Fluke J 39200 User manual

TOOL REQUIRED:

J 39200 Digital Multimeter or equivalent

The following bench check may be used to simulate operation on a vehicle. Use the

bench check to verify operation of a CS-144 generator that has been repaired.

1. Mount generator in suitable test stand according to test stand manufacturer's

instructions. Test stand must be capable of driving generator at 6,500 RPM.

Generator Bench Check

2. Make connections as shown in Figure above. Be sure carbon pile is turned off.

Ground polarity of generator and battery must be same. Battery must be fully

charged. Use a 30-500 ohm resistor between battery and "L" terminal of

generator.

3. Slowly increase generator speed and observe voltage using J 39200. Important

•The battery must be fully charged when making this test.

•The engine must be run at 2500 RPM and at ambient temperature.

4. If voltage is uncontrolled and increases above 16 volts , repair or replace

generator.

5. If voltage is below 16 volts, increase speed and connect and adjust carbon pile to

obtain maximum amperage output. Maintain voltage above 13 volts.

6. Use ammeter to check amperage. If output is within 15 amps of rated output,

generator is good.

7. If output is not within 15 amps of rated output, repair or replace generator.

Table of contents

Popular Multimeter manuals by other brands

Agilent Technologies

Agilent Technologies 34420A user guide

Hameg

Hameg HM 8012 manual

Mastech

Mastech MY70 Operation manual

Steren

Steren MUL-300 user manual

Somogyi Elektronic

Somogyi Elektronic home SMA 92 instruction manual

Gossen MetraWatt

Gossen MetraWatt METRAmax 6 operating instructions

PeakTech

PeakTech 4000 Procedure of calibration

YOKOGAWA

YOKOGAWA 90050B user manual

Gossen MetraWatt

Gossen MetraWatt METRALINE DMM16 operating instructions

Tempo Communications

Tempo Communications MM200 instruction manual

Elenco Electronics

Elenco Electronics CM-1555 operating instructions

Mastech

Mastech MS8238C user manual

SDAR

SDAR 830A, 830B, 830D, 830C user manual

RS PRO

RS PRO RS-9519BT instruction manual

BGS technic

BGS technic 8890 instruction manual

Amprobe

Amprobe Hexagon 60 user manual

Morris

Morris 57074 user manual

Agilent Technologies

Agilent Technologies 34450A 5 Digit Multimeter user guide