EDIFIER TWS1 User manual
www.edier.com
TWS1
Truly Wireless Stereo Earbuds
EN · Product Description and Accessories
There are dierent size of earmus attached in the package, please
select the suitable ones to wear.
USB charging cableEarmus x 3 pairs
Indicator light / microphone
Touch button
Charging case
■ Operational Guide
● Charge the Headphones
During using, if only red light ashes, it indicates headphones are at
low battery level, please use them after fully charged.
Charging: place the headphones into the charging case
Red light lit in a breathing pattern = charging
Red light o = fully charged
Charging time: about 1.5 hours for a full charging
Warning: The rechargeable batteries that provide power for this product
must be disposed properly for recycling. Do not dispose of batteries in
re to prevent an explosion.
If not used for long periods of time, it is recommended to charge the
product with lithium battery at least once per 3 months.
● Charge the Charging Case
If indicator light ashes slowly, its ashing times mean the times that
the headphones can be charged, if the indicator light ashes rapidly, it
means the charging case has a low battery capacity, please charge it in
time; once the battery runs out, the headphones cannot be turned on.
Indicator light steady lit = charging Indicator light o = fully charged
Rated input: 5V 60mA(headphone) 5V 500mA(charging case)
● Power ON/OFF
1. Power on automatically when taken out from the charging case;
2. Power o automatically while placed into the charging case.
● TWS (true wireless stereo) Pairing of the Left and Right
Headphones
The left and right headphones have nished TWS pairing before leaving
the factory. If the wireless connection fails to resume, please follow the
steps below to re-pair:
•With no TWS and Bluetooth connection, double press the touch
buttons to enter TWS pairing state, blue lights ashing rapidly;
•After pairing is done, blue lights of two headphones will ash slowly.
● Bluetooth Connection
1. Two Headphones Mode
•Open the charging case to take two headphones out, press and hold
the touch button of the left headphone to enter pairing state, red
and blue light ashing rapidly;
•Set mobile phone to search for and connect to “EDIFIER TWS1”, after
pairing is successful, blue light will ash slowly.
2. One Headphone Mode
If use one headphone only, please take the left or right headphone
out from the charging case, and refer to the procedures mentioned in
“Two Headphones Mode” to pair it with mobile phone.
■ Functional Operation Instructions
•Clear pairing records: With no TWS and Bluetooth connection,
respectively press and hold the touch button for 8 seconds.
•Disconnect from mobile phone: When the phone is connected, no
music is playing and no phone conversation,
press
and hold the touch
button for 5 seconds.
● Music playback
(same operation for the left and right headphones)
● Call (same operation for the left and right headphones)
Accept a call: single tap
End a call: single tap
Decline a call: press and hold
Skip backward: triple tap
Skip forward: double tap
Pause: single tap
Play: single tap
Red light instead of blue light ashes.
•
The headphones are at low battery level, please recharge the headphones.
Red light is o during charging.
•
Please ensure the headphones are correctly placed into the charging case.
•
When the headphones are not used for long periods of time, the battery
will enter sleep state, it needs to charge about 30 minutes and then
the red light will be lit.
No sound
•Check if the headphones are operating.
•Check if the headphones volume is at an appropriate level.
•Check if the headphones are correctly connected with mobile phone.
•
Check if the headphones are operating within a normal working range.
The call quality of the headphones is not good.
•Check if mobile phone is in an area with strong signal.
•Please ensure the headphones are within eective distance (10m) and
no obstacle between the headphones and mobile phone.
When playing music, cannot control pause/play/previous track/
next track via headphones.
•Please ensure the paired device support AVRCP (Audio/Video
Remote Control Prole) prole.
■ FAQs
During using, please read the following suggestions carefully.
•Keep the product away from humid places to avoid aecting internal
circuit. Do not use the product during intense exercise or with much
sweat to prevent sweat from dropping into the product to make
damage.
