Fujitsu FI-5900C Configuration guide
1
fi-5900C & fi-5950 CONSUMABLE REPLACEMENT AND CLEANING INSTRUCTIONS
fi-5900C & fi-5950 CONSUMABLE
REPLACEMENT AND CLEANING INSTRUCTIONS
CG00002-006201C
fi-5900C & fi-5950 CONSUMABLE REPLACEMENT AND CLEANING INSTRUCTIONS
2
CONSUMABLES LIST
Description Qty Life Fujitsu P/N
Pad 1 600,000 PA03450-K014
Pick Rollers 1 Set 600,000 PA03450-K011
Brake Roller 1 600,000 PA03450-K013
Separation Rollers 1 Set 600,000 PA03450-K012
Note:
To insure the longest possible consumable life, it is strongly
recommended that all the consumables listed above be replaced at
the same time. Not replacing all the consumables at the same time
will decrease the life of the consumables.
NCR or Carbonless paper has chemical composition which damages
the consumables listed above. Cleaning of these items will be
needed more frequently to avoid feed problems. Also their life will be
reduced if this paper is scanned.
Pad Pick Rollers
Brake Roller Separation Rollers
3
fi-5900C & fi-5950 CONSUMABLE REPLACEMENT AND CLEANING INSTRUCTIONS
REPLACING THE PAD
• Make sure there is no paper
in the stacker.
• Press theADF Cover Open
Button.
Note:
The cover opens slowly on it’s
own.
Multiple feeds and misfeeds can be caused by a worn or improperly
installed Pad. The life span of the Pad Assembly is approximately
600,000 pages. If NCR or carbonless paper is used the life span of the
Pad may be decreased by half.
S
endtoScan
P
owerT
h
ic
ic
knes
s
HopperHeig
Hopper Height
F
un
unc
tio
tion
Thick
Thin
• Move the Pad to the left, than pull it up in order to remove it from the
scanner.
Pad
fi-5900C & fi-5950 CONSUMABLE REPLACEMENT AND CLEANING INSTRUCTIONS
4
REPLACING THE PAD (CONT.)
• To install the new Pad, align the pins on the back of the Pad with the
large side of the mounting holes and move the Pad to the right.
Mounting
Holes
Pins
• Close theADF Cover.
• Reset the Pad Counter in the
Software Operation Panel.
5
fi-5900C & fi-5950 CONSUMABLE REPLACEMENT AND CLEANING INSTRUCTIONS
• Make sure there is no paper
in the stacker.
• Press theADF Cover Open
Button.
Note:
The cover opens slowly on it’s
own.
• Open the Roller Cover by
placing your fingers in either
of the openings of the cover
and pulling out.
• Pull out on the tab that locks
the Pick Roller in place in the
direction of the arrow and
slide the Pick Roller off the
shaft.
• Repeat the procedure above
to remove the second Pick
Roller.
REPLACING THE PICK ROLLERS
Worn, defective, or improperly installed Pick Rollers will cause misfeeds
and paper jams. The Pick Rollers have an approximate life of 600,000
pages. If NCR or carbonless paper is used the life span of the Pick
Rollers may be decreased by half.
S
en
endto S
can
can
P
owerT
hic
knes
s
HopperHeig
Hopper Height
F
un
unc
tio
tion
Thick
Thin
Roller Cover
Roller
Cover
Opening
Pick Roller
Tab
fi-5900C & fi-5950 CONSUMABLE REPLACEMENT AND CLEANING INSTRUCTIONS
6
REPLACING THE PICK ROLLERS (CONT.)
• Install the new Pick Rollers
by aligning the hole in the
rollers with the roller shaft.
Note:
The roller shaft and the hole in
the Pick Rollers are keyed and
will only slide on in one
orientation.
• Close the Roller Cover.
• Close theADF Cover.
• Reset the Pick Roller
Counter in the Software
OperationPanel.
7
fi-5900C & fi-5950 CONSUMABLE REPLACEMENT AND CLEANING INSTRUCTIONS
REPLACING THE SEPARATION ROLLERS
Worn or improperly installed Separation Rollers will cause multiple feeds
and paper jams. The Separation Rollers have an approximate life of
600,000 pages. If NCR or carbonless paper is used the life span of the
these rollers may be decreased by half.
