Elba EH-M9138ST User manual

For The Warranty Terms & Conditions, Please Refer To Warranty Certificate

Owner’s Manual

Please read this manual carefully

before operating your set.

Retain it for future reference.

Record model number and serial

number of the set.

See the label attached on the set and

quote this information to your dealer

when you require service.

DESIGNER HOOD

MODEL: EH-M9138ST(BK)

Please read this instruction carefully. It is advisable to keep this instruction

manual in a safe place for future reference.

SAFETY PRECAUTIONS

1. Keep electrical appliances out of reach from children. Do not let them to operate the

appliances without supervision.

2. To protect against the risk of electrical shock, do not immerse the product, power cord

or plug into water or any other liquid.

3. This product is for household and indoor use only.

4. This product is not intended for use by person (including children) with reduced

physical, sensory or mental capabilities unless they have been given supervision or

instruction concerning use of the appliance by a person responsible for their safety.

5. If the power cord or plug is damaged, it must be replaced by the service centre or a

qualified service technician to avoid hazard.

6. Before installation, check if the mains supply voltage is matched with the voltage

stated on the rating plate of the cooker hood.

7. There must be adequate air ventilation of the room when the cooker hood is used with

the cooking appliances with burning gas or other fuels.

8. Ensure that the installation of exhaust complies with the standard of local building, gas

and electrical authorities.

9. Do not ignite flames in the pans.

10. There is a risk of fire if cleaning is not carried out in accordance with this instruction.

ASSEMBLY INSTRUCTIONS

Please check the following before installation:

•Installation of cooker hood must be carried out by an authorized or qualified technician.

•Remove all packaging materials from the cooker hood. Check and make sure that the

cooker hood is not damaged.

•Please ensure the power supply has switched OFF when installing the cooker hood.

•For optimum air extraction, avoid having too many windows surrounding the cooker

hood which will cause air convection.

•The optimum height for the installation is between 400 to 450mm which is measured

from the bottom of the cooker hood to the top of the hob.

•Make sure the hood is in level after installation to avoid oil spill over from the oil cup.

•Before installing, determine the height between the bottoms of the cooker hood to the

top of the hob. Mark on the wall to suit the bracket locations.

•Drill holes with diameter of Ø10mm. Insert the screw anchors into the holes. Fix the

mounting bracket and tighten the screws.

•Hang the cooker hood on the mounting bracket and make sure the cooker hood is in

level.

•Fix the exhaust ducting on the cooker hood. Install the oil cup on the cooker hood.

•Install the exhaust cover to the height required.

•Pull the upper exhaust cover upwards then install the fixing bracket to fix the exhaust

cover position.

•Drill 2 holes with diameter of Ø8mm. Insert the screw anchors into the holes. Fix the

mounting bracket and tighten the screws.

•Before connecting to the mains supply, ensure that the mains voltage corresponds to

the voltage on the rating plate of the cooker hood.

NOTE: In order to ensure the well ventilation of Cool Breeze function, please

ensure there is at least 30mm gap for ventilation.

INSTALL THE CHARCOAL FILTER

•Disconnect the power supply. Gently push the clip on the grease filter to eject and use

both hands to remove it carefully (Please do not open while the cooker hood is operate

or connecting the power supply).

•On the left side, install the charcoal filter and lock the position by turning anti-clockwise

direction to tighten.

•On the right side, Install the charcoal filter and lock the position by turning clockwise

direction to tighten.

•To remove the charcoal filter, reverse the direction on above direction to loosen.

PRODUCT DESCRIPTIONS

1 Cool Breeze –Press to activate the Cool Breeze function while cooking. The cooling

fan will turn on. Press again to turn off this function.

2 Blue Magic Light –Press to turn on the Blue Magic Light. Press again to turn off.

3 High Speed Control –Press to operate cooker hood in high fan speed. Press and hold

for 4 seconds to activate the heat cleaning function. Press and hold again to

deactivate (please refer to Heat Cleaning Function).

4 Low / Medium Speed Control –Press to operate cooker hood in low fan speed and

press again to operate cooker hood in medium fan speed.

5 Press this button during operation to schedule one minute delay timer to turn off the

cooker hood. Press again to turn off immediately.

6 Gesture Motion Sensor –Wave your hand from left to right to turn on the cooker hood.

The cooker hood will start to operate with high fan speed and LED light will turn on.

Wave your hand from right to left to turn off the cooker hood. The cooker hood will stop

operate and turn off immediately.