•Do not put the product in places exposed to sun or with high
temperature. High temperature will shorten service life of electronic
components, damage battery and deform plastic components.
•Do not put the product in cold places to avoid damaging internal
circuit board.
•Do not dismantle the product. Non-professional personnel may
damage the product.
•Do not drop, strongly vibrate, strike the product with hard object to
avoid damaging internal circuit.
•Do not use drastic chemicals or cleaner to clean the product.
•Do not use sharp objects to scratch product surface to avoid
damaging shell and aecting looking.
If the product cannot operate properly, please send it to your qualied
maintenance agency.
■ Maintenance
EDIFIER International Limited
www.edier.com
2019 Edier International Limited. All rights reserved.
Printed in China
NOTICE:
For the need of technical improvement and system upgrade,
information contained herein may be subject to change from time
to time without prior notice.
Products of EDIFIER will be customized for dierent applications.
Pictures and illustrations shown on this manual may be slightly
dierent from actual product.
Picture for reference only, actual product prevails.
Diérentes tailles d’embout sont disponibles dans l’emballage, veuillez
choisir la plus appropriée.
Oreillettes
antibruit x 3 paires
Câble de
recharge USB
FR · Description du produit et accessoires
Voyant indicateur/microphone
Bouton tactile
Étui-chargeur
■ Instructions d’utilisation
Entrée nominale: 5V 60mA(écouteur) 5V 500mA(étui-chargeur)
● Chargement des écouteurs
Si seul le voyant clignote en rouge pendant l'utilisation, cela veut dire
que le niveau de batterie des écouteurs est faible. Chargez-la
complètement avant de les utiliser.
Charge: placez les écouteurs dans l’étui-chargeur.
Voyant rouge clignotant lentement = en charge
Voyant rouge éteint = complètement chargé
Durée de charge: approximativement 1.5 heure pour pleine charge.
Avertissement: La batterie rechargeable qui alimente ce produit doit être
éliminée de façon appropriée pour le recyclage. Ne pas jeter une batterie
au feu sous risque d'explosion.
Si vous n’utilisez pas un produit pendant longtemps, il est recommandé
de charger la batterie au lithium au moins une fois tous les 3mois.
● Chargement de l'étui-chargeur
Si le témoin lumineux clignote lentement, sa durée de clignotement
représente le nombre de fois que les écouteurs peuvent être chargés.
Si le témoin lumineux clignote rapidement, cela signie que les batteries
de l’étui-chargeur sont faibles, veuillez le charger aussi tôt que possible.
Lorsque la batterie est vide, les écouteurs ne peuvent pas être allumés.
Témoin lumineux allumé en continu = en charge
Témoin lumineux éteint = complètement chargé
Other manuals for TWS1
1
Table of contents
Languages:
Other EDIFIER Headphones manuals
EDIFIER
EDIFIER TO-U2 mini User manual
EDIFIER
EDIFIER TWS NB2 Pro User manual
EDIFIER
EDIFIER P205 User manual
EDIFIER
EDIFIER W360BT User manual
EDIFIER
EDIFIER TWS200 User manual
EDIFIER
EDIFIER TWS5 User manual
EDIFIER
EDIFIER TWS1 User manual
EDIFIER
EDIFIER NeoBuds Pro User manual
EDIFIER
EDIFIER TWS2 User manual
EDIFIER
EDIFIER TWS NBQ EDF201005 User manual
EDIFIER
EDIFIER Xemal X6 User manual
EDIFIER
EDIFIER Xemal X5 User manual
EDIFIER
EDIFIER Xemal X5 Installation guide
EDIFIER
EDIFIER W800BT Plus User manual
EDIFIER
EDIFIER Xemal X3 User manual
EDIFIER
EDIFIER TO-U7 Pro User manual
EDIFIER
EDIFIER W830BT User manual
EDIFIER
EDIFIER Xemal X2 User manual
EDIFIER
EDIFIER TWS5 User manual
EDIFIER
EDIFIER W600BT User manual
