loosen and remove the fluid knob assembly (D) and com-

pression spring (E) from back of gun and remove the old needle.

Insert the needle assembly (F) into the back of the gun. Replace the nozzle

(E,D) air cap housing (C,B,A) and air cap retaining ring and tighten by hand.

NOTE: O-ring (G) should always be on the nozzle.

Material

Part Number

Orifice Size

Fluid Set #2 Fluid Set #3 Fluid Set #4 Fluid Set #5 Fluid Set #6 Turbine Unit

244123 244124 244125 244126 244127

0.032 0.051 0.071 0.087 0.098

Dye

Ink 2500

Non-Wiping Stain

Automotive Finish

Lacquer

Stain

Enamel 3800

Epoxy

Urethane

Varnish

Primer

Industrial Finishers

Latex

Multi-Spec

Butyrate 4900

Nitrate Dope

Oil Wall Paint

NOTE: read gun manual for paint reduction recommendations.

All manuals and user guides at all-guides.com

SPRAYING

Plug turbine power cord into

a grounded outlet.

GRACO N.V. • Industrieterrein Oude Bunders

Slakweidestraat 31 • B-3630 Maasmechelen

Tel. (32) 89 770 700 • Fax (32) 89 770 777 All information, illustrations, and specifications in this document are based on the latest product information

available at the time of publication. The right is reserved to make changes at any time without notice.

Graco Inc. is registered to I.S. EN ISO 9001.

Open air control valve.

Turn air cap to obtain

desired direction. Lock air cap with retaining ring.

Turn turbine on.

Wait several minutes

prior to spraying to

allow warm-up time.

Nozzle

Air Cap

Air Control

Pattern Selection

Knob

Fluid Knob

Retaining Ring

SHUTDOWN

Turn off turbine. Unlatch cup.

CLEANING

Disassemble gun from cup and clean all parts with water.

Round Pattern

Set knob to RND Vertical or horizontal Pattern

Set knob to FAN

Select spray pattern by adjusting the fluid knob

and pattern selection knob. The air control

adjusts the TOTAL air to the pattern and gun.

Hold gun perpendicular, 6-8 inches

from surface. Move gun first, then

pull gun trigger to spray.

To control over-

spray, reduce

air flow or

reduce fluid

volume.

NOTE: If fluid is

not atomizing

properly, fluid

may need to be thinned further, or

a different tip size may be used.

All manuals and user guides at all-guides.com

Other manuals for HVLP 2500

This manual suits for next models

Other Graco Paint Sprayer manuals

Graco

Graco ST Max 395 Hopper Manual

Graco

Graco 254986 Instruction Manual

Graco

Graco 235-459 Operation manual

Graco

Graco TapeLazer HP Automatic Guide

Graco

Graco ToughTek M680a Use and care manual

Graco

Graco FinishPro 311911C Operating instructions

Graco

Graco Series E Operation manual

Graco

Graco 695 ULTRA MAX lIl Instruction Manual

Graco

Graco Series B Operation manual

Graco

Graco XM Series Use and care manual

Graco

Graco Finex 289256 Operation manual

Graco

Graco 237-426 Operation manual

Graco

Graco Reactor A-25 Instruction Manual

Graco

Graco EM 380 Operation manual

Graco

Graco 288359 User manual

Graco

Graco Delta Spray 7031A Operation manual

Graco

Graco 31-817 Operation manual

Graco

Graco HTX 313888B User manual

Graco

Graco 231-008 A Series User manual

Graco

Graco GMax 308870 Operating instructions

Graco

Graco XP-hf 572407 User manual

Graco

Graco Reactor H-VR Instruction Manual

Graco

Graco 25A187 Use and care manual

Graco

Graco Reactor A-XP Series Use and care manual

Popular Paint Sprayer manuals by other brands

SNOWJOE

SNOWJOE Sunjoe 24V-GS-LTW-RM Operator's manual

Binks

Binks SV100 Service manual

Fimco

Fimco LG-4-3-1 owner's manual

AG SPRAY

AG SPRAY FS-ATV-25BL owner's manual

Nordson

Nordson MicroMax 2 manual

Bonide

Bonide 051 Operation and service instructions

zogics

zogics Z-DAS instruction manual

KISANKRAFT

KISANKRAFT KK-KBS-165 Operation manual

Matrix

Matrix SG 650 Translation of the original instructions

Anest Iwata

Anest Iwata SGA-3 Installation, use & maintenance instruction manual

paasche

paasche VV Instructions and parts list

Carlisle

Carlisle DeVilbiss JGA-510 Service manual

Gardena

Gardena 11120 Operator's manual

Conrad

Conrad Hobby Airbrush K3 operating instructions

wiwa

wiwa 14025 R/F operating manual

DeVilbiss

DeVilbiss LUNA2i Operation manual

WAGNER

WAGNER W 125 manual

My Clean Buddy

My Clean Buddy PW018 user manual