Flash DJ Series User manual
LED MOVING HEAD
19x15W BIG EYE
SERIES: DJ
User Manual
Art No F7100768
(ver.05.23)
EAN 5905358808481
21/35/78/97/112 CH
CONTENTS
INTRODUCTION 3
SAFETY INFORMATION 3
PRODUCT INFORMATION 4
INSTALLATION 4
CONNECTION 6
DMX CHART 8
PHOTOMETRICS 10
WARNING! The Led Moving Head (LMH) has a powerful pan and lt mo-
tor. The torque reacon when the head is panned suddenly can cause the
base to move if the xture is standing unsecured on a surface. Do not apply
power to the LMH unless the baase is securely fastened to a surface or to
rigging hardware.
WARNING! Use 2 clamps to rig the xture. Do not hang the xture from
only one clamp. Lock each clamp with both 1/4-turn fasteners. Fasteners
are locked only when turned a full 900 clockwise.
WARNING! When clamping the xture to a truss or other structure at
any other angle than with the yoke hanging vercally downwards, use two
clamps of half-coupler type. Do not use any type of clamp that does not
completely encircle the structure when fastened.
WARNING! Posion or shade the head so that the front lens will not be
exposed to sunlight or any other strong light source from any angle - even
for a few seconds. See Figure 1. The LMH lens can focused the sun’s rays,
creang a potenal re hazard and causing damage.
IMPORTANT! Do not point strong light output from other xtures at the
LMH, as intense illuminaon can damaged the display.
Figure 1.
2
INTRODUCTION
SAFETY INFORMATION
THANK YOU FOR PURCHASING 19x15W BIG EYE. FOR SAFETY
REASONS AND TO ENSURE THE TROUBLE-FREE OPERATION, CA-
REFULLY READ THE INSTRUCTIONS.
Please keep this User Manual
for future consultaon. If you sell
the xture to another user, be sure
that they also receive this instruc-
on booklet.
Unpack and check carefully the-
re is no transportaon damage be-
fore using the xture.
Before operang, ensure that
the voltage and frequency of po-
wer supply match the power
requirements of the xture.
It’s important to ground the
yellow/green conductor to earth
in order to avoid electric shock.
Disconnect main power before
servicing and maintenance.
Use safety chain when xes this
xture. Don’t handle the xture by
taking its head only, but always by
taking its base.
Maximum ambient temperature
is: 40°C Don’t operate it where the
temperature is higher than this.
In the event of serious ope-
rating problem, stop using the
fixture immediately. Never try
to repair the fixture by your-
self.
Repairs carried out by unskil-
led people can lead to damage
or malfunction. Please contact
the nearest authorized techni-
cal assistance center. Always
use the same type spare parts.
Do not connect the device
to any dimmer pack.
Do not touch any wire during
operation and there might be a
hazard of electric shock.
To prevent or reduce the risk
of electrical shock or fire, do
not expose the fixture to rain
or moisture.
The housing must be repla-
ced if they are visibly damaged.
Do not look directly at the li-
ght spot while the fixture is on.
3
In the latest version of this Head, the colors in the macro channel have been
improved, making them more natural and consistent with the paern. The co-
lors on the dimmers, power and parameters remain the same as in the previous
version (F7100547).
PRODUCT INFORMATION
INSTALATION
Light Source:
19 pcs x 15W 4in1 LEDs
Power consumpon: 300W
Power supply voltage:
110-245V, 50/60Hz AC
PAN range: 540°
TILT range: 270°
Beam angle (min/max): 4°-60°
Color: RGBW
Zoom: Yes
LED outline stripe eect
Operang modes: DMX 512,
Auto-running, Master/Salve,
Sound acve
DMX channel mode
21/35/78/78/97/112
IP Rang: IP65
Housing made: ABS
Integrated fastening hooks
Cooling: Acve
AC IN/OUT: PowerCon
3-Pin XLR DMX Input/Output
Net Weight: 14.4 kg
Weight with packaging:
59 kg (2x MH+Case)
Dimensions:
H(48)xW(40)xD(26) cm
Dim. (case):
H(59)xW(74)xD(46) cm
The unit should be mounted via its screw holes on the bracket. Always
ensure that the unit is rmly xed to avoid vibraon and slipping while
operang. Always ensure that the structure to which you are aaching
the unit is secure and is able to support a weight of 10 mes of the
unit’s weight. Also always use a safety cable that can hold 12 mes of
the weight of the unit when installing the xture. The equipment must
be xed by professionals. And it must be xed at a place where is out of
the touch of people and has no one pass by or under it.
The following item
are included inside the case:
4
❶ - Moving Head (2pcs)
❷ - powerCON cable (2pcs)
❸ - Omega clamp (4pcs)
❹ - User manual (1pc)
❺ - Transport Case
F7100767 [EAN 5905358808474]:
2x Moving Heads 19x15W Big Eye SET ver.05.23 + Case (SET)
AVAILABLE VERSIONS:
The following item
are included inside the box:
5
❶ - Moving Head (1pc)
❷ - powerCON cable (1pc)
❸ - Omega clamp (2pcs)
❹ - User manual (1pc)
❶
❶
❷
❷
❸
❸
❹
❹
❺
User
Manual
User
Manual
F7100768 [EAN 5905358808481]:
1x Moving Head 19x15W Big Eye SET ver.05.23 (carton package)
6
CONNECTION
The device is equipped with the following interfaces:
1. DMX (in/out): XLR 3(5)-pin socket
2. Power (in/out): powerCON socket
The connecon is performed using cable with
XLR-female -> XLR-Male plugs.
