10
• Donotoperatethehighpressurecleanerifitisnotconnectedtoawatersupply.
• Donotsupplythehighpressurecleanerwithsaltwaterorwatercontainingimpurities.Inthisevent,
run the high pressure cleaner for a few minutes with clean water.
WARNING
•Follow current regulations for connection to the mains water supply in the country where the water cleaner
is installed.
4.3checks and connectIon to the maIns electrIcIty supply
WARNING
•A Skilled Technician must check that the electrical supply complies with the data indicated on the
identication label (7) on the high pressure cleaner. It is especially important that the supply voltage does
not dier more than ±5% from that indicated on the label.
•All connections to mains electricity must be carried out by a Qualied Eletrician according to IEC 364
regulations or the equivalent standard in the country where the high pressure cleaner is to be used. It is
especially important that the current outlet where the high pressure cleaner is connected is provided with
an earth conductor and a suitable fuse (according to the size indicated on the identication label and
in the table of technical specications), and must be protected by a magneto-thermal dierential circuit
breaker, whose sensitivity is not in excess of 30 mA.
•If the power supply cable is too short, an extension cord can be used provided it is not longer than 10
m/32.8 ft, the section of the wires is at least 1,5mm² and the plug and the socket are waterproof. Contact
a Qualied Eletrician so that all these requirements are followed.
The use of unsuitable extension cords can be dangerous.
5 operatIon
WARNING
•The high pressure cleaner must be used with care and attention. It is your responsibility to make sure that
any infrequent users have read these instructions and are acquainted with the operation of the water
cleaner; otherwise do not allow others to use the high pressure cleaner. Water cleaners must not be used
by children or by unauthorised personnel.
•Comply with the safety warnings in the operating and maintenance instructions of any optional
accessoriestobeused.
•Do not use the high pressure cleaner if:
- the power supply cable or other important parts such as the high pressure pipe, the safety devices, the
cleaner gun and the lance are damaged;
- the high pressure cleaner has been tipped over or has been bumped;
- there are obvious leaks of water.
In these circumstances, the water cleaner should be tested by a Skilled Technician.
•It is especially important to pay great attention when the high pressure cleaner is used in areas where there are
moving vehicles as these can crush or damage the power supply cable, the high pressure pipe, the cleaner gun etc.
•During operation, never leave the water cleaner unattended and make sure it is out of children’s reach. Pay
particular attention when using it in kindergartens, nursing homes and old people’s homes, as unsupervised
children, elderly people and disabled people may be present in such places.
•Before using the water cleaner, make sure it is in a dry place and that it is in a at and stable position in
order to avoid accidents and prevent it from falling over.
•Before moving the water cleaner, follow the instructions in the “Switching o” section.
•Before starting the water cleaner, put on clothing which guarantees adequate protection against the
possibility of incorrect manoeuvres of the jet of pressurised water. Do not operate the water cleaner near
people unless they are also wearing protective clothing.
•High-pressure jets of water can be dangerous if they are not used properly. Do not point the jet in the
direction of people, animals, and energized electrical appliances or towards the water cleaner itself.
•Hold the cleaner gun rmly during use: when operating the lever (26), the operator is subjected to the
backlash of the high pressure. The power of this recoil is indicated in the table of technical specications
(recoil is expressed in N, where 1 N = 0.1 kg).