• Make sure there is no paper
in the stacker.
• Press theADF Cover Open
Button.
Note:
The cover opens slowly on it’s
own.
• Open the Roller Cover by
placing your fingers in either
of the openings of the cover
and pulling out.
S
en
endto S
can
can
P
owerT
hic
knes
s
HopperHeig
Hopper Height
F
un
unc
tio
tion
Thick
Thin
• Slide the two Separation Rollers outwards in the direction of the
arrows.
Note:
The shafts will automatically lock in place when moved outward.
Roller Cover
Roller
Cover
Opening
Separation Roller
Shaft
fi-5900C & fi-5950 CONSUMABLE REPLACEMENT AND CLEANING INSTRUCTIONS
8
REPLACING THE SEPARATION ROLLERS (CONT.)
• Remove the two Separation
Rollers by sliding them
inwards and off the shafts (in
the direction of the arrow).
• Close the Roller Cover.
Note:
The Separation Rollers will
automatically spring to their
proper position.
• Close theADF Cover.
• Reset the Separator Roller
Counter in the Software
OperationPanel.
• Install the Separation Rollers by sliding them on to each shaft, aligning
the groove on the roller with the screw on the shaft.
Screw
Groove
Separation
Rollers
Roller
Cover
9
fi-5900C & fi-5950 CONSUMABLE REPLACEMENT AND CLEANING INSTRUCTIONS
REPLACING THE BRAKE ROLLER
Aworn or improperly installed Brake Roller will cause multiple feeds and
paper jams. The Brake Roller has an approximate life of 600,000 pages.
If NCR or carbonless paper is used the life span of the Brake Roller may
be decreased by half.
• Make sure there is no paper
in the stacker.
• Press theADF Cover Open
Button.
Note:
The cover opens slowly on it’s
own.
• Open the Pad Cover by
grabbing both sides of the
cover, pressing in and then
pulling out as shown in the
drawing to the right.
• Remove the Brake Roller by
lifting up on the left side first
and then removing the right
side of the shaft from it’s
mounting hole.
S
en
endtoS
can
can
P
owerT
hic
knes
s
HopperHeig
Hopper Height
F
un
unc
tio
tion
Thick
Thin
Pad
Cover
Brake Roller
Pad Cover
fi-5900C & fi-5950 CONSUMABLE REPLACEMENT AND CLEANING INSTRUCTIONS
10
REPLACING THE BRAKE ROLLER (CONT.)
• Install the new Brake Roller
by inserting the right end of
the shaft into the mounting
hole, then place the left end
into the mounting bracket.
• Close the Pad Cover.
• Close theADF Cover.
• Reset the Brake Roller
Counter in the Software
OperationPanel.
Other manuals for FI-5900C
9
This manual suits for next models
1
Table of contents
Other Fujitsu Scanner manuals
Fujitsu
Fujitsu ScanSnap FI-4110EOX2 User manual
Fujitsu
Fujitsu M3093DE Reference guide
Fujitsu
Fujitsu FI-6000NS Manual
Fujitsu
Fujitsu fi-6800 User manual
Fujitsu
Fujitsu fi-7140 User manual
Fujitsu
Fujitsu M4097D - Fb 50PPM SCSI A3 Dupl 100Sht Adf Manual
Fujitsu
Fujitsu fi-7140 User manual
Fujitsu
Fujitsu ScanSnap iX1600 Configuration guide
Fujitsu
Fujitsu 5015C - fi - Sheetfed Scanner Manual
Fujitsu
Fujitsu M3096EX Configuration guide
Fujitsu
Fujitsu M3099EX/EH Installation and operation manual
Fujitsu
Fujitsu ScanSnap fi-5110C User manual
Fujitsu
Fujitsu PA03360-B505 - ScanSnap S500 Manual
Fujitsu
Fujitsu FI-4010CU Manual
Fujitsu
Fujitsu fi-5650C Manual
Fujitsu
Fujitsu 6240 - fi - Document Scanner Manual
Fujitsu
Fujitsu 6000NS - fi - Document Scanner Manual
Fujitsu
Fujitsu S510 - ScanSnap - Document Scanner Manual
Fujitsu
Fujitsu FI-5015C User manual
Fujitsu
Fujitsu M3096NT User manual
