Frontier TH-0503B User manual
x2
B
To position body part on base after Wiring finished
Follow illustration below ( Figure 6/Figure 5/Figure 7/Figure 8/Figure 9 )
Figure 7
Prior to placing body on top
of base part, check position
of socket, must ensure both
male & female parts of
socket are pointed
to each other.
Figure 8
How to Detach thermostat body and base,
upon Wiring or replacing Batteries
Disconnect the front cover by using a screw driver to press a hook on the bottom of the front cover.
(Figure 1/Figure 2/ Figure 3/Figure 4/Figure 5)
Figure 2
Figure 1 Figure 3
Using screw-driver
push hook backward
Lean screw-driver
upward
Holding two side
of body, to take body off
base part
Figure 4 Figure 5
Move frame
off base part
Battery-holder
at back of body
Be sure to position "HOOK"
inside "body part" upon
positioning "body of thermostat
back on top of "base part".
Figure 9
Be sure the
"body
part "is tightly
attached
to base part.
Figure 6
Socket, female part
Socket, male part
Be certain, the frame is
positioned properly in place
before positioning
body on top of the base part.
The frame must be tightly
in touch with the base part.
PROG buttonto change the start hour settin
s the button to change the temperaturPROG
Other Frontier Thermostat manuals
Popular Thermostat manuals by other brands
Saswell
Saswell SAS920XWHB-7-S-RF User manual and warranty card
Aircalo
Aircalo TFP1-ET85P2 operating manual
Honeywell
Honeywell CM721 user manual
Carrier
Carrier DEBONAIR 33CS Installation and operating instructions
Lennox
Lennox iHarmony Zone Thermostat Installation and setup guide
Gemtech
Gemtech GT7000 Operation
