Protected by one or more of the following US patents: (D652.133S, 29/341,859, 29/391,310, 13/662,910)
© Exhale Fans, LLC 2018. All rights reserved
Model: EF34 8
Remote Operation (Cont.)
Each remote is pre-programed to motor when packaged at the factory. However, we have added
instructions below on how to program the remote in the event that it may become necessary.
a. Install the two AAA 1.5 Volt Batteries into the remote transmitter by rst removing the battery cover on the
back cover. Insert the batteries as indicated with the positive + end of the battery aligned with the + sign on
the battery holder.
Operating Functions of the Remote:
The Remote Transmitter has Six Operational Buttons and are depicted (See Figure 9a)
∞To turn the fan ON or OFF select the button labeled POWER.
∞To Increase or Decrease fan Speed select SPEED UP or SPEED DOWN button. The illuminated scale at the
top of the remote will indicate the speed selected, 1 through 6.
∞Please note that the lighted scale on top of the remote will indicate the speed that your fan is operating.
∞To change the direction of rotation, Toggle the CW/CCW button for ClockWise direction or
CounterClockWise direction. The lighted scale will scroll when the CW/CCW button is depressed, right to
left for Clockwise, and Left to right for Counter Clockwise. With your Exhale Fan rotational direction is of
personal preference, performance and temperature are not aected.
∞Turning on the LED light is made by pressing the LED LIGHT ON/OFF button.
∞The LED DIMMER button is used to provide a full-scale dimmer function for your LED. Press and Hold
the dimmer button to select the level of illumination that you desire. While holding this button the level
of illumination will increase to 100% and then decrease to 20%, just release the button at the level of
illumination that you desire.
Remote Programming (Syncing the Remote):
∞Turn the power OFF for at least 10 Seconds, if necessary, turn o the Circuit Breaker that routes power to
your fan.
∞Turn Power to the Fan ON
∞Within 60 seconds of turning the power on, press and hold the LED ON/OFF button for 5 seconds. Do not
touch any other button during this process, doing so will cause this process to fail.
∞Once the Synchronization is completed and detected you will hear an audible “BEEP” which indicates a
successful synchronization.
∞After completing the steps all fan functions will be available.
Please note that if a Power Failure occurs you may have select the CW / CCW direction button since it is not
remembered by the fan.