NOTE: The ideally gesture motion speed from left to right or right to left shall

within two seconds. The ideally distance of gesture motion from control panel is

from 5 –10CM.

OPERATING INSTRUCTIONS

1 Press the button and press the button to operate the cooker hood in low fan

speed. Press the button again to operate the cooker hood at medium fan speed.

Press the button to operate the cooker hood at high fan speed.

2 When the motor is running in low, medium or high fan speed, press button to

schedule one minute delay timer to turn off the cooker hood. Cooker hood will be

turned off after one minute. Press button again when the cooker hood is in delay off

timer to turn off cooker hood.

3 Press the button to turn on the Blue Magic Light. Press again to turn off. (This

function does not relate to the cooker hood motor).

NOTE: When the cooker hood is operating, do not perform any of the maintenance

or service the cooker hood. Avoid touching the inside of the cooker hood to avoid

hazard.

HEAT CLEANING FUNCTION

1 Press and hold the button for 4 seconds to activate the heat cleaning function.

2 The cooker hood will operate the heat cleaning function for 15 minutes.

3 The indicator light will keep blinking, heat cleaning process will start and run for 14

minutes. After that cooker hood will stop for the heating function and operate for final

cool down.

4 The final cool down process will operate for 1 minute. The cooker hood will be running

in high fan speed for final cool down process and turn off the cooker hood upon

completed.

5 Press and hold the button to deactivate the heat cleaning function or press the

button to deactivate.

NOTE: During the heat cleaning process, only button or ON/OFF button can be

functional.

CLEANING AND MAINTENANCE

•The cooker hood must always be disconnected from the electricity supply before

carrying out any maintenance.

•Clean the cooker hood with damp cloth, hot water and mild detergent. Do not use

chemical, steel, wooden or abrasive cleaners to clean the cooker hood.

•Remove the oil cup in horizontal direction, wash in hot soapy water, dry and fit back

into the cooker hood. Do not use the cooker hood without the oil cup installed.

•Avoid spilling water into the motor and electronic component.

CLEANING THE GREASE FILTER AND OIL CUP

•Disconnect the power supply. Gently push the clip on the grease filter to eject and use

both hands to remove it carefully.

•Remove the oil cup on the motor for cleaning.

•Clean the grease filter with household cleaning detergent to ensure the filters are free

from dirt (clean the filter once every month).

•After cleaning, install back the oil cup to its original position and put the grease filter in

place.

TROUBLESHOOTING

Malfunctions

Possible Root Cause

Checking

Weak Suction

The distance is too far between

the cooker hood and cooking

appliance

Lower down the cooker hood

installation height but within the safety

guideline

Strong convection due to too

much ventilation

Shut off some of the windows or doors

Cooker hood and light

not function

The power supply is not

connected

Check if the plug is well connected

and the power is on

Power cord is damaged

Contact technicians for repair

Motor functions but

light not works

Light bulb is damaged

Contact technicians to replace a new

light bulb

Light works but motor

not function

The bearing may be damaged

Contact technicians for repair

The internal wires or motor

capacitor may be burnout

Vibration on the cooker

hood

The screw is loosen

Tighten the screws

The cooker hood is

noisy

Exhaust pipe surface is distorted

Contact technicians to reinstall the

exhaust pipe

This manual suits for next models

Table of contents

Other Elba Ventilation Hood manuals

Popular Ventilation Hood manuals by other brands

emmeti

emmeti RECUPA MED A-140 Installation and use manual

Nibe

Nibe F135 user manual

Kuppersberg

Kuppersberg INTRO 60 Technical Passport

Zephyr

Zephyr Spruce AK9834BS Use, care and installation guide

Hisense

Hisense MH6INBG manual

Miele

Miele DA 1255 Operating and installation instructions

Broan

Broan 46000 Specification sheet

GE Profile PV977 Owner's Manual & Installation Instructions

FALMEC

FALMEC FFRIA24W5FS Instruction booklet

Whirlpool

Whirlpool RH2600XL-1 SERIES installation instructions

Küppersbusch

Küppersbusch DX ISLA instruction manual

ETNA

ETNA AV360RVS Instructions for use

JUNO

JUNO JDF603E6 installation manual

Miele

Miele DA 6708 D Operating and installation instructions

Tricity Bendix

Tricity Bendix LE 150 Installation & operating instructions

AEG

AEG X68163BV1 user manual

AEG

AEG 125 D operating instructions

Smeg

Smeg KSEV97X instruction manual