1
3
22
SHIELD
SIGNAL (+)
SIGNAL (-)
3
1
FEMALE
XLR
MALE
XLR
1
SHIELD
SIGNAL (+)
SIGNAL (-)
FEMALE
XLR
MALE
XLR
2
3
4
5
1
2
3
45
CAUTION! At the last xture, the
DMX signal has to be terminated
with a terminator. Solder a 120Ω
resistor between signal (-) and si-
gnal (+) into a XLR plug and plug
it in the DMX output of the last
xture.
3-PIN XLR
5-PIN XLR
Diagram of connecon of devices by DMX cable.
IMPORTANT! The maximum number of devices connected
in series via power cable is 6 pcs.
DMX
Controller DMX 512 DMX 512 120
Ω
Using lamp, the change rate of power voltage should be within ±10%,
if the voltage is too high, it will shorten the light’s life; if it’s not enough,
the lamp will be dark. Please restart it aer turning o light for 20 mi-
nutes unl full-cooling. Frequent switching will reduce the life span of
lamps and bulbs; intermient using will improve the life of bulbs and
lamps.
Input Voltage Frequency Total Power
100-245[V] AC 50/60[Hz] 300[W]
Voltage Specycaon.
7
The connecon is performed using power cable with powerCON
TRUE1 connector (included). The device must be operated by qualied
personnel.
CAUTION! In the case of cable damage do not aempt to repair. Repla-
cement or repair can be made only on the manufacturer or by a person
with appropriate permissions
8
DMX CHART
21 CH 35 CH
CHANNEL MODE
1Red
2Red ne
3 Green
4Green ne
5 Blue
6Blue ne
7 White
8White ne
9 Linear CTO
10 Macro colour
11 Strobe
12 Dimmer
13 Dimmer Fine
14 Pan
15 Pan Fine
16 Tilt
17 Tilt Fine
18 Funcon
19 Reset
20 Zoom
21 Zoom Rotaon
CHANNEL MODE
1Red
2Red ne
3 Green
4Green ne
5 Blue
6Blue ne
7 White
8White ne
9 Linear CTO
10 Macro colour
11 Strobe
12 Dimmer
13 Dimmer Fine
14 Pan
15 Pan Fine
16 Tilt
17 Tilt Fine
18 Funcon
19 Reset
20 Zoom
21 Zoom Rotaon
22 Shape Selecon
23 Shape Speed
24 Shape Fade
25 Shape R
26 Shape G
27 Shape B
28 Shape W
29 Shape Dimmer
30 Background Dimmer
31 Shape Transion
32 Shape Oset
33 Foreground Strobe
34 Background Strobe
35 Background Select
9
CHANNEL MODE
1 Red LED 1
2 Green LED 1
3 Blue LED 1
… Red LED …
… Green LED …
… Blue LED …
55 Red LED 19
56 Green LED 19
57 Blue LED 19
CHANNEL MODE
1 Red LED 1
2 Green LED 1
3 Blue LED 1
4 White LED 1
… Red LED …
… Green LED …
… Blue LED …
… White LED …
73 Red LED 19
74 Green LED 19
75 Blue LED 19
76 White LED 19
RGB RGBW
10
PHOTOMETRICS
Distance 1m:
26280,24 lx
6480 K
Ra 75
Measurements under laboratory
condions were made on
a spectrometer GL SPECTIS 1.0
R G B W
RGBW
Table of contents
Other Flash Lighting Equipment manuals
Flash
Flash F7300254 User manual
Flash
Flash F7100327 User manual
Flash
Flash FL-233 BEAM User manual
Flash
Flash F7100532 User manual
Flash
Flash F7100521 User manual
Flash
Flash LED PAR 64 18x12 RGBWA+UV FLAT User manual
Flash
Flash FL-330 BEAM 15R User manual
Flash
Flash Big Eye User manual
Flash
Flash F7100337 User manual
Flash
Flash FL-203 User manual
Flash
Flash F7100250 User manual
Flash
Flash 7X40W BIG EYE PRO User manual
Flash
Flash EVENT Series User manual
Flash
Flash F7300235 User manual
Flash
Flash DERBY LASER RG + LED User manual
Flash
Flash LED PAR 18x10W RGBW 4in1 IP20 User manual
Flash
Flash F7000547 User manual
Flash
Flash F7100335 User manual
Flash
Flash LED NEW EFFECT LIGHT User manual
Flash
Flash FOLLOW SPOT 350W User manual
Popular Lighting Equipment manuals by other brands
Qazqa
Qazqa Suplux SL 3 Black 103062 instruction manual
Commercial Electric
Commercial Electric 54568141 Use and care guide
CREE LIGHTING
CREE LIGHTING 304 Series installation instructions
Goobay
Goobay 49867 user manual
ECOMAN ITALIA
ECOMAN ITALIA LED T8 instruction manual
Alkalite
Alkalite Krypton KT-81 user manual
